Discussion: 1. Did your experimentali results verify the equivalence between the delta and star connections? (Compare the voltage and the currents in both cases). 2. The sum of the three voltage for Y or A (Vs. Voc. Va) must be equal to zero .Why ? Did your readings of the voltages verify this condition? Prove that. 3. Did the power delivers from (DC power supply) is changed after using the conversion from A to Y. Prove that? 4. When we have three equal resistors for a Y connection prove that (the value of each resistor of the delta is equal to three times the value of any resistor of the Y).

Discussion: 1. Did your experimentali results verify the equivalence between the delta and star connections? (Compare the voltage and the currents in both cases). 2. The sum of the three voltage for Y or A (Vs. Voc. Va) must be equal to zero .Why ? Did your readings of the voltages verify this condition? Prove that. 3. Did the power delivers from (DC power supply) is changed after using the conversion from A to Y. Prove that? 4. When we have three equal resistors for a Y connection prove that (the value of each resistor of the delta is equal to three times the value of any resistor of the Y).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Direction: Read the following problem. Show your complete and detailed solution. 1. Three resistors A, B and C are connected in parallel and take a total of 3.95 Amperes. Resistor A takes 1.25 Amperes and has a resistance of 24 ohms; also the current through B is twice as much as that through C. Calculate the line voltage. a. Given: b. Unknown/Required: c. Formula: d. Solution: e. Final Answer: 2. A 10-ohm resistor is connected in series with another resistor of unknown resistance to a 120-volt source. The voltage measured across the 10-ohm resistor is 48 volts. Find the unknown resistor. a. Given: b. Unknown/Required: c. Formula: d. Solution: e. Final Answer:
2. Convert the following current source into an equivalent voltage source and redraw the circuit. 230a 230a Equivalent Circuit Diagram Va Re
Write less than thirty lines about Power consumption in noc and power saving techinques.
Can we select components voltage references randomly in order to write KVL? Why? In what situation we cannot select both current and voltage references randomly? Why? 7. Why independent KVL and KCL equations used? What happens if dependent equations are used? 8. Analyze the experiment circuits and calculate elements powers and energies. 5. 6.
kindly answer this immediately thankyou somuch for helping -At a rated current of 400 A, a defective switch becomes overheated due to faulty surface contact. A millivoltmeter connected across the switch shows a 100 millivolt drop. What is the power loss due to the contact resistance choices: a.40 W b. 4kW c. 40 MW d. 4MW
An independent current source while providing a fixed current having Select one: a. Unknown voltage across its terminals. b. Not applicable to measure voltage across it. c. Zero voltage across its terminals. d. None of the above.
None
TaqooD fOusul AllaS The DC distributor fed at one end as shown below, the resistance of each conductor per 100m is 0.040 voltage at point B is maintain at 300V, then find The total voltage drop in this distributor (2 Marks) (1) The minimum voltage value in distributor (1 Mark) ion (ii) The total power losses in distributor (2 Marks) C E 150m | 200m 100m 250m 40A 50A 80A 60A 1 A- BI A single phase ring distributor ABCA is fed at point A, the feeding point maintains at 300 /0° V. the load at point B 07/04 a 49 立

With switch SW1 and SW2 both closed, complete the following using the values from the table:i. Determine the total resistance in the circuit. ii. Determine the currents flowing in the circuit. iii. Determine the volt drops around the circuit. iv. Use the appropriate Kirchhoff’s law to confirm your results.
23 - Current coil in wattmeters ……..……. It is made of wire, ............. spiraled.A) thin / lessB) thin / veryC) thick / veryD) thick / lessE) medium / medium
A. Use this graphic for Questions 3, 4, 5, and 6. V,= 36 Volts R1 R2 .023ka .023MQ Vs ŽR3 R5 R4 .23MQ 230