Determine the unknown distance in the loaded cable.1.5 m1 m1.5 mAC0.5 m5 kN10 kN2.5 mO 3.5 mO 2.25 mO 3 m3.25 mO 2.75 m

Answered: Image /qna-images/answer/0f249697-7e74-4724-b105-8834a4ca6e55.jpg

Answered: Determine the unknown distance in the…

Engineering

Civil Engineering

Determine the unknown distance in the loaded cable. 1 m 米 1.5 m 1.5 m A 0.5 m 5 kN 10 kN O 2.5 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: ■. Determine the resultant internal loadings on the cross section al point D.

Q: AB and CD 1. Determine the forces op segmentof the cable shown. Det ar mine also the value oF P. 4m…

Q: H 40-x U 6m B 16 KN 11m B -100 m- 10 m 10 m 40 kg/m 40 m x 7m 35° 20 KN B D 6m 10 kN/m 2m E 1m

Q: 5-27. The power transmission cable weighs 150 N/m. If h = 2.5 m, determine the resultant horizontal…

Q: 13 A weight is supported on a beam as shown. Determine the tension in the cable T. bod W (A) 990 KN…

A: In this question we will take tension T in cable as force at the end where cable is attacked to…

Q: Determine the stress in Cable E for the beam arrangement shown. The diameter of Cable E is 20 mm.…

A: Determine the stress in Cable E for the beam arrangement shown.

Q: 1.) The cable shown carries a triangularly distributed load. Find the tension of cable at the…

A: Due to symmetry of loading and boundary conditions about Vertical line passing through mid of span…

Q: : Sketch the complete and correct free-body diagram of each of the given structure and determine the…

A: Given figures are Homogenous bar with weight 45N Bar with load L Cylinder of mass 30Kg

Q: 2 m 2 m B 3 kN 8 kN tism -2 m 2 m -1.5 m- A cable supports a concentrated load as shown above. As an…

A: Given Concentrated loads of 3 KN and 8 KN acts at B and C respectively.

Q: B 8 ft 500 lb/ft 15 ft 15 ft

A: This question is from structural analysis in this question of cable is given with uniform loading…

Q: 3- The tensile force on the AB cable is 3 kN. Find the moment of the cable force acting on point A…

A: The Unit vector is given by Mo ; Mo = rOA × F Where ; rOA = 1.6i + 2k F = FAB AB|AB| =3 0.8i + 1.5…

Q: The cable AB carries a tension of 290 N. Determine the moment about O (positive if counterclockwise,…

Q: A 125 m cable weighing 2 kg.s per m is suspended between two towers at the same level. The sag is…

A: In the cable suspension bridge the cable play a critical role to transfer the load. Since, cable…

Q: 8. Determine the load P that should be so that cable BC hung stay horizontal. 3m VA А 5.821m 4m 4KN…

Q: (LO2-4) If b = 1 (i.e. the anchor side of the cable is at a 45° angle), what should be the slope a…

A: Please refer the attached image for complete solution. THANK YOU.

Q: For the cable shown, determine the vertical reaction at B (N). 12 m 12 m | 12 m 12 m Inc hp=8m hE…

Q: 6 m B 1. Determine the mass of the heaviest cylinder that can be supported without exceeding a…

Q: Situation 1: Knowing that dc = 3 m, determine the following:

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: The system shown is initially at rest. Neglecting axle friction and the masses of the pulleys,…

A: Applying newtons second law for 60kg∑ Fy=maT-60(9.81)=60(a)T-588.6=60a.........(1)

Q: 2. For the cable shown, determine P, and yp. E 0.4 m 0.8 m 1.4 m B 6 kN 6 kN P 2 m -1.5 m- 1.2 m 1.2…

A: Sum of the moment at the point E - ∑ME = 0⇒6×1.2 + P1×2.7 + 6×4.7 - RA×6.9 - HA×.4 = 0⇒RA6.9 + HA.4…

Q: The uniform 62-kg pole of 150-mm diameter is hinged at A, and its lower end is immersed in fresh…

A: Uniform 62 kg pole of 150 mm diameter we have to find the tension T in the vertical cable required…

Q: Tension in cable A in Newtons?

A: Since joint 1 is at equilibrium, so we can balance force in x direction and y direction. Or we can…

Q: A' 3.214 гот B SOKN fom с lom 4 Tooky D you

Q: The boom shown has negligible weight, but has sufficient strength to support the 1000 kN load. Find…

A: The following figure shows the Free Body Diagram of the point B.

Q: 3. Determine the coefficient of friction between the uniform 200N spool and the wall so that the…

Q: Determine the resultant force, together with its angle, of the system shown. -note:The tension…

Q: Q.5 A cable stretched between two supports 50 m apart with one end above the other by 5 m. The left…

Q: tank of water sits on a cart and discharges from a 10 mm diameter nozzle. Find the tension in the…

Q: Problem #4: No nu Us 10+B (ft) | 24 n se ibonun The street-lights at A and B are suspended from the…

A: 9. Determine the tension in cable BC. (lb) 10. Determine the tension in cable AB. (lb) 11. Determine…

Q: Compute the maximum loading (kN) in the cable.

Q: h B 3 kN -2 m- D c 8 kN -2 m-1.5 m- 2 m 2m

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

Concept explainers

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.

Question

Determine the unknown distance in the loaded cable.
1.5 m
1 m
1.5 m
A
C
0.5 m
5 kN
10 kN
2.5 m
O 3.5 m
O 2.25 m
O 3 m
3.25 m
O 2.75 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

B S A 700mm T 1200mm Block A is suspended from two cables. Knowing that the tension in AC is 200 N, and the tension in AB is 500 N, determine a) the angle of cable AB with the horizontal, and b) the mass of block A.
Determine the tension in cable BE .and the reactions at A and D 1.25m 10.75m 1.75m cable Smooth surface B 80 kN Smooth surface
3) Cable ABCD supports the 10-kg lamp E and the 15-kg lamp F. Determine the maximum tension in the cable and the sag ys of point B. A Ув B book E 1m+ 3 m 2 m C D 0.5 m
Determine the unknown distance in the loaded cable. 1.5 m 1 m 米 1.5 m y C. 0.5 m 5 kN 10 kN
Determine the force in cable BD when the spring is held in the position shown for equilibrium. The spring has an unstretched length of 0.15 m. 0.4 m k= 600N/m A 0.3 m 0.5 m 0.9 m
Determine the tension in cables BA and BC necessary to support the 60-kg cylinder shown. 45° Y B D (a)
Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable CD is required for static equilibrium in the position shown? What is the tension Tin cable CD? T 41° 1.7' Answers: LCD- i TCD= i B 49 lb ft lb
Determine the tension in cable BE .and the reactions at A and D 1.25m 10.75m 1.75m cable Smooth surface B 80 kN Smooth surface 2m
Determinoe the masximum tension in th ecable shown
For the cable shown,a. Determine the vertical distances Yc, Ye, Yf, and Yg, b. Determine the reaction at left support, andc. Determine the reaction at right support.