Can you show how to out this calculation in the calculator? Everytime I do it, I get a different answer. EJ+21ogenxo 1321) x-seal.Хhot iequilibKg2 11.6 x 10.42 [I+20t] [pic] = (x)()

Solved Explanation:Step 1: Step 2: Step 3: Step 4:

Answered: E J +21 ogen xo 1321) x-seal. Х hot i…

Science

Chemistry

E J +21 ogen xo 1321) x-seal. Х hot i equilib Kg2 11.6 x 10.42 [I+20t] [pic] = (x)()

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

3.58 4.42 5.48 0.100 0.200 0.300 You wish to determine the value of the constant, 6, and to do so you will construct a linear plot. What will you plot ag what? y-axis label: x-axis label: From the values of x and y in the table above, calculate the values of the three corresponding data points. Click on the graph below, and use th "Freeform Curves" tool to plot the data. Line segments will automatically connect the points. Enter Solution What is the numerical value of the constant, b? Previous b =
when using a buret do your results depend on the initial volume in the buret or does the initial volume have to be exactly 0 ml?
Ti(s)+H2O(l)→Ti(s)+H2O(l)→ Express your answer as a chemical equation. Identify all of the phases in your answer. Enter noreaction if there is no reaction. Cs(s)+H2O(l)→Cs(s)+H2O(l)→ Express your answer as a chemical equation. Identify all of the phases in your answer. Enter noreaction if there is no reaction.
A meniscus is "read" at the bottom of the convex curve and can only be reported to one more significant figure than is labeled on the buret. Draw a meniscus on each of these burets (different volume in each one) and read the meniscus and determine the volume of the difference between the two burets.
5
a) In the simulation, select the solutions indicated below from the dropdown list at the top left corner of the simulation. The beaker will fill up to the 1.00 LL mark with the solution. Arrange the acids in increasing order of acidity. Rank from lowest to highest. To rank items as equivalent, overlap them. Beer,vomit,coffee,milk,battery acid,soda pop. b)In the simulation, select the custom liquid from the dropdown list. The beaker will be filled to the 1.00 LL mark with the solution. Set the pHpH to 8.55 by entering the value in the text box provided above the pHpH scale in the panel called "pHpH." Once you adjust the pHpH, note the corresponding OH−OH− ion concentration in mol L−1mol L−1 as given in the graph on the right side of the simulation. Make sure to click the option "Concentration (mol L−1mol L−1)" under the “Water components” panel. Click on the Logarithmic scale below the graph. Find the pOHpOH of the solution.
Try Again Your answer is incorrect. Row 2: Your answer is wrong. In addition to checking your math, check that you used the right data and DID NOT round any intermediate calculations. • Row 3: Your answer is wrong. In addition to checking your math, check that you used the right data and DID NOT round any intermediate calculations. A student dissolves 13.0 g of ammonium nitrate (NH4NO3) in 300. g of water in a well-insulated open cup. She then observes the temperature of the water fall from 21.0 °C to 16.5 °C over the course of 3.3 minutes. Use this data, and any information you need from the ALEKS Data resource, to answer the questions below about this reaction: NH4NO₂ (s) NH (aq) + NO3(aq) You can make any reasonable assumptions about the physical properties of the solution. Be sure answers you calculate using measured data are rounded to the correct number of significant digits. Note for advanced students: it's possible the student did not do the experiment carefully, and the values…
Help please, the data is in the second picture.
Weigh out accurately 9.99 g of copper(II) sulfate pentahydrate (CuSO4·5H2O) by taring using a clean and dry empty 250-ml beaker. 2. Add tap water to the beaker to reach the 50-mL mark on the side of the beaker. 3. Dissolve all the crystals of CuSO4·5H2O in the water using a clean glass rod for stirring. 4. Then using a glass funnel transfer all the blue solution to a 100-mL volumetric flask. Rinse the beaker with about 10 mL of water and transfer the solution to the volumetric flask. Repeat the rinsing of the beaker with another 10 mL of water and transfer the solution to the volumetric flask. This is called quantitative transfer of the solution. 5. Then add enough water to reach the calibration mark of the volumetric flask. (You will need to use a dropper to add the last few drops of water to ensure the meniscus is on the calibration mark). Close the volumetric flask with a stopper and mix the solution well (so that it is homogeneous). 6. You have now prepared a standard solution (or…
1. (answer the questions in the tan boxes in the tables below each question) A student conducted an investigation to determine the effect of water temperature on the amount of sugar that dissolves in a beaker of water. Identify components for trial 1 of this investigation. Beaker Number 1 2 3 4 Amount of Water (mL) 100 100 100 100 Amount of Water (mL) Trial 1 Temperature of Temperature of Amount of Sugar Sugar (°C) Water (°C) Dissolved (g) 20 20 20 20 Temperature of Sugar 5 10 15 20 185 189 194 204 Temperature of Water Terms Variable Constant Amount of Sugar Dissolved
Part E Write balanced complete ionic equation for NaOH(aq)+ HC,H,O2 (aq)→H,O(1) + NaC, H,O2 (aq). Express your answer as a chemical equation. Identify all of the phases in your answer. ΑΣΦ x" O That's not quite right. Please check your formatting and try again No credit lost. Try again. Submit Previous Answers Request Answer Part F Write balanced net ionic equation for NAOH(aq) | HC,H,O, (aq) H,O(1) i NaC, H,O, (aq). Express your answer as a chemical equation. Identify all of the phases in your answer.
A student prepares a 3.4M aqueous solution of propionic acid (C₂H₂CO₂H). Calculate the fraction of propionic acid that is in the dissociated form in his solution. Express your answer as a percentage. You will probably find some useful data in the ALEKS Data resource. Round your answer to 2 significant digits. % x10 X 5