Answered: Determine the voltage standing wave…

Determine the voltage standing wave ratio VSWR, the reflection coefficient I'and the line return loss if the line impedance Z,=50 and the load impedance Z.= 115 N

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.22MCQ: In a three-phase line, in order to avoid unequal phase inductances due to unbalanced flux linkages,...

See similar textbooks

Related questions

Q: Design base resistor bias circuit for a CE amplifier such that operating point is VCE = 8V and Ic= 2…

A: Note: Here, To design base resistor for CE amplifier only question is considered .

Q: A single degree of freedom system with a mass of 1 kg. C= 10 N.Sec,/m, and K = 25 is an underdamped…

A: Natural vibrations: When a body is free, that means when there is no force acting on the body, even…

Q: 1.7)The armature of a 4-pole de machine rotates at 840 rpm .The armature length and diameter are 40…

A: The answer to the above problem is provided below. Hope it helps.

Q: Find the energy stored in each of the capacitors and the inductors in the circuit shown below, under…

Q: Calculate the branch current IAB and IBC using: a. Mesh Circuit Analysis b. Nodal Circuit Analysis…

Q: The sinusoidal voltage source in the circuit in (Figure 1) is developing a voltage equal to 50 sin…

A: Given, Voltage = 50 sin (400t)V R=500 ohm

Q: Q.1 For the power amplifier of Fig. bellow, calculate: (a) Po(ac). (b) P(dc). (c)n %.

A: As per our policy we can provide solution of first three questions only Vcc=40 VRL=8 ΩVin=18…

Q: Ex:- a- find the general from of the equation for the stream lines of the field E = 10 xy āx +5x2ay…

A: GivenE¯=10xya¯x+5x2a¯y

Q: The diodes in the circuit shown have VK = 0.7V The value of Vs(t) that turns both diodes on is 1k ww…

Q: 1) Determine the complex exponential Fourier transform for the following periodic signal shown. i)…

A: Both the question are independent so as per our company guidelines we are supposed to answer only…

Q: Find the inverse Laplace transform of: 2s+26 V(s) = 5(s² +48 +13)

A: The Laplace transform is a mathematical technique used to analyze linear time-invariant (LTI)…

Q: D sketch the siynel: s(t) = suGt)+u (t) - Rad tes out put io(t) usiny Laploce treusA %3D 4H - imitid…

Q: (b) A positively charged particle enters a region with a uniform magnetic field B = B, k. The…

A: The solution is given below

Q: In Faraday's experiment: 1_ What happens if the source voltage is DC? And why? — 2_ What is…

A: Faraday's law A fundamental property of electromagnetism known as Faraday's law of induction…

Q: person represented as in Fig. 01. Position of the book is given as the reference. Feedback signal…

Q: 13) You plan to use lateral spacing of 5 feet and emitter spacing (on the laterals) of 2 feet. If…

Q: In the given circuit below; a. Draw the Thevenin's Equivalent Circuit and calculate current Is b.…

Q: Q.2: The network shown in the following Figure, uses neurons with tansigmoid activation function…

Q: Find the desired values in the circuit below. Do not forget to use its units while calculating. R1=?…

Q: 12 Use nodal analysis on the circuit of Fig. 10.23 to fi 50/-90° mA V1 -j25 mS lll 0° mA j50 mS 40…

Q: Q1/ A narrowband FM signal has a carrier frequency of 90 kHz and a deviation ratio of 0.05. The…

A: Narrowband FM signals are commonly utilised in walkie-talkies and other low-cost two-way radio…

Q: For the circuit shown, find the operating point assume ß = 45 Rc1.2 k2 Ic Cc Cin V BE. 100 kn Rg…

Q: Q3/ Consider a satellite receiver as shown in the figure below, if the operating frequency is 4GHz…

A: The given figure is shown below: It is given that: Fin=0.69 dBFrf=1 dBFin=4.48 dBFif=7.9 dBTo=290 K

Q: Determine the gate output shown in figure (b) for the input waveforms in figure (a) and draw the…

Q: R1 R2 I4 R3 커50 Ix 13 R4 VIS200 20 € 20 Il R5. 10 20 V V2 V= SLx

Q: Calculate the total charge internal the volume 0<ps2,0 <¢ <T/2 and 0 <z<3 if the charge density is…

A: 3. It is given that: 0≤ρ≤20≤φ≤π20≤z≤3charge density=ρ=4xyz

Q: 5- For a static system, the output does not depend on the values of input. B-(Answer 6 only)…

Q: The n-channel JFET transistor in the amplifier shown has IDSS = 10mA and Vp = - 4V Complete the…

Q: Q3/Analysis the following memory circuit: AIS +5 V 02 Al4 All AS A13 A10 A7 A12 A9 06 A6 MEMW MEMR…

A: A decoder is a combination of the logic circuit which is used to change the code of the given input…

Q: Given a system with Transfer Function G(s) = (+1)(+5) F The system settling time in seconds is…

Q: A PV system has a lifetime of 17 years and a capital cost of $2200. It is designed to supply 1550…

A: duration =n =17 years inflation rate = 5% Discount rate = 7 % Note: 1550 kWh energy duration is…

Q: In hybrid parameters of a CB BJT circuit, hf is equivalent to O a. DC Beta O b. AC Alpha O c. AC…

Q: find value of Rafrom circuit below 13A ww 50 18 v RA

Q: Determine i o (t) in the network shown in the following figure using Laplace Transform. 10 42 ww 5 +…

Q: Inside the sphere r ≤ 4 m, the electric flux density is given as 5r³a, C/m². (a) What is the volume…

A: The above problem is based on Gauss's law in spherical coordinates. All the formulae used are…

Q: The problem are DC analysis problems. For each of the circuits verify the mode of operation and…

Q: A lossless TL with if the voltage a cross a load connected to lossless TL is 20 Vyms and reflection…

A: This question has multiple sub- parts,we will solve the first 2 sub-parts. If you want the solution…

Q: A 4-pole, 50 Hz, 3-phase induction motor has blocked rotor reactance per phase which is four times…

A: Types of induction motor Squirrel cage Induction motor Slip ring induction motor

Question

I need the answer in 20 minutes please.

Determine the voltage standing wave ratio VSWR, the reflection
coefficient I'and the line return loss if the line impedance Z,=502 and the
load impedance Z= 115 Q

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'
I need the answer as soon as possible
answer it i will rate
Don't copy
4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLY
5/The phase angle between magnetizing component current and core loss component current is 180o Select one: True False
Discuss the desirable properties of insulators. Explain the causes of insulator failure due to electrical breakdown. Each line of a three-phase system is suspended by a string of three identical insulators of self-capacitance C farad. The shunt capacitance of connecting metal work of each insulator to earth is 20.7 % of C while for line it is 13.8 % of C. Calculate the string efficiency of the system if a guard ring increases the capacitance to the line of metal work of the lowest insulator to 0.25 C.
Derive the equation of Capacitance per phase for the 3-phase double circuit line with hexagonal spacing. (transposition of conductors is not required)
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the ratio of C1/C=0.1 (Shunt capacitance per self-capacitance) is given. If the string is connected to line of voltage 33kV. a) What is the voltage distribution over the unit of string and what is the string efficiency? b) When the string is supplied by a Guard Ring and this lead to add a two air capacitance of value 0.2C, 0.1C respectively to the nearest to the conductor. Find the new voltage distribution and the new efficiency.