Determine the current going through inductor L2 in Amperes of the following circuit: V1 30V R1 www 50 L2 www 1H LR3 100 R2 ww 100 C1 수 1µF IL3 31H

Q: What is the time constant for a 10 H inductor in series with a 800 resistor? 7.0 sec 0.094 sec 0.013…

A: inductance (L) = 10 H resistance (R) = 800 ohm

Q: 6 A R₁ L₁ m L2 R₂3 in L3 ell R3 i2

A:

Q: An indictor with inductance L = 0.2 H and negligible resistance is connected to a battery, a switch…

A: Given:  L = 0.2 H R2 = 10 ohms R1 = 15 ohms  E = 80 Volts

Q: 820 winding wire coil with resistance of 24 n wrapped around a 7 cm long solenoid with 12500…

A:

Q: Don't use chat gpt

A:

Q: Consider a circuit shown below with the following parameters, battery voltage V=13 V, the resistors…

A: When the switch is immediately closed, the inductor will behave as a resistor of infinite resistance…

Q: For Transformer winding1 N131000 turns, N2= 200 turns and V1=220 Volts, secondary resistance of 22…

A: Solution:-Given thatFor Primary windings;N1=1000 turnsN2=200 turnsV1=220 voltsFor Secondary…

Q: & = 36.0V R₁ =6.00 ₪ R₂ = 4.00 Ω R3 = 12.00 C=6.00 μF The capacitor in the shown circuit is…

A:

Q: The I vs t graph shown below is for an LR circuit without a battery. I (A) 12 16 14 10.5 7. 3.5 8 20…

A:

Q: At time t-0, the switch is closed. What is the current thru the inductor L after a long time? O 3.0A…

A:

Q: In the following circuit, the switch is initially closed. At t=0, the switch is opened. Select the…

A:

Q: Inductor 1 stores the same amount of energy as inductor 2, although its inductance is only half the…

A:

Q: In the figure below, a 13.0 V ideal battery, a 23.302 resistor, and an inductor are connected by a…

A:

Q: A 14.0 V battery is connected in series with a resistor and an inductor. The circuit has a time…

A:

Q: The voltage across an inductor is proportional to the inductor and the derivative of the current…

A: As we know that,          Voltage across Inductor is given by :…

Q: A series RLC circuit with consists of a 35 2 resistor, a 125 mH inductor, and a 125 µC driven by a…

A:

Q: current in the circuit

A:

Q: E= 18 V 0.5 Q R 2.5 Q- R, a 6.0 2 R 1.52 h 0.5 N E, = 45 V What is the equation which results when…

A: Given Find the equation which results when applying the loop rule to loop aedeba and current I2.

Q: An inductor in the form of a solenoid contains 430 turns and is 17.4 cm in length. A uniform rate of…

A:

Q: An RLC circuit governed by the equation Lq" + Rq + q/C = E0(t)sin wt a)get the equation for the…

A:

Q: γVV C 3.3 k2 Find the Current through R5 2.5 A R1 R R3 IA R6 R2 ww Rs Write the Kirchoff's loop…

A:

Q: 1. 2 12 t(s) Determine the time constant of the LR circuit. TH If L = 6 H, determine R. R = P

A: By observing the graph; The maximum current Imax=3.8A As we know that the current in delay is equal…

Q: A cr IS constructed one inductor, one battery and a switch as shown. The values for the resistors…

A: R1=R2=39 ΩR3=62 ΩR4=126 ΩL=362 mHV= 12 V.

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.