Determine the maximum axial force P that can be applied to the joint if the shear stress in each of the bolts is not allowed to exceed 85 MPa and the shear stress along each of the four shear planes is not allowed to exceed 0.60 MPa. The diameter of each bolt is 6 mm.

Q: For the given riveted connection shown, having the allowable stresses: Fy = 248 MPa Fy = 150 MPa…

A:

Q: 2. A connection is made from two 1.9 cm bolts in parallel, placed on a 21.6 cm wide steel bar. The…

A: Given data:- Diameter of bolts,d = 1.9 cm  Thickness of steel bar, t = 2.54 cm Ultimate strength of…

Q: For the connection shown, the bolt diameter is d = 15 mm. The average shear stress in the bolts must…

A:

Q: Problem 5: A hole is to be punched out of a plate having a shearing strength of 40 ksi. The…

A: Note-Since we answer one question at a time so we will answer the first one. Please resubmit another…

Q: Three bolts are to be used to attach the steel plate shown to the wooden beam. Knowing that the…

A: Shear stress acting in parallel with the solid body causes the conversion. As the liquid evaporates,…

Q: Figure below. The bolt has a diameter of 10 mm and an allowable shear stress T allow 80 MPa. Each…

A: Given dataA lap joint with a bolt of 10mm dia.,To calculate maximum Load that is to be taken by the…

Q: The following image shows a front and side view of the column connection. The bolts have a diameter…

A:

Q: Material Strengths: Fy = 248 MPa, Fu = 400 M Pa For the two lines of bolt holes, the pitch is the…

A:

Q: From the bolted connection shown in the figure, the steel plates which is 275 mm x 12 mm is…

A:

Q: The bolts in the lap joint shown are 22mm in diameter and 25mm diameter holes. The plates are A36…

A:

Q: Five bolts are used in the connection between the axial member and the support. The ultimate shear…

A:

Q: Determine the maximum factored LRFD tensile force capacity in tension only (no block shear). The…

A: We know that Maximum factored LRFD tensile force capacity of the member is given by minimum of the…

Q: Five bolts are used in the connection between the axial member and the support. The ultimate shear…

A:

Q: Calculate the maximum shear force in the bolts in figure 1. P= 170 kN X= 150mm y= 125mm Y Y X Figure…

A: Connections are required at various points in steel structures. Bolts are frequently employed in…

Q: Question 3) The tension member shown in Figure 1 contains holes for in. bolts. At what spacing, s,…

A: We need to calculate spacing between two bolts.

Q: Q1: Determine the largest load P that can be applied to the bars ofthe lap joint shown in Figure…

A: Given:- ζallow=80 MPad= 10mmσtallow=50 MPaσballow=80 MPaζallow=30 MPaTo find:-Largest Load P

Planar Stresses