Answered: Determine the forces in members BE and… | bartleby

Related questions

Question

Determine the forces in members BE and CE of the loaded truss. The forces are positive if in tension, negative if in compression.
3.1 m
41°
5.6 kN
B
3.1 m
5.6 KN
E
BC=CD
C
3.1 m
D

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Determine the force in member CE of the truss, and state if the member is in tension or compression. Aby 6 m D 600 N 4 m B 900 N 4 m
Determine the force in member BE of the loaded truss. Enter a positive number if in tension, negative if in compression. 11' B 14' 15° 15° F E 11' 15° 1.0 L 1.7L 15° 45° A Answer: BE = i !L 45° D
A uniform 6.59 m long horizontal beam that weighs 269 N is attached to a wall by a pin connection that allows the beam to rotate. Its far end is supported by a cable that makes an angle of 52° with the horizontal, and a 586 N person is standing 1.16 m from the pin. R. FT 52 1.16 m 269 N 586 N 6.59 m Find the force Fr in the cable by assuming that the origin of our coordinate system is at the rod's center of mass. Answer in units of N.
Needs Complete solution with 100 % accuracy don't use chat gpt or ai plz plz plz plz.
Structural member AB is to be supported by a strut CD. Determine the smallest length CD may have, and specify where D must be located for a strut of this length to be used. Take x= 120 mm. 60 mm D. y 20 mm E The smallest length CD may have is mm. The coordinates of point Dare ( and Imm.
PRO BLEM 2: A TRICKY STRUT An orange strut of length l is connected to a wall via a pi vot at the bottom. An additional (blue rope) also connec ts the strut to the wall attached at an angle 01. A load of weight W is hanging from the strut; the load makes an angle 02 with the strut as shown in the diagram. In order to stabilize the system, and additional force needs to be applied. That force, which is labeled C in the diagram, makes an angle p with respect to the strut as shown. What is o?