During the stress test, the wood sample is subjected to an average normal stress of 10 MPa. Determine the axial force P applied to the sample. Also, find the average shear stress developed along section a – a of the sample.

During the stress test, the wood sample is subjected to an average normal stress of 10 MPa. Determine the axial force P applied to the sample. Also, find the average shear stress developed along section a – a of the sample.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In a laboratory test of a beam loaded by end couples, the fiber at layer AB as shown are found to increase 50 x 10 3 mm while those at CD decrease 80 x 103 mm in the 250- mm-gage length. Using E = 170 GPa, determine the flexural stress at the top %3D fiber. Answer must be in MPa. Given: a = 50 mm, b = 110 mm, and c = 80 mm. %3D gage length A a mm B b mm D с mm
During the tension test, the wooden specimen is subjected to an average normal stress of 12.5 MPa. Determine the average shear stress and bearing stress developed on the specimen. 100 mm 50mm 25mm 100 mm 40 mm
Determine the absolute maximum shear stress for each of the following plane stress states for which the principal stresses are given. (a) Op1 = 2610 psi, op2 = -2440 psi, op3 = 0 (b) op1 = 74 MPa, op2 = 46 MPa, op3 = 0 Answer: (a) Tabs max psi %3D (b) Tabs max = MPа
Calculate the stress from a 0.3498 in. diameter tensile specimen yielding at 4.407 kips 46.0 ksi 30.6 ksi 33.4 ksi 45.9 ksi
The piece of wood shown below was used in an experiment. During the test it sheared parallel to the wood grain along the dashed line. Determine the average shear stress on that failure plane for a maximum load of P = 1250 lb. The dimensions of the wooden specimen are t = 2.0 in. and L = 5 in.
Solve both
Urgent please give me right solution
Answer 3,5
In unconfined compression test, the deformation dial gauge is used for stress calculation Ture Fulse
The point loads are placed at the fixed positions shown in the figure and they are live loads. A k a b a b dn = 1₂ Icr= M B 7 Ast Stress profile (concrete) Cross section before cracking Aso Cross section Asc Ast N.A. Q2) Now, the live load increases gradually and the moment at the critical section just exceeds the cracking moment (Mcr), but the compressive section of the concrete is still under the linear elastic region. Please be reminded that in the flexural design, the crack of the concrete section starts where the tensile stress reaches the tensile strength. It is assumed that the cracks then propagate rapidly up to the entire tension section (up to the neutral axis) and this cracked concrete section cannot resist the tension. It should be noted that in reality, concrete sections between the primary cracks can still resist some tensile stresses as shown in the figure, which should be considered in the displacement design. However, in flexure design, we design the critical section…
bb3 please help me this is my last attempt
Two overlapping plates are joined by a 0.75-in diameter pin. If the shear force on the pin is 0.5kips and the thickness of both plates is half of an inch, solve the bearing stress on each plate. O 1132ksi O 1333.333psi O 1333psi O 1131.768ksi l00oo