Determine the balanced hauls and indicate the direction of haul for the mass diagram showR below. The LPH is 4,000 ft. Also, show on the profile what cut sections will be hauled to what fill sections, and indicate any borrow or waste sections. Calculate the average haul distance for each balanced haul. 75000 50000

Q: 3. An 8"diameter timber pole is fixed into a large concrete footing at grade and is completely pin…

A:

Q: A wooden pile is being driven with a drop hammer weighing 30 kN and having a free fall of 1 m. The…

A:

Q: A pre-cast wooden pile is being driven with 50 kN drop hammer having a free fall of 100 cm.…

A: Drop hammer weight W=50 kN, Free fall H=100 cm, Penetration S=0.45 cm,

Q: Calculate the load bearing capacity of the pile shown in Figure Q5. Assume that it is a bored pile,…

A: Given, L = 18.5 m B = 0.60 m

Q: Engineers have observed that the axial capacity of piles driven into saturated clay improves with…

A: During pile driving operation, the soil is disturbed which in-turn induces pore pressure due to…

Q: Write a Short note on Statical Analysis (Single Pile Capacity).

A: Static Analytic Method Of Single Pile Capacity

Q: A wooden pile is being driven with a drop hammer weighing 20 kN and having a free fall of 1.0m. The…

A: Weight of drop hammer = 20 kNFree fall = 1.0 mPenetratiin in last blow = 5 mmTo Find :Load carrying…

Q: 3. As shown in the diagram, the RC solid precast square pile will be lifted up by two points, the…

A:

Q: What will be the load carrying capacity (kN) of group of 6 piles, if the individual load carrying…

A: No. of piles N = 6 Load carrying capacity of individual pile = 150 kNGroup effeciency = 75 %To Find…

Q: 7.6 A dozer with as S-blade has pushed a normal load onto a level area. The height of this load…

A:

Q: QUESTION 15 A 20 m normal weight concrete pile is driven into the ground. How long will it take in…

A:

Q: A solid circular concrete pile is to be driven into a clayey soil with the following properties:…

A: Cu1 = 40 kPa Length (L1) = 5 m unit weight (γ1) = 15 kN/m3 Cu2 = 50 kPa Length (L2) = 10 m unit…

Q: Determine the cycle time for a single-engine scraper rated at 21 cy heaped that is used to haul…

A:

Q: The average values of the undrained shear strength (cu) with depth are given below. If a CFA pile…

A: Determining the empirical adhesion factor-Length of the pile=10mHence, Cu=80 kN/m2, would be taken…

Q: QUESTION 3: Three forces act on a pile as shown. If the resultant of the three forces is equal to…

A: An arrangement of forces have been given and it has been asked to determine missing force and its…

Q: A pile is driven into the ground with a drop hammer weighing 1200 kg and having a free fall of 2.0…

A: Given data- Weight of drop hammer W=1200 kg, Free fall H=2 m=200 cm, Penetration S=1 cm, To Find-…

Q: The pile P has a mass of 800 kg and is being driven into loose sand using the 300-kg hammer C which…

A: In this problem  Given data: Mass of the pile (M) = 800 Kg Mass of the hammer (m) = 300 Kg Height of…

Q: Calculate the steel of spiral stirrups for a circular pile of X meter height where X is 133 and…

A: Spiral Stirrups of a Circular Pile Length of pile, L=133 m Diameter of pile, D=1.25 m Pitch of…

Q: Question: A pile with a diameter of 0.4 m and length of 30 m is driven into the soil ground. Find…

A:

Q: Calculate the pile's allowable bearing load using the corrected SPT values at various depths given…

A:

Q: 0.5 m diameter concrete pile is driven at a site as shown in Figure below. What is the pile's…

A: Terzagi bearing capacity factor chart:

Q: What will be the load carrying capacity (kN) of a group of 6 piles, if the individual load carrying…

A:

Highway Safety

Proper highway safety refers to the methods or rules that prevent highway travelers from being killed or severely injured. Proper highway safety measures help to protect motorists, cyclists, pedestrians, passengers on public transport, and so on.