Determine the mean waiting time W for an M/M/2 system when lambda = 2 and μ = 1.2. Compare this with the mean waiting time in an M/M/1 system whose arrival rate is lambda = 1 and service rate is μ = 1.2. Since the arrival rate per server is the same in both cases and service times don’t vary, should the wait times be the same in both cases?

Determine the mean waiting time W for an M/M/2 system when lambda = 2 and μ = 1.2. Compare this with the mean waiting time in an M/M/1 system whose arrival rate is lambda = 1 and service rate is μ = 1.2. Since the arrival rate per server is the same in both cases and service times don’t vary, should the wait times be the same in both cases?

MATLAB: An Introduction with Applications

6th Edition

ISBN:9781119256830

Author:Amos Gilat

Publisher:Amos Gilat

Chapter1: Starting With Matlab

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

To check the effect of hot temperatures on the elasticity of two brands of rubber bands, one box of Brand A and one box of Brand B rubber bands are tested. Ten bands from the Brand A box are placed in a warm car in the sun for two hours and ten bands from the Brand B box are kept at room temperature. The amount of stretch before the breakage is measured on each rubber band, and the mean for the hot bands is compared to the mean for the others. Is this a good experimental design? No, because No, because temperature is confounded No, because No, because the means are more than two more not proper Yes brands should temperatures should be used. statistics for be used. with brand. comparison.
A scientist is calibrating a laboratory apparatus that will be used to measure the concentration of ozone in air samples. To check the calibration, samples of known concentration are measured. The true concentrations in ppm (x) and the measured concentrations in ppm (y) data points are: (0, 1), (10, 11), (20, 21), (30, 28), (40, 37), (50, 48), (60, 56), (70, 68), (80, 75), (90, 86), (100, 96). Because of random error, repeated measurements on the same sample will vary. The apparatus is considered to be in calibration if its mean response is equal to the true concentration. To check the calibration, the linear model y = ß0 + ß1 + ε is fit. Ideally, the value of ß0 should be 0 and the value of ß1 should be 1. The least-squares estimate of the error standard deviation σ is closest to:
Compute the least-squares regression line for predicting the right foot temperature from the left foot temperature. Round the slope and y-Intercept values to four decimal places.
A researcher is interested in testing the relationship between smoking and BMI (kg/m2) in adults aged 30-45. In order to test this association, the researcher divides smoking into currently more than a pack a day, currently less than a pack a day, and never smokers. The following table represents the BMIs for each participant enrolled by their respective smoking category. Current Smoker (≥1pack/day) Current Smoker (<1 pack/day Never Smoked 26.7 29.4 22.1 29.4 28.6 30.4 24.3 27.4 21.3 28.4 23.2 26.4 21.6 20.1 19.7 27.4 20.6 19.8 26.8 19.7 21.6 36.4 19.6 22.3 31.5 21.6 24.3 27.4 21.5 *Continue as though all assumptions for ANOVA are met. A) Calculate the MSW and MSB for the data represented above. B) Carry out a formal test for a one-way analysis of variance among the groups and interpret your results.
A trucking company considered a multiple regression model for relating the dependent variable y = total daily travel time for one of its drivers (hours) to the predictors x₁ = distance traveled (miles) and x₂ = the number of deliveries made. Suppose that the model equation is Y = -0.800+ 0.060x₁ +0.900x₂ + e (a) What is the mean value of travel time when distance traveled is 50 miles and four deliveries are made? hr (b) How would you interpret ₁ = 0.060, the coefficient of the predictor x₁? O When the number of deliveries is constant, the average change in travel time associated with a ten-mile (i.e. one unit) increase in distance traveled is 0.060 hours. O The total daily travel time increases by 0.060 hours when the distance traveled increases by 1. O When the number of deliveries is held fixed, the average change in travel time associated with a one-mile (i.e. one unit) increase in distance traveled is 0.060 hours. O The average change in travel time associated with a one-mile (i.e.…
Given the “data” determined by y = x^3 + (x-1)^2 with x = 0.1, 1.2, 2.3, and 2.9, calculate SSTO, SSR, and R^2. Then recalculate these using x = 0.3, 1, 2.45, and 2.8. Does where you collect your data (i.e., which values of x) appear to impact your interpretation of how good the linear model fits?.
Arm circumferences (cm) and heights (cm) are measured from randomly selected adult females. The 143 pairs of measurements yield x = 32.40 cm, y = 160.39 cm, r=0.072, P-value = 0.393, and y = 157 + 0.1075x. Find the best predicted value of y (height) given an adult female with an arm circumference of 34.0 cm. Let the predictor variable x be arm circumference and the response variable y be height. Use a 0.05 significance level. %3D The best predicted value is cm. (Round to two decimal places as needed.) Enter your answer in the answer box. MacBook Pro 888 esc %24 % & 4. 9- E T. Y. H. K %#3
Arm circumferences (cm) and heights (cm) are measured from randomly selected adult females. The 139 pairs of measurements yield x = 31.99 cm, y = 163.33 cm, r= 0.032, P-value = 0.708, and y = 158 + 0.1703x. Find the best predicted value of y (height) given an adult female with an arm circumference of 35.0 cm. Let the predictor variable x be arm circumference and the response variable y be height. Use a 0.05 significance level. %3D ..... The best predicted value is cm. (Round to two decimal places as needed.)
Consider the following population model for household consumption: cons = a + b1 * inc+ b2 * educ+ b3 * hhsize + u where cons is consumption, inc is income, educ is the education level of household head, hhsize is the size of a household. Suppose a researcher estimates the model and gets the predicted value, cons_hat, and then runs a regression of cons_hat on educ, inc, and hhsize. Which of the following choice is correct and please explain why. A) be certain that R^2 = 1 B) be certain that R^2 = 0 C) be certain that R^2 is less than 1 but greater than 0. D) not be certain
A researcher wishes to examine the relationship between years of schooling completed and the number of pregnancies in young women. Her research discovers a linear relationship, and the least squares line is: ˆy=5−4xy^=5-4x where x is the number of years of schooling completed and y is the number of pregnancies. The slope of the regression line can be interpreted in the following way: When amount of schooling increases by one year, the number of pregnancies tends to decrease by 4. When amount of schooling increases by one year, the number of pregnancies tends to increase by 4. When amount of schooling increases by one year, the number of pregnancies tends to increase by 5. When amount of schooling increases by one year, the number of pregnancies tends to decrease by 5.
A critical communications relay has a constant failure rate of 0.1 per day. Once it has failed, the mean time to repair is 2.5 days (the repair rate is constant). Calculate the interval availability over a 2-day mission (starting at time zero) and the point availability at the end of the 2 days.
"Space Mountain", a classic attraction at Disneyland Park, attracts many tourists to take a ride. Each ride can take tourist at a rate of 5 persons/min. The park is opened at 9:00 AM. Based on daily observations, it is found that the tourist arrival rate is 8 persons/min during 9:00 AM - 12:00 PM, 5 persons/min during 12:00 PM - 3:00 PM and 2 persons/min after 3:00 PM. Apply a D/D/1 queuing model to calculate what is the maximum number of tourists waiting in the queue? (Round to the nearest integer and fill in the blank with a number only.) Tourist # 180 D/D/1 360 Time (min) A