Determine the magnitude of the pin reactions at B and Cif W = 2180 Ib. 3.5' 3.5' B 2.1' W D

Q: Determine the magnitudes of all pin reactions for the frame loaded as shown. 770 N 295 mm B 675 mm…

A: To determine the reactions at A, B and D.

Q: For the loading, determine the reaction at C.

A: Here, Reaction at C will be  C=Cj Force p will be, P=84k Unit vector in direction BD will be,…

Q: 100 Ibs 3. Determine the reactions at Points A and B for angle alpha = 60 degrees. 12 in.

A: Given data as per question The load applied =100 lbs Considering FBD of the system taking moment…

Q: Solve for all reactions at A and B

A: The free-body diagram of the given truss system can be drawn as below, Here, RB is the normal…

Q: Refer to the diagram. The roller at A is in a smooth slot. Determine the reactions at A and O.

A: for vertical equilibrium F1sin 55 + Ay = Ry1.258 * sin 55 + Ay = Ry   For Horizontal Equilibrium…

Q: Q2) Determine the reactions at the roller at A and pin at B. 10 kN -0.6 m -0.6 m 6kN 0.8 m 30 60 0.4…

A:

Q: The boom derrick supports a suspended 15-kip load. The booms BC and DE are each 20 ft long. The…

A: GIVEN :- a=15 ftb=2 ftBC=DE=20 ft θ=30°β=77.4°SOLUTION :-choose a cordinate system at point C, with…

Q: Determine the magnitude of the pin reactions at B and Cif W = 2180 lb. 3.5' 3.5' BI 2.1' W Answers:…

A:

Q: 30 kN 50 kN to B D A 1m 3 m 2 m Determine the following: 35. Reaction support at point B.

A: Given, Load = 30 kN and 50 kN

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.