dl dt 3. Recall that the voltage across an inductor is given by V₁ = -L In this problem, you will consider a parallel combination of inductors L₁ and L2. The goal is to determine the equivalent inductance of the parallel combination. Writing down the correct answer without explaining the logic/reasoning will not receive any credit. You must clearly present the details of the argument you use to arrive at your final answer. Supplement your solution with words and figures as needed.

dl dt 3. Recall that the voltage across an inductor is given by V₁ = -L In this problem, you will consider a parallel combination of inductors L₁ and L2. The goal is to determine the equivalent inductance of the parallel combination. Writing down the correct answer without explaining the logic/reasoning will not receive any credit. You must clearly present the details of the argument you use to arrive at your final answer. Supplement your solution with words and figures as needed.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Which quantity must be zero?

Q: 7. It is then connected in series with a [ inductor. What is the total energy stored in this…

Q: An inductor has a peak current of 300 μA when the peak voltage at 39 MHz is 2.5 V. You may want to…

Q: c) the rate at which energy is being stored in the capacitor ate = nW

Q: A current flows through an inductor L, as shown. a b Which statement is TRUE if the current is…

A: Due to the current flowing through the inductor, there will be magentic field inside the inductor.…

Q: 7. Assume that a 10.0 µF capacitor, a battery of emf &=12.0 V, and a voltmeter of 10.0 MS impedance…

Q: At t = 0, the current through a 80.0 mH inductor is 54.0 mA and is increasing at the rate of 68.5…

Q: The switch in the figure below is connected to position a for a long time interval. At t = 0, the…

A: as per our guidelines we will solve first three subparts for you. To get remaining subparts solved…

Q: 9. A ring of mean radius r and cross-sectional area A is made of a perfectly conducting wire.…

A: Given: electron density=n charge on electron=e mass of electron =m radius=r Inductance=L Magnetic…

Q: c) What is the value of the maximum current through L? d) At what first time after t=0 will the…

A: In this case, a capacitor is charged with a battery. And then it discharged through an inductor. In…

Q: E The alternating current in an electric inductor is 1 = where E is voltage and Z= R + X₁i is…

A: Given Data: Current equation (I) = EZ.Voltage (E) = 7(cos(30o)+i sin(30o)).Impedance (Z) = R+XL i.R…

Q: Consider the RLC circuit shown in the figu L

A: The resistance, inductor and capacitor are all in series. The current is maximum at resonance. At…

Q: A 4900-pF capacitor is charged to 120 V and then quickly connected to an inductor with 83-mH…

Q: The circuit shown consists of three resistors and two inductors. The resistors have resistances of…

A: Dear student, "Since you have posted a question with multiple sub-parts, we will solve first three…

Q: The circuit shown in the diagram has a switch which is turned on at time t = 0, and it is known that…

A: Given, Q0=2.0 μCC=1.0 nFL=10.0 μH

Q: It has been proposed to use large inductors as energy storage devices. Part A How much electrical…

Q: You want to investigate the voltage, V, induced in a coil due to motion of the magnet. A setup is…

A: Required ; The first step of investigation.

Q: For a classroom demonstration, a professor built an RL circuit similar to the one shown in the…

A: Given Emf of the battery is ξ=6.00 V Inductance of the inductor is L=4.80 mH=4.80×10-3 A Resistance…

Q: I need help finding what the potential difference is from A to u. A is in the upper left Conner of…

A: For finding the voltage between A and u, we will draw the circuit as shown below, The current…

Q: Which of the following statements are true? Choose all that apply. O A changing magnetic field will…

Q: a) Use Kirchhoff's Voltage Law and the given variables to write down two unique equations involving…

Q: Insect “zappers” use a high voltage to electrocute insects. One such device uses an AC voltage of…

A: Insect “zappers” use a high voltage to electrocute insects. One such device uses an AC voltage of…

Q: DC Circuits Problem 1.01. For the following circuit, let VT = e = 24.0 V, R₁ = 120. 2, R₂ = 240. 2,…

Q: The circuit shown in the figure contains a resistor and a solenoid. A battery is connected by…

Q: decide if the given statement is true or false,and give a brief justiﬁcation for your answer.If…

A: Express the relation for the current as: I=PV Here, I is current, P is the electric power and V is…

Q: For the coaxial line filled with two dielectric media as shown in figure below, a) Find the…

A: Given:inner radius of the conductor, adielectric 1, has permittivity, ε1it has a radius of…

Q: Part C Find the current 0.338 s after the circuit is closed. Express your answer in amperes. 17 ΑΣΦ…

Q: a. For the DC circuit is shown in Figure 5, determaine the following: If i,-5A, find v, and iy If v;…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

dI
3. Recall that the voltage across an inductor is given by V₁ = -L In this problem, you will
dt
consider a parallel combination of inductors L₁ and L2. The goal is to determine the equivalent
inductance of the parallel combination. Writing down the correct answer without explaining the
logic/reasoning will not receive any credit. You must clearly present the details of the argument
you use to arrive at your final answer. Supplement your solution with words and figures as needed.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Solution

VIEW

Step 2: Solution

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The current through inductance L is given by I = Io e-t/r. Part A Find an expression for the potential difference AVL across the inductor. Express your answer in terms of some, all, or none of the variables L, T, t, and the constant e. AVL = Submit ΠΕΙ ΑΣΦ Request Answer ?
In the circuit shown in, S₁ has been closed for a long enough time so that the current reads a steady 3.50 A. Suddenly, S₂ is closed and S₁ is opened at the same instant. Part A What is the maximum charge that the capacitor will receive? Express your answer in millicoulombs. VE ΑΣΦ Qmax Submit Part B Request Answer What is the current in the inductor at this time? Express your answer in amperes. || VE ΑΣΦ ? ? A A S₁ C=17 2.0 mH mC 5.0 μF
Need some assistance figuring this one out! Force F pulls upward on link A with magnitude 622N , d1 = 3.3m , d2 = 1.7m , d3 = 2.9m , d4 = 4.2m , h = 6.5m 4. What is Express cable AC as a position vector ? (rACx, rACy, rACz) 5. What is the length of cable AC ( |rAC| ) 6. What is cable AC as a unit vector ? ( uACx, uACy, uACz ) 11.What is the tension on cable AC ( TAC)
The generator of a car idling at 1500 rpm produces 17.3 V . Part A What will the output be at a rotation speed of 2800 rpm , assuming nothing else changes? Express your answer to three significant figures and include the appropriate units.
An inductor has a peak current of 300 μA when the peak voltage at 39 MHz is 2.5 V. You may want to review (Page 914). For help with math skills, you may want to review: Rearrangement of Equations Involving Multiplication and Division 1 Rearrangement of Equations Involving Multiplication and Division 2 ▼ ▼ Part A What is the inductance? Express your answer using two significant figures. VE ΑΣΦ L= 3.4007 10¯5 Submit Previous Answers Request Answer Part B BOY X Incorrect; Try Again; One attempt remaining Submit Previous Answers Request Answer If the voltage is held constant, what is the peak current at 78 MHz ? Express your answer using two significant figures. ΠΨΕ ΑΣΦ 12 1.5 107 ? ? X Incorrect; Try Again; One attempt remaining ΜΗ μA
How can I get the solution to these problems? (Answers are given)
I am doing physics homework and am stuck on this part! Help would be great, thank you!
PLEASE ANSWER ALL QUESTIONS BELOW FOR A THUMBS UP
The answer that I have entered is incorrect.
Determine the equivalent inductance for each of the networks of inductors shown in the figures below. Each inductor has an inductance of 100 mH. е. f.
What is the inductance L of the inductor? Express your answer in terms of R, I_0, I_1, and t1
6. The graph to the right plots the current through a resistor as a function of time given that the resistor is connected to an inductor, and the combination is suddenly disconnected from a battery. What would change if the inductor is exchanged for one with a larger inductance and the process is repeated? a) Shorter decay time b) Longer decay time c) Higher initial current d) Lower initial current none of the above Plot of current in resistor vs time for a resistor which is disconnected from a battery at time 0 0.8 0.4 0.2 0 0.5 Time (microseconds) 1.5