Design the slab reinforcement if the maximum positive moment is Mup= wul2/11 and the maximum negative moment is Mun= wul2/10

Q: A beam has a cross section show below. If the stress at point P is 30Kpa , calculate the value for…

A: Given values Shear stress = 30kpa Shear force, V= ? Formula used -> shear stress = V*Yc*A/INA*t…

Q: 8 kN/m 35° E By D 20 kN 0.4 m 0.4 m 0.4 m

A:

Q: Problem 1: A horizontal force P = 650 kN is acting at joint C. The length of AB is 3 m. and members…

A:

Q: The steel pipe AB has a 64-mm outer diameter and a 5-mm wall thickness. Knowing that arm CDE is…

A:

Q: Rod BD is made of steel (E= 29 x 106 psi) and is used to brace the axially compressed member ABC.…

A: the rod BD is made of steel EBD=(29 x 106) psi= (29 x 103) ksi and it is used to brace the axially…

Q: A simply supported wood beam that is 13.8 m long carries a 30 kN concentrated load at B. The…

A: Given data L = 13.8 m  a = 75 mm  b = 155 mm c = 40 mm d = 390 mm P = 30 KN So,  2L/3 = 2×13.8/3 =…

Q: For the truss shown below, applied loads are PB = 73 kN, PC = 36 kN and PD = 15 kN. Using the sign…

A:

Q: the allowable bearing stress for the material under the supports at A and B is ob = 810 p n be…

A:

Q: 2. Determine the largest load P that can be applied to the frame without causing either the average…

A: member CB has a square crosssection of 25mm sideat section a-aaverage normal stress(average shear…

Q: Required information Consider the beam and loading shown. If a=8 in, b=9.0 in, c=1 in. For a section…

A: Draw the free-body diagram of the beam.

Q: of A1 = 1.95 in.2. and yield stress of σy = 150 ksi; member (2) has a cross-section area of A1 = 9.2…

A:

Design criteria for structural loading

The different loads such as loads due to self-weight (dead load) and external loads such as live load, wind loads, seismic load, snow load, and other loads and load combinations that influence the design of a building are called structural loading. The nature of the applied load differs from changes in the location, design, and type of materials used. The design criteria require that structures must be designed and constructed to be able to withstand all load types that are expected to act upon the structure and render its usage for the designated purpose. The structural members such as beams, slabs, columns, and foundations help the structure to withstand the applied load. There are different institutes such as ASCE and ACI that provide building design codes to assure minimum safety requirements and quality of the structures.