Digital MPSK transmissions carried on a 6GHZ terrestrial link require a bandwidth of 24MHz. The transmitter carrier power level is 10W and the hop distance is 40Km. The antennas used each have a 40dB gain and filter, isolator and feeder losses of 4dB. Prove that the received power is equal to -28dBm.

Q: Calculate the frequency difference between the original signal and the recovered signal

A: Given: To generate an SSB Signal, sinusoidal signals are being used with, Carrier frequency, fc=3…

Q: 2 a. Determine the scattering matrix of a lossless circulator (clockwise) that has insertion [5]…

A: A lossless circulator is a passive, non-reciprocal three- or four-port device, in which a microwave…

Q: Problem # 4 Let the carrier be given by cos (106 t) and let the message signal be m(t) = 2 cos…

A:

Q: 8. For an unmodulated carrier amplitude of 16 Vp and a modulation coefficient m = 0.4, determine the…

A: The solution can be achieved as follows.

Q: 6-16 The discrete-spectrum signal of Problem 6-4, having components at 1.2 kHz, 3.6 kHz, and 6 kHz,…

A: If a physical quantity takes only distinct values with gaps between them, it is said to have a…

Q: What is the maximum frequency (in GHz) that a single-line bus with a length of 1 meter can operate…

A:

Q: A microwaye receive receiver has a total input noise power of -108 dBm and an overall noise figure…

A: We need to find out minimum recived carrier power for given FM system .

Q: Which of the following should be selected for the minimum carrier frequency in order to transmit an…

A: For successful reconstruction of the message signal (i.e, for demodulation), the minimum carrier…

Q: a) A block diagram of an indirect (Armstrong) frequency modulation (FM) transmitter is shown in…

A: Step-1-> The block diagram of an indirect Frequency modulating transmitter is -:To determine the…

Q: For a modulation coefficient of m = 0.3 and an unmodulated carrier power of 1500 watts calculate the…

A:

Q: 4. A wireless host is initially located 8m away from the transmitter. The signal power at this…

A: we are authorized to do only one question at a time so i am solving question 4 only Distance of foot…

Q: Consider a downlink communication from base station to mobile user. The carrier frequency is 6 GHz…

A: Given parameters: Carrier frequency: fc = 6 GHz Channel bandwidth: B = 5 MHz Transmit antenna gain:…

Q: An AM transmitter radiates 20kW. The modulation depth is rated at 75% with a channel capacity of…

A: The given characteristics of the given Amplitude modulation are,  Pt=20 kWm=0.75fm=5 kHzfc=0.8…

Q: Q2. In a DSB-SC AM system, the carrier is e(t) = 0.5 cos (20000 nt) and the message signal is given…

A:

Q: For the uplink transmission signal, let's assume a center frequency of 1.8 GHz with a data rate of 5…

A:

Q: 18. Two wattmeters are connected to a balanced three-phase system. Wattmeter R gives a reading of 3…

A:

Q: A 6GHZ direct-broadcast TV satellite system transmits 100W through a 2m diameter parabolic dish…

A:

Q: In microwave communications systems, for a carrier frequency of 6GHz and a distance of 40 km.…

A:

Q: For a citizens band receiver using high-side injection with an RF carrier of 27.04 MHz and a 10.645…

A: An oscillator is a mechanical or electronic device that work on the principle of oscillation:…

Q: What is the relation between carrier frequency of received signal and the intermediate frequency of…

A: The superheterodyne receiver(also called as superhet) is a type of radio receiver which uses a…

Q: How large is the dish diameter (in wavelength and in meters) that is needed for a 80 dB gain at 300…

A: The Gain for a parabolic dish antenna is given by the below Formula: G=10log10KπDλ2Where,G=Gain in…

Q: 4. Compute how many percent of the AM power is consumed by the carrier signal and the two sidebands.

A:

Q: A 1 m long RG-58U type coaxial transmission line to be used at 2 GHz is terminated with a load…

A: We need to find out the input impedance.

Q: Design a wideband FM transmitter to achieve an output carrier frequency of fo=1.7 GHz, and an output…

A: Given:front end of the FM transmitter has,.we need to design:Wideband FM transmitter with Also we…

Q: 9. Any signal can be expressed as the sum of possibly infinite, series of and cosines, square…

A:

Q: A two-disc antenna of 0.75 m diameter is used to form a point-to-point wireless link. Each antenna…

A: Step 1:Given ParametersD = 0.75 mPrq = 10 Wd = 1 kmf = 1800 Mhz D - Diameter of two-disc antennaPrq…

Q: A transmitting antenna, Tx and a receiving antenna, Rx are separated by d=1.25 km. The efficiency…

A: Given : Transmitting antenna and receiving antenna are separated by distance d=1.25 kmEfficiency of…

Q: Q2: What's the effect of phase error A0 and small frequency error Af in the locally generated…

A: Here, the same carrier signal generating SSBSC waves is used to detect the message signal. Hence,…

Q: P(t)=30cos[ 10'nt+6sin(2x10°nt)| If the modulation is FM, determine: 1. Carrier and information…

A:

Q: A 47kF capacitor is subjected to an electric charge of 6 Coulomb. Compute for the plate separation…

A: To find the separation of plates in the parallel plate capacitor

Q: For a carrier of 250W and 90% modulation, what is the power on each sideband and the total power?

A:

Q: In diversity technique, pairs of widely separated antennas are used for transmitting and receiving.

A:

Q: A bandwidth of 20 MHz is to be considered for the transmission of AM signa If the highest audio…

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: Q2: Draw the block diagram of the the difference between it and the envelope detector is?…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: Question 4 Transform the circuit below so that it only contains resistors and voltage sources in…

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.