Design a two phase traffic signal by using webster's method when the average normal flow of traffic on cross roads 1 and 2 during design period are 400 and 250 P.C.U/hr respectively. Also the saturations flow values are estimated as 1250 and 1000 P.C.U/hr and the all-red time required for crossing of pedestrian is 12 seconds.

Design a two phase traffic signal by using webster's method when the average normal flow of traffic on cross roads 1 and 2 during design period are 400 and 250 P.C.U/hr respectively. Also the saturations flow values are estimated as 1250 and 1000 P.C.U/hr and the all-red time required for crossing of pedestrian is 12 seconds.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An intersection has a three-phase signal with the movements allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired. O 20.464 sec O 22.411 sec O 24.460 sec Phase O 21.035 sec Allowed movements Analysis flow rate Saturation flow rate Using v/c equalization ratio, calculate the effective green time for phase 2 NB L, SB L 330, 365 veh/h 1700, 1750 veh/h 2 NB T/R, SB T/R 1125, 1075 veh/h 3400, 3300 veh/h EB L, WBL 110, 80 veh/h 650, 600 veh/h 3 EB T/R, WB T/R 250, 285 veh/h 1750, 1800 veh/h
Problem 1: Textbook Problem 7.1 W An intersection approach has one left-turn lane. The signal cycle length is C = 90 seconds, which is divided into r= 74 seconds of effective red, followed by g = 16 seconds of effective green. At t = 0 (start of the effective red), there is a queue of 3 vehicles. Left turn vehicles arrive at a constant rate of λ = 200 . During the 16 second effective green time, left-turn vehicles cross the stop line at one vehicle every 2 seconds. veh a. Sketch the graph of cumulative arrivals and departures from t = 0-90 seconds. Shade the area that represents the total delay. b. At t = 90 seconds, how many vehicles arrived? How many vehicles departed?
An approach at a signalized intersection with a 60-second cycle gets 30 seconds of displayed green time. Yellow time is 4 seconds and all-red is 2 seconds (lost time is to be determined from standard assumptions). At the beginning of an effective red there are 4 vehicles in the queue and the saturation flow is 876 veh/h. The arrival rate is given by v(t) = 0.20 - 0.002t [with v(t) in veh/s and t in seconds after the beginning of the effective red]. What is the average vehicle delay for this approach in seconds at the end of the cycle (until the next effective red) that started with the 4 vehicles queued at the beginning of the effective red? (Assume D/D/1 queueing. Please provide you answer in decimal form without units)
A traffic signal control is being designed for a four-leg intersection on a divided highway with the characteristics shown in the table below. Assuming the average vehicle length L is 6m, Determine an appropriate length of the yellow interval for each approach and how you will provide it. Use the AASHTO recommended deceleration rate and perception-reaction time. N-S Approaches E-W Approaches Median width, (m) 6. 3 No. of 3.5 lanes 3 on each approach Design speed, km/h 60 Grade -3.5 2. 80
Q4b. What are the relevance of the following considerations in traffic signal timing design? i. Incorporating all-red interval in the inter-green period ii. Conversion of all vehicle categories to passenger car units (PCU)
A two-phase signalized intersection is designed with a cycle time of 100 s. The amber and red times for each phase are 4 s and 50 s, respectively. If the total lost time per phase due to start-up and clearance is 2 s, the effective green time of each phase is s. (in integer)
Compute the average approach delay per cycle, given the saturation flow rate of 2400 veh/h and is allocated 24 seconds of effective green in an 80-second signal cycle. Flow at the approach is 500 veh/h. Assume the traffic flow accounts for the peak 15-min period and that there is no initial queue at the start of the analysis period.
7.12 The saturation flow rate of an approach to a pretimed signal is 6000 veh/h. The signal has a 60-second cycle with 20 seconds of effective red allocated to the approach. At the beginning of an effective red (with no vehicles remaining in the queue from a previous cycle), vehicles start arriving at a rate v(t) = 0.4 +0.01t + 0.00057+² (where v(t)) is in vehicles per second and t is the number of seconds from the beginning of the cycle). 30 seconds into the cycle the arrival rate remains constant at its 30-second level and stays at that rate until the end of the cycle. What is the total vehicle delay over the cycle (in vehicle- seconds), assuming D/D/1 queuing?
10. For the intersection shown below draw a 3-phase traffic signal operation.
A turning movement count and a saturation flow study were conducted at a major intersection on an expressway with configuration as presented in Fig.1. The peak-hour volumes and saturation flows obtained from the studies for each movement are presented in Tables 1 and 2, respectively. i) provide a diagrammatic representation of the signal sequence at the intersection. Assume a yellow interval of 3s, all-red interval of 2s and a peak hour factor of 0.95 for all the approaches. Note: No two movements should conflict during the determination of the phasing plan.
Vehicles arrive at an intersection approach at 550 veh/h at the beginning of an effective red and 15 vehicles are left in the queue from the previous cycle (end of the effective green). Due to peak hour congestion, the arrival rate increases 50 veh/h/min. Therefore after 1 minute, the arrival rate will be 600 veh/h, after 2 minutes it is 650 veh/h. The saturation flow rate of the approach is 1800 veh/h, the cycle length is 65 seconds, and the effective green time is 30 seconds. Determine the total vehicle delay until complete queue clearance. (Assume D/D/1 queuing).