Determine the all-day efficiency of a 10 KVA 2220/220V 60 Hz transformer. During a day of 24 hours, it is loaded with unity power factor as under the following condition: 2 hours at five-fourths load; 6 hours at full load; 8 hours at half load; 4 hours at one-quarter load; 4 hours at no load. Take core loss as 153 W and full-load copper loss as 224 W.

Determine the all-day efficiency of a 10 KVA 2220/220V 60 Hz transformer. During a day of 24 hours, it is loaded with unity power factor as under the following condition: 2 hours at five-fourths load; 6 hours at full load; 8 hours at half load; 4 hours at one-quarter load; 4 hours at no load. Take core loss as 153 W and full-load copper loss as 224 W.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

2. If the length of a conductor is halved, then the resistance of the conductor a. becomes double the initial value. b. remains the same. c. becomes half of the initial value. d. becomes four times the initial value.
I need the answer as soon as possible
A piece of wire has a resistance of R. Another piece of wire has twice the length and also twice the diameter of the first piece of wire. Find the resistance of the second piece of wire in terms of R.
5. Assignment 1: Derive the microscopic model of current. Explain each step carefully with diagram. Hand written. Explain the Random, and drift velocity. Give values.
Describe an Electrical circuit
A wire of 59 in length and 4 mm2 has a resistance of 0.94 ohms. A 110-m length of wire of the same material has a resistance of 3 at the same temperature. Find the radius of this wire. The final unit must be in millimeter, mm.
Q1. Give the definition of: a) Resistance: b) Reactance: c) Phasor diagram: d) What is the unit of reactance?
8. Determine the reluctance of a piece of cast steel of length 150 mm and cross-sectional area 1800 mm2 when the relative permeability is 4000. Find also the absolute permeability of the cast steel.
QUESTION -8 The plot describing the thermal characteristics of copper wire is given in the figure. Using this plot, for a 1000ft length copper wire with 10 Ω resistance at room temperature (20oC)a) Calculate the resistance value at 100oC.b) Calculate the power consumed in the cable carrying 10A current at this temperature (100oC) in units Watt.c) Calculate the amount of energy consumed in the cable during a day with the conditions in (a) and (b) in units Joules.d) A motor with 600Watt output power that works with 85% efficiency is driven with 10A current carried in the cable at 100oC. Calculate the amount of power transformed (dissipated) into heat in this system.e) Consider that a cooling system is used to cool the cable to 50oC and the cable carries 10A current. How many watts should be the maximum amount of power consumed by the cooling system in order to gain power (consume less total power).
12. You plot the current-voltage characteristics of a new non-ohmic device, perform a curve fit, and discover the current as a function of voltage is given by the equation: I = (9Amp/volt")V² – (7Amp/volt) V (a). Perform calculations to find the slope of a line tangent to this curve when V = 4.15 volts. (b). Calculate the effective resistance of this device when V = 4.15 volts. This device is Non-Ohmic!
how is resistance related to physical parameters
Two coils are placed close to each other as shown in the figure. The coil on the left is connected to a battery and a switch, and the coil on the right is connected to a resistor.What is the direction of the current in the resistori. an instant after closing the switch?ii. after the switch has been closed for several seconds?iii. an instant after opening the switch?Choose your answers betweento. on the leftb. on the rightc. the current is zero.And clearly explain the reason for your answer.