Determine the PV array configuration (NpxNs) to charge a 48 V battery bank using a PWM (non-MPPT) charge controller with rated charging current = 30 A & maximum PV input voltage = 120 V. The datasheet of the PV module gives: Pmp = 355 Wp, Vmp = 38.68V, Imp = 9.17A, Voc = 46.88 V & Isc = 9.85 A all @STC. Note: Np represents the number of parallel-connected strings and Ns represents the string length. O a. 3x2

Determine the PV array configuration (NpxNs) to charge a 48 V battery bank using a PWM (non-MPPT) charge controller with rated charging current = 30 A & maximum PV input voltage = 120 V. The datasheet of the PV module gives: Pmp = 355 Wp, Vmp = 38.68V, Imp = 9.17A, Voc = 46.88 V & Isc = 9.85 A all @STC. Note: Np represents the number of parallel-connected strings and Ns represents the string length. O a. 3x2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Please answer the question with neat handwriting
??
Discuss the significance of integrated circuits in modern microchip design.
Biasing in integrated circuit design makes use of what type of DC source? Explain.
I need the answer as soon as possible
A PWM signal changes with a voltage of -15 and 15 volts while it is desirable to produce an effective (average) voltage of the PWM signal of 9 volts. The duty cycle that must be generated is
Discuss the importance of integrated circuits in modern electronics and computing.
a) What is a Field effect transistor? Give its description and classification.b) Explain the working of n-channel / p-channel Junction Field EffectTransistor with its drain characteristics.
A centre-tap full-wave rectifier (CT-FWR) is operated from a (60 Hz), (110 V,ms) line voltage through a transformer with turn ratio of ( = 2). It has a (2 k 2) load resistance. Assume Si diodes. 1. What minimum value of capacitance is required if the ripple must be no greater than 1%? 2. If the filter capacitor is changed to a (470 µF), what is the required load resistance to give the same ripple of 1%. 3. Determine the DC voltage on the load side. 4. What is the power dissipated and minimum PIV of each diode? 5. Draw the circuit diagram with output voltage waveform.
In Amplitude Demodulation ( Envlope Detector )
Discuss the problems with Concentrated Solar Power (CSP) Systems.