Determine the total deformation of the steel rod shown in figure (1) under the given loads. Take the modulus of elasticity E= 200 MPa. Use the last three digits of your ID for the missing force P KN. ww314

Q: i. Draw the Free Body Diagrams for pin C, Block A, and Block B. ii. Applied force P on pin C is…

A: Either block moves when the friction can't overcome the horizontal pull

Q: The resultant loading force is 2.5 kN/m 3 m KN. 0.5 kN/m B 1 m 1.5 kN

A: The resultant loading force: R = 6 kN

Q: With the the following modifications: Change the 30 degree angle of the 4 kN force to 15 degrees

A: Consider a free body diagram below:First diagram is the components of force in horizontal and…

Q: the ability of fluid to resist shear stresses is known as bulk modulus Select one: O True O False

A:

Q: Which of the following statement is/are correct? (please select MORE THAN one answer) Radius of a…

A: Given:

Q: 20 ksi 40 ksi 60 ksi The differential element above represents the state of plane stress at a point…

A: As per given question Which of the following best represents the orientation of the maximum in-plane…

Q: Figure 0.75 m X 0.75 m 2.5 m 3 m FB 12.5 m 0.75 m 10 3 m Z 30 kN 90 kN FA | 20 kN 1 of 1 If FA = 30…

A: Given data is

Q: Suppose we are considering a ductile material under a static load. For the same geometry, same…

A: The given problem is based on theory of failures:

Q: For the problem shown, determine the magnitude of the force in member EF given that x = 2.3 m, y =…

A:

Q: Assuming the stress state in a rotating gas turbine is axisymmetric, how many stress and/or…

A: For completely determine the stress we need two boundary conditions for complete explanation. We…

Q: 3rd option is correct. Please show the work within 20minutes includes Free body diagram. [Solution…

A: Force F=60 lb and force P=40 lbAngle made by the force F from the horizontal is 45 degreeAnd the…

Q: Tensile and Compressive forces are indirect forces Select one: O True O False

A: There are two types of forces: 1.direct forces 2.indirect forces

Q: If the magnitude of the resultant force acting on the bracket shown in the figure below is to be…

A: (15) Draw the free-body diagram of the bracket,     Apply force equilibrium in a horizontal…

Strain energy

The term strain indicates the variation in an object's length, area, and volume when the object is subjected to an external force. The external force may be of normal, shear, moment, torque, etc. The strain in an object depends on the types of external force and cross-section of the object. Mathematically, the evaluation of strain can be obtained with the help of elastic constants.