During a football game, a vertebra in one of the player's spines experiences a shear force of 524 N. If we model the vertebra as a cylinder whose height is 0.61 cm and diameter is 3.30 cm, find the shear deformation experienced by the vertebra. Express your answer in micrometers.

Q: Consider steel B is a cylindrical sample with original length 40mm and subjected to 15700N.…

A: Option b is correct.

Q: Calculate the young’s modulus from one of these two graphs?

A:

Q: A rod 6 inches long is loaded until fracture. The plastic strain (the permanent set after elastic…

A:

Q: Using the Magic Formula described in Section 1.4.4, estimate the cornering force of a car tire at a…

A: Given : The slip angle is The applied load is

Q: What is the torque (in ft.lbs.) needed to fracture a bone if: A typical human tibia is 1.5 cm…

A: Given:- Typical human tibia(Di) Inside diameter = 1.5 cm(Do) Outside diameter = 5 cm(J) Polar moment…

Q: One way of quantifying the energy needed to create fracture in a material is with a Charpy test,…

A: Given: The mass of the pendulum, m = 50 kg The radius of gyration, k = 1.75 m the length of…

Q: The general equation that describes the relationship between the stress and the strain for ductile…

A: Correct answer: 3. Hooke's law

Q: What is the change in dimension in the 2 direction in mm?  What is the σ1 component of the stresses…

A: Given data: A 50 mm cube of graphite reinforced material was extended by 0.90 mm in the 1-direction.…

Q: A rod of length 24.7 cm has Young's Modulus of 1.60 ✕ 1010 N/m2. Assume that a force is  applied to…

A:

Q: A 9 cm diameter solid aluminum post is subjected to a horizontal force of V= 7.9 kN and a…

A:

Q: Three rectangular rods experience the same deformation o. Which rod will experience the largest…

A: The normal strain produced in the rods is given by the following expression as, ε = δ / L Where, ε…

Q: A specimen of copper having a rectangular cross section of 15 x 13 mm is pulled with a force of 45…

A: Given Data

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.