Determine the permeability a AFS standard sand specimen of 5.08 cm diameter and 5.08 cm in height. The air drum was raised to take 2000 cm3 of air into it. The whole air was then allowed to escape through the sand specimen at a pressure of 10 g/cm3 in a span of 15 seconds.

Determine the permeability a AFS standard sand specimen of 5.08 cm diameter and 5.08 cm in height. The air drum was raised to take 2000 cm3 of air into it. The whole air was then allowed to escape through the sand specimen at a pressure of 10 g/cm3 in a span of 15 seconds.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

One end of a tube of unknown radius is immersed to a depth of 15 mm in water and an air bubble is blown at the end of this tube. The maximum air pressure measured is 200 Pa. The same procedure is carried out in a liquid and the maximum air pressure recorded in 150 Pa. Determine the surface tension of the liquid. Data given: Density of water = 997 kg/m3 Density of liquid = 850 kg/m3 Density of air = 1.2 kg/m3 Surface tension of water = 72 mN/m
The open-ended pipe has a wall thickness of 2mm and an internal diameter of38mm. Calculate the pressure that the ice exerts on the interior wall of the pipe tocause it to burst along the cross-section and along the longitudinal section. Allowablestress at freezing temperature of the material is 350MPa
The tanks will befilled at 20 °C to a pressure of 100.0 atm. What maximum and minimum pressureswould you expect to observe in a full tank if the ambient temperature will rangefrom -20 °C to 30 °C?
A capillary tube viscometer is being selected to measure viscosity of a liquid food. The maximum viscosity to be measured will be 230 cP and the maximum flow rate that can be measured accurately is 0.015 kg/min. If the tube length is 10cm and a maximum pressure of 25 Pa can be measured, determine the tube diameter to be used. The density of the product is 1000 kg/m3.
solve it fast
A capillary tube viscometer is being selected to measure viscosity of a liquid food. The maximum viscosity to be measured will be 230 cP and the maximum flow rate that can be measured accurately is 0.015 kg/min. If the tube length is 10cm and a maximum pressure of 25 Pa can be measured, determine the tube diameter to be used. The density of the product is 1000 kg/m3.
A fluid is flowing in a glass pipe at a rate of 0.588 kg/s. The pipe has a diameter of 68.5 mm. If the fluid has a density of 1030 kg/m^3 and a viscosity of 2.12 cP at 20 degrees Celsius, determine the Reynolds number. Report your answers to the nearest whole number. Do not round off intermediate answers.
What is the apparatus used to blow and suction air into and out of the bent glass tubing/rubber tubing during the experiment on the determination of surface tension of liquids by the capillary rise method? * Rubber bulb O All of the choices are correct answers. Aspirator O Pipetol
In the tube in image 1, a certain amount of water flows, with areas A1 = 10 cm2 and A2 = 5 cm2. Determine the volume and mass flow, and the average velocity Determine the volume and mass flow, and the average velocity in section (2) (ρH2O = 1000 kg / m3, g = 10 m / s2). Answer .: ϕv = 1L / s, ϕm = 1kg / s and v2 = 2 m / s.
Working for an engineering consultancy firm, your knowledge of fluid dynamics is required to design a new safety feature for a high-pressure air line in a factory. The air line takes the form of a cylindrical pipe of diameter 150 mm, which is designed to operate between 0.45 MPa and 0.76 MPa. At the end of the pipe a burs9ng disk is placed so that, if the pressure exceeds the maximum opera9ng pressure, the air is vented to atmosphere rather than over-pressuring the chemical reac9on vessel (Figures 4a and 4b). In this ques9on, you should treat the flow as quasione-dimensional and inviscid. The air in the surrounding atmosphere is at 101 kPa and 298 K. a) You have a choice of five disks which can withstand the following forces across them before burs9ng: 10.5 kN, 11.0 kN, 11.5 kN, 12.0 kN, 12.5 kN. Which of these burs9ng disks would you recommend, and why? b) Due to an over-pressurisa9on of the air line, the disk bursts at 9me t = 0. At what pressure in the air line will this occur? c)…
Choose Correct Answer .The oil zone lie's between Gas zone and water zone. Upper part of reservoir. Lower part of reservoir. it cuts the rocket the bottom. ?As the bit rotates, what tow things dose it do It Crashes the rock at the bottom. It Cuts and Crushes the rock at the bottom. Of mass to volume ΟΟΟ Densities is the relation Of part to another. ㅇ ㅇㅇㅇ Both of them.
What will be the kinetic energy in kWh of an aeroplane which has a mass of 30 tons and is travelling at 1000 km/hr speed? If this plane is made to nose vertically upwards at this speed with power off, calculate the vertical distance through which the plane will move. Take g = 9.80 m/s²