Electromechanical converters dynamic response is the power electronic systems O Higher than OLower than OSame as

Q: explain the working of a single phase fi AC * Va lage Controller

A:

Q: R2 Q1 VCC R1

A:

Q: The cross-sectional of majn poles is equal to Select one: Оа 2прг/60 Ob 2n/60T OC. 2mr/60 O d.…

A: According to the question we have to find the value of the cross-sectional area of the main pole.

Q: Calculate the total inductance:

A:

Q: What is Kirchoff

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: 10 22 62 82 20V 24V

A:

Q: In forward regeneration mode of operation in chopper, one of the following condition happens Load…

A: Forward regeneration mode of the operation in chopper  What will be happened

Q: Determine the DC currents (IB, IC and IE) and dc junction voltages (VBE, VCE and VCB) IB= mA, IC=…

A:

Q: Hydroelectric genarators are

A: The explanation is as follows.

Q: VCC R1

A:

Q: In Class A chopper, if duty cycle is varied from 0 to 1, the output voltage will vary from zero to…

A: In this question, choose the correct option What is output voltage variation if duty cycle carried…

Q: In 3 phase half wave converter the thyristor T1 is reverse biased due to the 'b' phase supply.…

A:

Q: LA MAR 5) M 5) COM³) D I, 34-13 Find In, In, and Iz 12√

A: The given circuit is:

Q: When a direct voltage of 90V is applied to a coil, 15A direct current flows from the source. When…

A: In d.c. analysis, under steady state condition a inductor will behave as SHORT circuit. The detailed…

Q: Vcc Ic 6 mA Rc 330 k Ohm 40uA B=110 1k Ohm 16 V Vce 2. Find the value of Rb

A:

Q: hat will be the approximate value of the DC voltage component of the waveform at the output of block…

A:

Q: For the converter shown below, determine the magnitude of current ripple value, Aa | in mA. V dc Vdc…

A: Given data Vdc=55 VdcD=55%fsw=15 kHzR=2.0 ΩL=1.0 mHea=35 Vdc We have to determine the magnitude of…

Q: SY collester Feedback blas hit work Showh in figure belahcalchlate Are Valke os SRE) the 18 V 560 KR

A:

Q: The following forward converter (for questions 8-12) has the following parameters. Vin=40V,…

A: Given Vin=40 VV0=10 VP0=50 WD=40%=0.4NP=16

Q: t. - 34 7- Sinzt dt t

A: Here I am attaching images so that you can understand each and every step properly

Q: 4. For an operational amplifier, the slew rate limits the O common-mode rejection O frequency…

A: 4) Lower Slew rate change the shape of applied input waveform so it limits the shape is that it is…

Q: What is the minimum detectable temperature change that the A-to-D converter can resolve

A: The minimum detectable temperature change that the A-to-D converter is given by the expression as…

Q: An alternating voltage Vp is applied to the primary coil of a step-up transformer having N turns on…

A:

Q: 5. Identify the appropriate name for each terminal. Terminal #1 Terminal #1: Terminal #2: 6. Sketch…

A:

Q: A load consists of XL=30 Q and Xc=120 Q are connected in parallel across 120 Volt supply. The…

A: Given, A load consists XL and Xc connected in parallel Inductive reactance, XL=j30 Ω Capacitive…

Q: Hw MANY MODES, LOOP, MEH IN THE FIEURE

A:

Q: a. HIGH to LOW edge O b. falling edge O c. trailing edge leedin g od

A: In this question, positive going pulse is given..And asking about rising edge..

Q: the average values of each voltage in Figures below are: 20 V 10 V OV- 16.4v 13.18v 16.36v 6.369v O…

A: We need to find out average value of given waveform

Q: When the input signal is AC voltage source reaches zero at every cycle, this will turn the thyristor…

A:

Q: • Show the voltage waveforms across each half of the secondary winding and across RL. • Find the…

A: In a full wave rectifier average output voltage is defined as, Vavg=2Vmπ Turns ratio and voltage in…

Q: The proper shaping of the load curve or load characteristics cannot be done by relieving the…

A: Load curve is the graphical representation of load in proper time sequence and the time in hours. It…

Q: In forward regeneration mode of operation in chopper, one of the following condition happens Load…

A: In the forward regeneration mode of the operation in chopper,  Which conditions are happened

Q: Fusing factor is the ratio of Current to rated current

A: In this question we will define fusing factor...

Q: In forward regeneration mode of operation in chopper, one of the following condition happens Load…

A: In this we will see forward regeneration mode..

Q: the frequency is high.

A:

Q: Calaulate the eurrent glanng thmgh the 1os rototor. 180V 4 30 17 34 wit D A 12 12 30 10

A:

Q: A load consists of XL=20 Q and Xc=190 Q are connected in parallel across 120 Volt supply. The…

A: reactive power from element = voltage2reactance  here inductor absorbs reactive power whereas…