Determine the reactions at the supports A and B. EI is constant. -2 m- 60 kN 2 m- Į 4 m- 50 kN/m

Q: Determine the reactions at the fixed support A and the roller B. EI is constant.

A:

Q: A beam supports a distributed load as shown. Determine the reactions at the supports. 200 lb/ft 6…

A: This is the very basic question of strength of material portion. Topic:-Reaction calculation of…

Q: Determine the reactions at the supports A and B. EI is constant.

A: Given data: The uniformly varying load on the beam is w0. The length of the beam is L.   The free…

Q: From the given beam: Determine the vertical reaction at the roller support. 5000 lb 4000 lb 1000…

A:

Q: Solve for all reactions at A and B

A: The free-body diagram of the given truss system can be drawn as below, Here, RB is the normal…

Q: Q1. Determine the reactions at A, B its of fig. * 70 - 150 lb 50 - 200 lb 30

A:

Q: Determine the four support reactions. El is constant L-4 m, q=5 kN/m A q L B

A: Given question is from Basic mechanics. We have to find support  reation. Stepwise solution is…

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A:

Q: If the weight of homogenous bar AB is 10kN, F is 40kN, and bar AB is in equilibrium, calculate the…

A:

Q: Determine the reactions at B and D when b = 60 mm. 80 N A D 75 с 250 mm -90 mm- B

A:

Q: The pulley is frictionless and members ACE and BCD are weightless, Find the reactions at points A,…

A:

Q: 4- Determine the reactions at the support A.

A:

Q: Reaction at A: RA = Reaction at B: RB: = kN KN

A:

Q: 5. For the structure shown, if h=200 mm, determine the reactions at A and B. Answer: RA= 519 N 12.6°…

A: h=200mm To find reaction at A and B

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.