Determine the value of Kc for the following reaction if the equilibrium concentrations are as follows: [N2]eq = 1.5 M, [H2]eq = 1.1 M, [NH3]eq = 0.47 M. N2(g) +3 H2(g) 2 NH3(g) This does not require a RICE table. ○ 3.5 ○ 9.0 O 0.28 0.11

Determine the value of Kc for the following reaction if the equilibrium concentrations are as follows: [N2]eq = 1.5 M, [H2]eq = 1.1 M, [NH3]eq = 0.47 M. N2(g) +3 H2(g) 2 NH3(g) This does not require a RICE table. ○ 3.5 ○ 9.0 O 0.28 0.11

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter5: Introduction To Chemical Equilibrium

Section: Chapter Questions

Problem 5.31E

See similar textbooks

Similar questions

Consider the system 4 NH3(g) + 3 O2(g) ⇌ 2 N2(g) + 6 H20(ℓ) ΔrH° = −1530.4 kJ/mol How will the amount of ammonia at equilibrium be affected by removing O2(g) without changing the total gas volume? adding N2(g) without changing the total gas volume? adding water without changing the total gas volume? expanding the container? increasing the temperature? Which of these changes (i to v) increases the value of K? Which decreases it?
Write the equilibrium constant expression for each of the following reactions in terms of concentrations. (a) CO2(g) + C(s) 2 CO(g) (b) [Cu(NH3)4)2+(aq) Cu2+(aq) + 4 NH3(aq) (c) CH3CO2H(aq) + H2O() CH3CO2(aq) + H3O+(aq)
Based on the diagrams, chemical reaction, and reaction conditions depicted in Problem 9-83, which of the diagrams represents the equilibrium mixture if the numerical value of the equilibrium constant is 9.0?
For the reactionH2(g)+I2(g)2HI(g), consider two possibilities: (a) you mix 0.5 mole of each reactant. allow the system to come to equilibrium, and then add another mole of H2 and allow the system to reach equilibrium again. or (b) you mix 1.5 moles of H2 and 0.5 mole of I2 and allow the system to reach equilibrium. Will the final equilibrium mixture be different for the two procedures? Explain.
. Explain what it means that a reaction has reached a state of chemical equilibrium. Explain why equilibrium is a dynamic state: Does a reaction really “stop” when the system reaches a state of equilibrium? Explain why, once a chemical system has reached equilibrium, the concentrations of all reactants remain constant with time. Why does this constancy of concentration not contradict our picture of equilibrium as being dynamic? What happens to the rates of the forward and reverse reactions as a system proceeds to equilibrium from a starting point where only reactants are present?
The value of the equilibrium constant, K, is dependent on which of the following? (There may be more than one answer.) a. the initial concentrations of the reactants b. the initial concentrations of the products c. the temperature of the system d. the nature of the reactants and products Explain.
Suppose a reaction has the equilibrium constant K = 1.3 108. What does the magnitude of this constant tell you about the relative concentrations of products and reactants that will be present once equilibrium is reached? Is this reaction likely to be a good source of the products?
Calculate the value of the equilibrium constant for the reaction N2(g)+2O2(g)2NO2(g) if the concentrations of the species at equilibrium are [N2] = 0.0013, [O2] = 0.0024, and [NO2] = 0.00065.
Consider the reaction Fe3+(aq)+SCN(aq)FeSCN2+(aq) How will the equilibrium position shift if a. water is added, doubling the volume? b. AgNO3(aq) is added? (AgSCN is insoluble.) c. NaOH(aq) is added? [Fe(OH)3 is insoluble.] d. Fe(NO3)3(aq) is added?
Because calcium carbonate is a sink for CO32- in a lake, the student in Exercise 12.39 decides to go a step further and examine the equilibrium between carbonate ion and CaCOj. The reaction is Ca2+(aq) + COj2_(aq) ** CaCO,(s) The equilibrium constant for this reaction is 2.1 X 10*. If the initial calcium ion concentration is 0.02 AI and the carbonate concentration is 0.03 AI, what are the equilibrium concentrations of the ions? A student is simulating the carbonic acid—hydrogen carbonate equilibrium in a lake: H2COj(aq) H+(aq) + HCO}‘(aq) K = 4.4 X 10"7 She starts with 0.1000 AI carbonic acid. What are the concentrations of all species at equilibrium?
Consider the system 4NH3(g)+3O2(g)2N2(g)+6H2O(l)H=1530.4kJ (a) How will the concentration of ammonia at equilibrium be affected by (1) removing O2(g)? (2) adding N2(g)? (3) adding water? (4) expanding the container? (5) increasing the temperature? (b) Which of the above factors will increase the value of K? Which will decrease it?
The experiment in Exercise 12.33 was redesigned so that the reaction started with 0.15 mol each of N2 and O2 being injected into a 1.0-L container at 2500 K. The equilibrium constant at 2500 K is 3.6 X 10“’. What was the composition of the reaction mixture after equilibrium was attained? The following reaction establishes equilibrium at 2000 K: N2(g) + O2(g) *2 2 NO K = 4.1 X IO-4 If the reaction began with 0.100 mol L-1 of N2 and 0.100 mol L-’ ofO2, what were the equilibrium concentrations of all species?