Determine the approximate value of Ip of Figure 51. 12V 31.5ka Q1 V, 1MQ V1 12mA pss -4V 1.5 V Figure 51. O 75 mA O 6.12 mA O 5.625 mA O 4.69 mA 1:31 am /

Six 100Wp crystalline PV modules, each with an open circuit voltage (Voc) of 30V, are connected in series in a string. What would be the total open circuit voltage (Voc) of the string of modules? And what would be the total Wp of the string? 180V, 600Wp 180V, 100Wp 30V, 600Wp 30V, 100Wp The distance from a combiner box to a PV array junction box is 4 m. The voltage drop of the used cable on this distance is 0.5 V. The current is 8.0 A. What is the power loss on this distance? 16 W 32 A 4 W 2 W A PV system has a rated capacity of 10 kWp. The overall efficiency of this PV system is 75% . The average daily irradiance at the site is 4 kWh/m²/day. What is the expected average daily energy output of this system? 3 kWh 30 kWh 7.5 kWh 40 kWh

H.W: Determine Vo and ID for the circuit in figure below after adding a resistance of 2kQ in series with both diodes +20 V Si St 4.7 ks2

In Figure-1 (a and b), calculate the load current, load voltage, load power, diode power, and total power using 3d approximation if Rp 802 and diode current is 10 mA. Note please solve within 30 minutes.avoid plagiarism

not use ai please don't

Determine VL, IL, IZ and IR considering that RL = 180 Ω. Check if the zener drives with such an arrangement. In the case of not driving, what arrangement do you have to perform to regulate the zener diode.

B) For the circuit shown below, what is maximum load current Iį that can be drawn from the Zener regulator shown below if it is to maintain a regulated output? What is the maximum power dissipated by the Zener diode. IppaX 15 kQ RL 30 V Rz=0 A6=24

Determine the voltage waveforms across each half of the secondary winding and across RL when a 100 V peak sine wave is applied to the primary winding. (Si diode used) What minimum PIV rating must the diodes have? D +25 V ----- 2:1 +100 V IN4001 0- Vin oV -25 V -S RL 10 kf -100 V +24.3 V ---- IN4001 Vot 0- alll

The data sheet of a JFET gives the following information: IDSS = 3 mA, VGS(off)= - 6 V, and gm(max)= 5000 . For VGS = - 4 V. find the drain current.

For the circuit in the figure, let V input = 8V, Ri = 12ohms, RL = 10ohms, and VZ = 3.3V. Determine the voltages and currents of the resistors and the current of the zener diode.