Don't used Ai solution and don't used hand raiting Determine the amount of Cd²+ per gram of dry clam weight. Express your final result as weight percent (grams of Cd²+ pergram of dry clam multiplied by 100). Additionally, find the absolute uncertainty (standard deviation) and the 95% confidenceinterval of the measurement. Consult the Student's t table as needed. Report the absolute uncertainty and 95% confidence levelwith two significant figures.wt% =1.6Incorrect Answer0.034uncertainty +Incorrect Answer0.11%%confidence interval +Incorrect Answer%

Step 1:Determine the weight percent of CdThe weight percent (wt%) is calculated by dividing the mass…

Answered: Determine the amount of Cd²+ per gram…

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter1: Introduction

Section: Chapter Questions

Problem 1.10QAP

See similar textbooks

Similar questions

Explain the difference between the propagated uncertainty and the standard deviation. Which number would you use to describe the uncertainty in the measurement?
A solution is prepared by weighing 5.0000 g of cesium iodide into a 100-mL volumetric flask. The balance used has a precision of 0.2 mg reported as a standard deviation, and the volumetric flask could be filled with a precision of 0.15mL also reported as a standard deviation. What is the estimated standard deviation of concentration (g/mL)?
calculate mean,SD and 95%confidence limit. Use t=4.3.Compare the two means using the student's t test and precision of the two methods using F test at 95% confidence level . For two sets of three replicates use t=2.78 and fcrit=19
Consider the following sets of replicate measurements: (1) Calculate the mean and standard deviation of Group A. (2) Determine the confidence interval at 95% confidence level. Assume the data here are the only knowledge you have and no previous measurements are available.
Explain the difference between the propagated uncertainty and the standard deviation. Which number would you use to describe the uncertainty in the measurement? if the standard deviation is 0.01 and the propagated uncertainty is 0.03
A calibrated pipet delivers a mean volume of 24.991 mL with a standard uncertainty of ± 0.006 mL. What is the uncertainty if you deliver four aliquots to reach 100 mL?
For a concentration technique, Stotal is given as 19.31 ± 0.035, Smb is 0.22 ± 0.008, and kA is 0.154 1 0.007 ppm, where Stotal is the signal, kA is the method's sensitivity for the analyte and Smb is the signal from the method blank. If we want the absolute percent uncertainty of the concentration CA to be 2.6%, which statement is false below? (Hint: refer to sections 4B.1 and example 4.7 in your textbook) We must improve the uncertainty in KA to 10.004 ppm-¹. O Uncertainty in the method's sensitivity dominates the absolute uncertainty. O Improving the signal's uncertainty will improve the absolute uncertainty.
Rewrite the number 3.123 56 (+0.167 89%) in the forms (a) number (6absolute uncertainty) and (b) number (+percent relative uncertainty) with an appropriate number of digits.
What is a 99% confidence interval uncertainty of the slope when we are given a trendline with a slope of 42.211 and an R² value of 0.9991 for a set of 145 data points?
Estimate the absolute deviation(or uncertainty) for the results of the following calculations. Round each result so that it contains only significant digits. The numbers in parentheses are absolute standard deviations. Finally, write the answer and its uncertainty.a.) Y= 6.75 (± 0.03) + 0.843(±0.001) - 5.021 (±0.001) = 2.572b.) Y= 19.97(± 0.04) + 0.0030(±0.0001) + 4.29(±0.08) = 24.263c.) Y= 143(± 6) - 64(±3) = 5.9578 x10-21249 (±1) +77 (±8)
The following densities of water were obtained by Student A: 1.07 g/mL, 1.14 g/mL, and 1.13 g/mL. Show how Student A determined the density of water to be 1.11 ± 0.04 g/mL. Calculation for the average = 1.11 g/mL: Calculation for the standard deviation = 0.04 g/mL:
How would you calculate Standard Deviation?

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Instrumental Analysis

Chemistry

ISBN:

9781305577213

Author:

Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:

Cengage Learning

Appl Of Ms Excel In Analytical Chemistry

Chemistry

ISBN:

9781285686691

Author:

Crouch

Publisher:

Cengage

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Principles of Instrumental Analysis

Chemistry

ISBN:

9781305577213

Author:

Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:

Cengage Learning

Appl Of Ms Excel In Analytical Chemistry

Chemistry

ISBN:

9781285686691

Author:

Crouch

Publisher:

Cengage

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Principles of Modern Chemistry

Chemistry

ISBN:

9781305079113

Author:

David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS