During the summer, the height of the water in a pool decreases by 4.25 inches each week due to evaporation. What is the change in the height of the water over a six-week period?
Q: A block of wood has specific gravity 0.80. When placed in water, what percent of the volume of the…
A: Introduction Specific gravity of the block of wood is given as s=0.80 Specific gravity of a material…
Q: An iceberg has mass 188,000 tonnes and is composed of pure ice with density 917 kg/m3 and entrained…
A:
Q: Gold can be hammered into decorative gold leaf, which is only 1.00E-07 m thick. If 1.88 troy ounce…
A: We know the density of a material sample, ρ=mV. Where m = mass of the sample and V= volume of the…
Q: The wing of an airplane has an average cross-sectional area of 11 m2 and experiences a lift force of…
A: Given : cross-sectional area (Area)=11 m2 Lift force (Net force )= 72 000 N We have to find…
Q: The volume of an air bubble increases by a factor of 3.19 times as it rises from the bottom of a…
A:
Q: A 10 kg piece of metal displaces 2 L of water when submerged. What is its density in units of ст3
A:
Q: The wing of an airplane has an average cross-sectional area of 13 m2 and experiences a lift force of…
A: Write the given values with suitable variables. A=13 m2F=91000 N Here, A denotes the average…
Q: A rectangular box with an open top is floating on the surface of a swimming pool. During a rainstorm…
A: Since there's no information given about the thickness of the box, we can't really find its buoyant…
Q: In the video, the water level was 15 milliliters before adding the chain, and 20 milliliters after…
A:
Q: A 9.00 m × 15.0 m swimming pool slopes linearly from a 1.20 m depth at one end to a 3.70 m depth at…
A: l=9m b= 15 m h1 = 1.20 m h2 = 3.70 m
Q: A container has a large cylindrical lower part with a long thin cylindrical neck open at the top.…
A: Given Volume of water in lower part = 23.8 kg/m3 area of the bottom of the container = 9.50 m2 The…
Q: Figure (a) below shows a U-shaped tube containing an amount of mercury. The left arm of the tube has…
A:
Q: The end of a garden hose is enclosed in a mesh sphere of radius 4 cm. If the hose delivers five…
A:
Q: building is to be designed to withstand hurricane-force winds. The maximum wind velocity is v=89 ms.…
A:
Q: A container has a large cylindrical lower part with a long thin cylindrical neck open at the top.…
A: P = F/A
Q: Figure (a) below shows a U-shaped tube containing an amount of mercury. The left arm of the tube has…
A: Given : A1=11 cm2=11x10-4 m2 A2=4.90 cm2=4.90x10-4 m2 Mass of water poured=m=0.3 kg Density of…
Q: Some rocks or bricks contain small air pockets in them and have a spongy structure. Assuming the air…
A: Given: diameter = 0.006 mm radius, r = 0.003 mm surface tension, T = 0.085 N/m angle of…
Q: A rectangular block of ice with dimensions 2 m by 2 m by 0.2 m floats on water. A person weighing…
A: Given Volume of Ice is = 0.8m3 Ice density = 920kg/m3 Water density = 1000kg/m3 As per buoyant…
Q: A jet airplane in level flight has a mass of 8.64 104 kg, and the two wings have an estimated total…
A: Apply the Bernoulli’s equation at the top and the bottom side of airplane.
Q: Water flows steadily from an open tank as shown in the figure. (Figure 1)The elevation of point 1 is…
A: The speed of the water flows in the tank is,
Q: The wing of an airplane has an average cross-sectional area of 13 m2 and experiences a lift force of…
A: Given: Average cross sectional area of wing, A = 13 m2 Lift force, F = 97000 N
Q: The draft of a (cuboid) shipping barge (boat) is the amount of the barge that is under water. If a…
A: Given - draft of the barge in freshwater, h = 2.11 m density of freshwater, ρf = 1000 kg/m3…
Q: A reservoir has a surface area of 50.0 km2 and an average depth of 40.0 m. What mass of water is…
A:
Q: An iceberg with a volume of 20,000 m³ is floating in the sea. It is seen that 8% of the iceberg is…
A:
Q: Suppose you spray your sister with water from a garden hose. The water is supplied to the hose at a…
A: Given data: Volume flow rate (Q) = 0.441×10-3 m3/s Diameter (d) = 5.63×10-3 m Required: Speed (v)
Q: m 1. A river is 12.2 m wide with an average depth of 5.1 m. The river is flowing at a speed of 1.7…
A:
Q: A rectangular trough, 2.0 m long, 0.60 m wide, and 0.45 m deep, is completely full of water. One end…
A: Given a rectangular system with, Length of rectangle, l = 2 m Width of rectangle, w = 0.6 m Depth of…
Q: A small artery has a length of 1.10 × 10-3 m and a radius of 2.50 × 10-5 m. If the pressure drop…
A: The rate of flow of fluid through the artery can be found using the Poiseuille's law and it is given…
Q: A tall graduated cylinder contains 7 cm of oil (density of 825 kg/m3kg/m3) on top of 20 cm of water…
A: According to the question,data is given below:-…
Q: 8. An object that can float in both water and in oil (whose den- sity is less than that of water)…
A: (c) the same when it is floating in water or oil
Q: A container has a large cylindrical lower part with a long thin cylindrical neck open at the top.…
A:
During the summer, the height of the water in a pool decreases by 4.25 inches each week due to evaporation. What is the change in the height of the water over a six-week period?
Trending now
This is a popular solution!
Step by step
Solved in 3 steps with 2 images
- The reservoir in Figure contains water and immiscible oil at a temperature of 20 ° C. What is the height h in centimeters if the density of the oil is 898 kg / m3?A block of wood with the dimensions 0.12 by 0.34 by 0.43 cubic meters floats along a river with the broadest face facing down. The wood is submerged to a height of 0.053 meters. What is the mass of the piece of wood?Gold can be hammered into decorative gold leaf, which is only 1.00E-07 m thick. If 1.50 troy ounce of gold is hammered into gold leaf, what is the area that can be covered when used for decoration? 1 troy ounce = 31.1 g, and the density of gold is 19.3 g/cm3.
- A company has several sensors in storage silos to detect the total pressure in the silos to ensure the tanks will not leak. Each tank is designed to withstand a maximum total pressure of 5.7 atmospheres [atm]. An engineer wants to use one of the silos to store liquid nitric acid, which has a density of 97 pound-mass per cubic foot [lbm/ft3]. If the tank is filled to a depth of 90 feet [ft], how much surface pressure in units of atmospheres [atm] can be applied to the top of the liquid inside the tank without exceeding the maximum total pressure of the silo?A wooden raft has dimensions 4.0 m x 2.0 m with height 0.5 m. The density of wood is 0.65 g/cm3. How much of the raft is submerged in water? How many people (average mass 70 kg) could the raft support if it becomes 95% submergedIn the video, the water level was 15 milliliters before adding the chain, and 20 milliliters after adding the chain. When I weighed the chain, its mass was 70.6 grams. I believe the chain is solid metal (not gold plated), but is probably a blend of gold and other metals. I looked up that gold has a density of 19.3 g/ml, while the other metals like silver and copper usually blended with gold have a combined density of about 9.7 g/ml. Determine what percentage of the chain is gold, by mass, to at least 1 decimal place? % ४९
- The density of a composite is 1.7 g/cm3. The density of an unknown fluid is 2.2 g/cm3. An object made of the composite will _____ in the unknown fluid.Water flows at a speed of 2.8 m/s through a 9 cm diameter pipe to a 4.5 cm diameter pipe. What is the speed of the water in the 4.5 cm diameter pipe?2. Kim wanted to conduct an experiment to find out how the exposed surface area of water affects the rate of evaporation. She filled four beakers, A, B, C and D with 150 ml of water each. Then, she placed each of the four beakers of water under different conditions as shown in the table below. Beakers A B C D Exposed surface area of water (cm²) (1) A and B (2) A and C (3) B and C (4) B and D Observe: Highlight the aim of the experiment. What is the variable that is changed? 20 30 30 20 Temperature of water (°C) Speed of wind blowing over water surface (km/h) 20 20 10 20 30 35 30 35 Which two beakers of water should she choose in order to conduct a fair test? Z *Clue: For a fair test, only one variable can be changed. Refer to the aim to find out which variable is changed. ( )
- V6A 1m high water tank has base dimensions of 1m by 1m and top dimensions of 2m x 2m. If the tanks is just full, the pressure force on the base of the tank is O 49.6kPa O9.81kPa O 4.96kPa 98.1kPa O 0.981kPaAssume that a raindrop has a volume of 0.05 cm^3 and you need an Avogadro's number of raindrops to fill up the cubic water tank. What is the length of the edge of the tank?