Determine the reactance of the generator corresponding to base values of 200MVA and 35kV

Q: The voltmeters in the figure measure RMS voltages. If V, = 23 V and V, = 14.5V what is V3? R V V3 23…

A:

Q: a) Find Io in the circuit in Fig. P11.7 b) Find VAN c) Find VAB- d) Is the circuit a balanced or…

A: The solution is given below

Q: What's the rise time for this system with its closed-loop poles as shown? Jo x- 14 j6 j8 Select one:…

A: Rise time from the poles given on the graph is determined as shown below

Q: For the DC circuit shown in Figure P30, find the voltage across each resistor and the current in…

A: We have to calculate the voltage and current across each resister.

Q: Problem 15. A source of e.m.f. of 15 V supplies a current of 2A for six minutes. How much energy is…

A: In this question we will find energy provided by source ...

Q: Determine the output waveform for the network of figure below and calculate the output dc level. Si…

A: The solution is given below

Q: a) A sinewave is having a frequency of 100 Hz and instantaneous value of 100 Volts at 1.1 milli…

A:

Q: 6. What is the effect of load inductance on the ripple current? 7. effect of chonnine

A: Effects of load Inductance on ripple current :

Q: 4. Explain the three-level PWM by drawing waveforms.

A: Pulse width modulation(PWM): PWM is a powerful technique for controlling Analog circuits with a…

Q: 7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform…

A: In an inductor voltage leads the current  And in capacitor current leads voltage. The pahsor diagram…

Q: Determine the output waveform for the network of figure below and calculate the output dc level.

A: To solve above problem, one should know what rectifier circuit is and how it works. To charge a…

Q: Q4. Determine the equivalent inductance and equivalent current of the inductive circuit in Figure…

A:

Q: An rms ac voltmeter and a peak-to-peak-reading ac voltmeter are to be used to determine whether…

A: The given peak to peak reading should be converted into peak value and then convert it into RMS…

Q: Q2: Determine the maximum output voltage and 50% voltage and its time for 16-stage impulse generator…

A: The given data's are, Stages n=16, The generator capacitance C1=320×10-916=20×10-9 F, The load…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

A:

Q: %VAI ۲,۷ K/s 9:- Zain 4.5G+ A step down de chopper is connected to an R-52 and L. 10 mH. The de…

A:

Q: Reduce 4-3j 2+2j 0.25 +j1.75 0.25-j1.75 -0.25 +j1.75 -0.25 -1.75

A: Given, The expression is 4-3j2+2j.

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the PIV of the…

A:

Q: Find the RMS current from 30⁰ to 180⁰ at  Im = 10 Amperes

A:

Q: Determine the maximum peak-to-peak ripple current of previous problem by using the next equations,…

A: To determine the maximum peak-to-peak ripple current ((Imax​)), we can use the given equations.…

Q: For the circuit shown below, write the mesh equations using Ia, IB, and Ic, as specified in the…

A: From looking at the circuit, the mesh current for mesh 1 is IA=I1 and for mesh 2 is IC=-I2. Assuming…

Q: In the given circuit, a step down transformer with an RMS voltage as 110V/11-0-11Vis used with R = 1…

A:

Q: 2.1-8 Determine the power and the rms value for each of the following signals: (f) elat cos wot

A: we need to determine power and rms for the given signal.

Q: Tu netuork show in opeating in the thndy doulce. If V, = 2aes2t state wilh sinusoidal ve and V, 2…

A:

Q: Show whether a limit cycle exists or not for the following nonlinear system x₂ =−x₂ + x₂x² x²₂₂ = x₂…

A: a non linear system is given  it is asked to find whether there exists a limit cycle

Q: If there is reactive power associated with a circuit element we can say a) That said element is…

A: Real Power: The power dissipated from the supply is utilized by the resistive nature of the circuit.…

Q: If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit…

A:

Q: en 5 Find the peak time for this system with its closed-loop poles as shown. ed Jout of Select one:…

A: Peak time

Q: ?What is the function of exciter It absorbs reactive power O It generates reactive power None of…

A:

Q: 6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll

A: In this question,   We need to determine the peak voltage Across the load and average power P?  We…

Q: n fast decoupled method, the strong coupling between the following is used, a. Q and V b. P and Q…

A:

Q: Determine the magnitude of the current through the capacitor in the circuit below. VT = 97V RMS, ZT…

A:

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.