Determine load carrying capacity of pile without considering critical depth concept. Diameter of pile 0.4 m.Nq =132 for o = 40° to o m Cor-off K= 1 S- 0.75¢ = 21-75 looe Sand Soft Clay Cu 20k Demse Sund 2 20 kA K=2 $=40° 30°

Q: Calculate the pile point bearing capacity using Meyerhof's Method, where a Concrete pile of diameter…

A: The given data is: Diameter of concrete pile=12 in Length of pile=25 ft Unit weight of sand, γ=128…

Q: A 14-in.-diameter steel pipe pile is driven 50 ft into overconsolidated clays having the following…

A: The ultimate bearing capacity of the pile is given by,

Q: 3. As shown in the diagram, the RC solid precast square pile will be lifted up by two points, the…

A:

Q: A group of 16 piles is arranged in a square pattern. The pile diameter is 350 mm. The length of pile…

A: The diameter of each pile, Total number of pile, The center-to center distance of pile is 1 mThe…

Q: Determine the base capacity of a square pile with a 0.4 m width and a 10 m length using Hansen's…

A:

Q: A group of nine piles is arranged in a square pattern and is used as a foundation for column in…

A: Given-9-pile group arranged in a square pattern,foundation in sand,diameter d= 350 mm= 0.35…

Q: A group of nine piles is arranged in a square pattern and is used as a foundation for column in…

A: Given-9-pile group arranged in a square pattern,Foundation in sand,Diameter d=350 mm=0.350m,Spacing…

Q: 9.5 Following is the variation of Ngo with depth in a granular soil deposit. A concrete pile 9 m…

A:

Q: When we classify the piles in accordance to the type of loading, then we may call it as: *End…

A: Piles are vertical or slightly inclined, relatively slender structural foundation members. They…

Q: An 18" square solid concrete pile is driven with an impact hammer to a depth of 55ft below grade…

A: Solution: Considering the Diagram: Qp=qpApqp=σvo'      Nq*≤0.5pa  Nq*tanφ…

Q: 10 A pile of 40cm diameter and 18.5m -long passes through two layers and embedded in a third layer.…

A:

Q: 17) The friction load capacity of the pile using the B-method is most nearly: a. 437 kN b. 927 kN c.…

A: To determine- Friction load capacity

Q: Calculate the steel of spiral stirrups for a circular pile of X meter height where X is 133 and…

A: Spiral Stirrups of a Circular Pile Length of pile, L=133 m Diameter of pile, D=1.25 m Pitch of…

Calculation of Settlement

The vertical displacement of the structural foundation due to the loading from the superstructure is known as settlement. It is due to the reduction of air voids present in the soil. The amount of vertical displacement depends on the bearing capacity of the soil on which the foundation is laid. The effect of the settlement depends on the magnitude of settlement, uniformity, and the structural design of the structure. The maximum allowable settlement for residential and office buildings should be less than 18 mm, for industrial buildings, it is 38 mm and for commercial buildings, it is 25 mm.