Answered: 5. Find the minimum bandwidth of a FDM…

5. Find the minimum bandwidth of a FDM system which multiplex five devices, each requiring 4000 Hz. 200 Hz of guard band is needed for each device.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 36VE

See similar textbooks

Related questions

Q: Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During…

A: Given: TDM based circuit switching networks is transmits and receive signals on a single path by…

Q: The differences between Frequency Division Multiplexing (FDM) and Time Division Multiplexing (TDM)…

A: Frequency Division Multiplexing (FDM) and Time Division Multiplexing (TDM) are two widely used…

Q: Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During…

A: Given that, Number of frames per second= 8000 Number of time slots per frame= 32 Number of bits…

Q: T/F. The conversion from parallel to serial data transmission and vice versa takes place inside the…

A: Question. T/F: The conversion from parallel to serial data transmission and vice versa takes place…

Q: Five Channels each with a 100 KHz bandwidth are to be multiplexed together using Frequncy division…

A: Answer is. The minimum bandwidth is 540 Khz.

Q: Ten signals, each requiring 4000 Hz, are multiplexed onto a single channel using FDM. What is the…

A: The answer is

Q: Six channels, each with a 200 kHz bandwidth are to be multiplexed using FDM together. What is the…

A: It is an analog technique that can be applied when the bandwidth of a link (in hertz) is greater…

Q: lex cable runs at T1 data rate cable is 2/3 the speed of light in the cable is

Q: illustrate the various broadband architecture compensation schemes.

A: 1) Broadband architecture compensation schemes are used to address the issue of signal distortion…

Q: What is the number of slots in a frame for TDM if n signal sources with the same data rate are to be…

A: Time-division multiplexing (TDM) is a method of transmitting and receiving independent signals over…

Q: Your company has a video transcoder. Each network interface returns the number of transmitted and…

A: Answer is given below-

Q: -A synchronous TDM with four 2 Mbps data stream inputs and one data stream output. The multiplexing…

A: Here we have given the answer for the first question as per the guideline.

Q: Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During…

A: Given, TDM-based circuit switching with 8000 frames per second 32 time slots per frame During each…

Q: Q3: Four voice signals have the total (BW) is 36 KHz, design FDM to transmit them within equal…

A: The total BW is 36 KHz. Each signal will have BW equal to 36/4= 9KHz.

Q: TDM, FDM, and CDM are physical layer multiplexers. Please list each approach's pros and cons

A: What is multiplexing: Multiplexing is the process of combining multiple signals into a single…

Q: A voice channel occupies a bandwidth of 28 kHz 10 voice channels are to be multiplexed together…

A: FDM is a technique used in telecommunications and signal processing to combine multiple signals into…

Q: Q6: Suppose the carrier waveform illustrate below with assuming a group of 10 information signals xi…

A: ANSWER:-

Q: Consider an OFDM system in which 1000 subcarriers are each to be modulated at 1000 bits per second.…

A: OFDM system in which 1000 subcontractor modulations are per second at 1000 bits. (A) The…

Q: re 8 input signals each requiring a bandwidth of 3 MHz, what is the minimum bandwidth required for…

A: Given 2. In FDM, if there are 8 input signals each requiring a bandwidth of 3 MHz, what is the…

Q: What, in a nutshell, is the WDM operating principle?

A: WDM: WDM doubles optical network communication transmissions utilizing a single fibre optical…

Q: 1. (a) What is Frame Synchronization in TDM technique? Why are guard bands used in FDM and are not…

A: Frame Synchronization in TDM technique: TDM frameworks, it is significant not just that an edge must…

Q: 2. (a) In FDM, time synchronization is not necessary. Yes or No? Give proper reasons behind your…

A: NOTE :- As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: I symbol rate across all subcarriers is 4000 symbols per second. Assume that in the Triers use…

A: the solution is an given below :

Q: In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex…

A: Answer : correct option is 'E'

Q: According to the commuting communication network, FDM should be treated independently from TDM.

A: FDM and TDM, or incidence and time splitting up multiplexing, are type of multiplexing.These are two…

Q: Computer science What advantages does TDM have over FDM in a circuit-switched network?

A: Intro Time Division Multiplexing (TDM): Time-division multiplexing is a procedure of sending and…

Q: Computer science What is the maximum number of slots in a TDM frame if n signal sources with the…

A: Introduction: A method of transmitting and receiving separate signals across a shared signal route…

Q: Given a channel with an intended capacity of 20 Mbps, the bandwidth of the channel is 3 MHz. what…

A: Given data: Bandwidth (B) = 3MHZ Intended capacity of the channel(C) = 20 Mbps

Q: Problem 3 A TDMA system provides 48.6 kbps data rate for a single user over one physical channel…

A: The total data rate provided by the TDMA system is 48.6 kbps for one user. When 3 users are…

Q: Time Division Multiplexing (TDM) is shown to have greater performance when compared to Frequency…

A: A circuit-switched network is a network where a dedicated communication path is established linking…

Q: The distinction between FDM and TDM is explained.

A: Telecommunications use multiplexing methods such as frequency division multiplexing (FDM) and time…

Concept explainers

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.

Question

Find the minimum bandwidth of a FDM system which multiplex five
devices, each requiring 4000 Hz. 200 Hz of guard band is needed for each
device.
5.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

2. In FDM, if there are 8 input signals each requiring a bandwidth of 3 MHz, what is the minimum bandwidth required for the combined signal?
Six channels, each with a 200 kHz bandwidth are to be multiplexed using FDM together. What is the minimum bandwidth requirement for the multiplexed path?
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. What is the bit rate of one circuit in kbps?
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. Assuming it is possible to combine several circuits, how many circuits does it take to keep the transmission time of a 1 Mbyte file below 15 seconds?
2. (a) In FDM, time synchronization is not necessary. Yes or No? Give proper reasons behind your answer. Write one example of TDM where extra information load (overhead) could be 300%.. (b) We need to use Time Division Multiplexing and combine 9 digital sources, each of 900 Kbps. Each output slot carries 9 bit from each digital source, but no extra bit is added to each frame for synchronization. Now, answer the following questions: i) What is the output frame duration? ii) What is the output frame rate? iii) What is the output bit rate? iv) What is the output bit duration? v) What is the size of an output frame in bits? vi) What is the input bit duration?
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. What is the shortest time possible (in seconds) to transmit a 1 Mbyte file over the given link?
20
Computer science What is the maximum number of slots in a TDM frame if n signal sources with the same data rate are to be sent at the same time?
Ten signals, each requiring 4000 Hz, are multiplexed onto a single channel using FDM. What is the minimum bandwidth required for the multiplexed channel? Assume that the guard bands are 400 Hz wide.
The two questions are related
Five Channels each with a 100 KHz bandwidth are to be multiplexed together using Frequncy division multiplexing(FDM) scheme.What is the minimum bandwidth of the link if there is a need for a guard band of 10 Khz between the channel to prevent interference?
The distinction between FDM and TDM is explained.