Detemine the principal stress acting at point B, which is located just on the web, below the horizontal segment on the cross section. Show the results on a properly oriented element located at this point. Although it is not very accurate, use the shear fomula to calculate the shear stress. -NEK) mm 300'mm 150 mm 12 mm 130 mm--15 mm 6 kN

Q: Two plates are joined by four bolts of d=20-mm diameter, as shown in the figure. The shearing stress…

A: We have to determine the value of maximum load P as the shearing stress is limited to 70 MPa,…

Q: The rigid bar EFG is supported by the truss system shown. Knowing that the member CG is a solid…

A: Given Load PSpan 12 ftTo find out Normal stress in CG

Q: A steel pipe of 300-mm outer diameter is fabricated from an 8-mm-thick plate by weldingalong a helix…

A: Step 1:Step 2:

Q: A B C 80 kN 2 m 50 kN D E F -1m--1 m--1 m--1 m-|

A:

Q: 3. Determine the required diameter of the pins at A and B to the nearest 1mm if the allowable shear…

A:

Q: the stress system shown, calculate the magnitude of the shear stresses on Ty and the angle a, (72…

A:

Q: 9-3. The state of stress at a point in a member is shown on the element. Determine the stress…

A: To determine the stresses acting on the shown plane AB.   The stresses acting on the plane AB can be…

Q: For the element with stresses as shown below, find: . The magnitudes and directions of major and…

A: To determine-

Q: The piece of plastic is originally rectangular. After the application of force, it deformed in the…

A: L = 500mm B = 800mm ∆Cx = a = 2mm∆Cy = b = 1.5mm∆Dx = c = 4mm∆Dy = b = 1.5mm

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Q: . For the riveted connection shown in the figure using  elastic analysis a. Determine the safe value…

A: Diameter of rivet = 25 mmAllowable shear stress = 150 MPaloading = 50 KNOther Data are given in the…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.