During an analysis to determine the fractions of solids in 100 ml of a sample, the weights were obtained according to the following table: The amount of Volatile Total Solids, Fixed Suspended Solids and Volatile Dissolved Solids?

Q: Based on the below data from a sieve analysis test, what is the cumulative percent passing 630µm…

A: Cumulative percent passing 630 microne sieve=  = (Cumulative mass retained on smaller size sieve /…

Q: The specific gravities of solids and carrier fluids of a slurry are usually known, but the specific…

A: Specific gravity is defined as the ratio of the density of solids in the slurry and the density of…

Q: The chlorine demand test conducted in a laboratory for raw water samples is tabulated below. Sample…

A:

Q: The results of a multiple-tube fermentation test of a water sample are shown to the right. What is…

A:

Q: EA two-stage distiller system is used to remove TDS from sea water as shown in the figure. The…

A: Given:- two stage distiller To find:- concentration

Q: Question #6: In a water sample, the following elements are detected. Calculate the total hardness,…

A:

Q: The amount of chlorine residual remaining when gases start evolving during disinfection and when…

A: The amount of chlorine residual remaining when gases start evolving during disinfectionand when they…

Q: Please solve all points

A: Approach to solving the questions   1) Answer - non-carbonate hardness in water typically arises…

Q: From the results of a sieve analysis given below compute for the effective size of D10, D30 and D60

A: Results of sieve analysis are given as Sieve number Mass retained (g) 4 0 10 40 20 60 40…

Q: 8. A laboratory provides the following analysis obtained from a 50-ml sample of raw water: Ca - 60…

A:

Q: Problem 8: An analysis of solids test run gave the following results. Determine the concentrations…

A:

Q: i. Breaking point dosage ii. Design dosage to obtain the residual of 0.4mg/l of the available…

A: This question has been taken from environmental engineering

Q: The results of a grain-size analysis is given below. Plot the grain-size distribution curve and…

A: To Determine :- Median size D50 and Plot the grain-size distribution curve.

Q: During construction of the surface layer of asphalt pavement, two samples were taken every day to…

A:

Q: Specific gravity is calculated by the formula: S.G. = density of sample/density of water at a given…

A: Given data:   t [°C]   ρH2O [g/cm3] 4              1   20        0.99820 25        0.99705    It…

Q: The BODs of a domestic wastewater sample is considered to be about 200 mg/l and the DO in it is…

A:

Q: True or False: When comparing two samples of equal mass, the number of particles in each sample is…

A: Answer:- 1. The given statement is true. The number of particles and number of moles are directly…

Fluid Materials

In general terms, anything that flows can be termed as a fluid. In other words, a fluid is any substance that cannot resist shear forces and deforms continuously under the application of external shear forces. Fluid materials differ completely from solid materials such as metals and alloys. For instance, if we consider two infinitesimally small cross-sectional areas of fluid materials and solid materials, and apply shear forces to these elements, both the elements will undergo deformation. Upon releasing the shear force, the element of the solid materials will regain its original orientation, but the element of the fluid materials will keep on deforming continuously under the action of the shear force.