Dilute phosphoric acid(K1 = 7.5 x 10-3) solution is titrated with standard NaOH solution to form NaH,PO4. Which pH indicators below could NOT be used the detect the end-point? 7. 10 Methyl Orange Bromeresol Green Methyl Red Bromthymol Blue Phenolphthalein A. methyl orange and bromocresol green B. bromocresol green and methyl red C. methyl red and bromothymol blue D. bromothymol blue and phenolphthalein

Dilute phosphoric acid(K1 = 7.5 x 10-3) solution is titrated with standard NaOH solution to form NaH,PO4. Which pH indicators below could NOT be used the detect the end-point? 7. 10 Methyl Orange Bromeresol Green Methyl Red Bromthymol Blue Phenolphthalein A. methyl orange and bromocresol green B. bromocresol green and methyl red C. methyl red and bromothymol blue D. bromothymol blue and phenolphthalein

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Why is the pH of mixture D the same as the pH of mixture B? B 0.1 mol L–1 CH3COOH Conductivity (mA) 5 PH 3 D Mixture made by mixing equal volumes of 0.2 mol L–1 HCl and 0.2 mol L–1 NaCH3COO Conductivity (mA) 80 pH 3
Find the pH during a titration of 1.00 ml of 0.600 M analyte when a) 60.00 ml b) 120.00 ml of 0.0100 M titrant has been added then sketch the titration curve. Titrant: HI Analyte: KN3
Calculate the concentrations of the weak acid and conjugate base for the best possible buffer at pH 3.50 knowing that the concentration of the more concentrated species between the two will be 0.2 M. Choose the buffer system you think would be best between the following three. You will need to look up literature values for the Ka/pKa on your own. Remember that a strong buffer has similar concentrations of the buffering components. Formic acid/formate Acetic acid/acetate Hypobromous acid/Hypobromite
Phenol red is a common acid-base indicator. It has a pKa equal to 8.000. It's undissociated form is yellow and its anionic form is violet. What color would a solution containing phenol red solution if the pH is 7.50? yellow yellow-orange red-orange red-violet violet
Reaction: NaHCO3(aq) + HCl(aq) ® NaCl(aq) + CO2(g) + H2O(l) Methyl orange is a pH indicator. It is yellow above pH 4.4, orange between pH 4.4 and 3.2 and red below pH 3.2. NaHCO3 is a weak base and it must be acidified to about pH 4 to completely neutralize it. Why did you test the reaction mixture with this indicator before you began the evaporation step?
ch2
Refer to the following titration curve and answer the following questions. Enter numerical whole value only. PH 12 9 6 3 2 [OH-] eq 3 The number of inflection points: The value of the most basic pKa value:
What is the pH of a solution prepared by mixing 20.0 mL of 0.50 M NaOH and 35.0 mL of 0.50 benzoic acid solution? (Benzoic acid is monoprotic with a Ka of 6.5 x 10-5.)
10 11 12 13 14 15 16 17 18 19 20 A chemist titrates 170.0 mL of a 0.3333 M nitric acid (HNO, solution with 0.1703M NaOH solution at 25 °C. Calculate the pH at equivalence. Round your answer to 2 decimal places. Note for advanced students: you may assume the total volume of the soluțion equals the initial volume plus the volume of NaOH solution added. pH = %3D Submi Continue MacBook Air
A group of students perform a titration experiment. The buret tube is filled to the 0.00ml line with 0.100M NaOH solution. The E. flask contains 50.0ml ov 0.100M HC2H3O2 solution. The Ka of the acetic acid is: Ka = 1.8 x 10-5. A) Write the ionic equation for the conjugate acid reactihng with water. One product is the OH- polyatomic ion. B) What is the pH of the equivalence point?
When titrating 25 mL of an approximately 0.1 M solution of a triprotic acid solution with 0.1052 M NaOH, a student calculates that the end point will be reached after the addition of approximately x mL of NaOH. However, after the addition of 2x mL of sodium hydroxide, no colour change is observed. Which of the following errors could not account for this obervation? using a 3 mole acid : 1 mole base ratio in the calculation washing the sides of the flask with DI water during the titration and diluting the analyte solution mistakenly using a 0.01000 M NaOH solution in the titration failing to add an indicator to the analyte solution mistakenly using a primary standard solution of > 1.0 M in the titration
Say I am titrating 10 mL of H3PO4 with NaOH. It took 5 mL of NaOH to reach the first equivalence point, and the calculated concentration of the weak acid at the first EQ was 0.005 M. If it takes another 5 mL to reach the second equivalence point, what is the weak acid concentration at that point?