Effective Stress in Soil Problem 1. The water table in a certain deposit of soil is at a depth of 2m below the ground surface. The soil consists of clay up to depth of 4m from the ground and below which lies sand. The clay soil is saturated even above the water table: Clay strata: ? = 30%,?? = 2.72 Sandy Strata: ? = 26%, ?? = 2.64 1. Compute the total pressure. 2. Compute the pore water pressure. 3. Compute the effective stress pressure at a depth of 8m below the ground surface

Effective Stress in Soil Problem 1. The water table in a certain deposit of soil is at a depth of 2m below the ground surface. The soil consists of clay up to depth of 4m from the ground and below which lies sand. The clay soil is saturated even above the water table: Clay strata: ? = 30%,?? = 2.72 Sandy Strata: ? = 26%, ?? = 2.64 1. Compute the total pressure. 2. Compute the pore water pressure. 3. Compute the effective stress pressure at a depth of 8m below the ground surface

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter9: In Situ Stresses

Section: Chapter Questions

Problem 9.12P

See similar textbooks

Similar questions

A uniform soil deposit has a dry unit weight of 15.6 kN/m³ and a saturated unit weight of 17.2 kN/m³. The groundwater table is at a distance of 4 m below the ground surface. Point A is at a depth of 6 m below the ground surface. If the water table rises by 3.5 m, determine the change in effective stress at A. Indicate if it is maintained, increased or decreased.
The soil profile consists of 5m sand underlain by 13 m layer of clay. The ground water table is at a depth 2.8 m below the surface. The sand has a unit weight of 19 kN per cu. Meter above the ground water table and the saturated unit weight below was 20 kN per cu. meter. The saturated unit weight of the clay is 15.7 kN per cu. meter. At a depth of 11 m determine the following:a. Total stressb. Pore water pressurec. Effective stress.....
Dry Sand H, Groundwater Table Clay Refer to the soil profile shown. Given H1 = 8.85 m., and H2 4.01 m If the ground water table rises by 2.19 meters, determine the change in effective stress (numerical value only, in kPa) at the bottom of the clay layer Properties of dry sand Gs = 2.51, e = 0.65 Properties of clay. Gs = 2.72, e = 0.84. Round off to two decimal places. Activate Windows Go to Settings to activate Windows. < Question 18 of 20 2 A Moving to another question will save this response. ASUS C8O CD 80 5n E R- T Y H]
Dry Sand H, Groundwater Table Clay H2 Refer to the soil profile shown. Given H1 = 9.48 m., and H2 = 4.41 m. If the ground water table rises by 2.94 meters, determine the change in effective stress (numerical value only, in kPa) at the bottom of the clay layer. Properties of dry sand: Gs = 2.58, e = 0.67. Properties of clay: Gs = 2.74, e = 0.87. Round off to two decimal places.
Determine the total vertical stress, pore water pressure, and the effective stress of the soil mass at the Centre of the clay layer and at the Centre of the sand layer for the conditions stated below.
Q: For the soil profile shown in figure. Determine: The effective stress (o') at level (A). Soil 1 k = 0.2 cm/sec Y sat = 19 kN/m³ Soil 2 k = 0.4 cm/sec Y sat = 21 kN/m³ Datum D EL + 2.0 m EL 0.0 m EL - 1.0 m EL - 4.0 m EL - 10.0 m
Determine total stress at end of silt layer
A ground profile consists of 2.0 meters silty sand underlain by 3.0 meters of clay. The ground water table is 3.0 meters below the ground surface. The sand has a unit weight of 14 kN/cu.meter. The clay has a unit weight of 16 kN/cu.meter above the water table and 20 kN/cu.meter below the water table. Determine the total soil stress at the bottom of the clay layer.
stion 17 | Dry Sand H Groundwater Table Clay Refer to the soil profile shown. Given H1 = 8.93 m., and H2 = 5.32 m. If the ground water table rises by 2.01 meters, determine the change in effective stress (numerical value only, in kPa) at the bottom of the clay layer. Properties of dry sand: Gs = 2.56, e = 0.65. Properties of clay: Gs = 2.72, e = 0.87. Round off to two decimal places.
Dry Sand H Groundwater Table Clay H, Refer to the soil profile shown. Given H1 = 9.46 m., and H2 = 4.79 m. If the ground water table rises by 2.58 meters, determine the change in effective stress (numerical value only, in kPa) at the bottom of the clay layer. Properties of dry sand: Gs = 2.57, e = 0.63. Properties of clay: Gs = 2.74, e = 0.88. Round off to two decimal places.
Effective Stresses in Soil
The soil profile was consists of 4 m sand at the top and 5 m clay at the bottom. The specific gravity of sand and clay is 2.65 and 2.67 respectively and the void ratio of sand and and clay is 0.61 and 0.48 respectively. The water table is located at the interface of sand and clay. Determine the following:a. Effective stress at the bottom of sand layer.b. Effective stress at the bottom of soil strata.c. the depth of water table from the ground so that the effective stress at the bottom of clay layer becomes 104 kPa.....