Design a composite pipe drain of parallel grid system to be installed, en laterals are joint a collector from each sides. A smooth concrete drain pe of (150 m) length on one side and (200 m) on the other side will be nstalled at depth of (2 m) below soil rface with slope of 0.1%, the ground ater table was found at depth of (1.2 m) and the impermeable layer was found at depth of 7m below soil rface. The hydraulic conductivity is 0.8 m/d).The irrigation losses which recharge the ground water was (40 mm) from each irrigation. Irrigation was applied once in five days. The llector is also smooth concrete pipe with slope (10%). (Assume uniform ow for both lateral and collector use B= 2.0)

Design a composite pipe drain of parallel grid system to be installed, en laterals are joint a collector from each sides. A smooth concrete drain pe of (150 m) length on one side and (200 m) on the other side will be nstalled at depth of (2 m) below soil rface with slope of 0.1%, the ground ater table was found at depth of (1.2 m) and the impermeable layer was found at depth of 7m below soil rface. The hydraulic conductivity is 0.8 m/d).The irrigation losses which recharge the ground water was (40 mm) from each irrigation. Irrigation was applied once in five days. The llector is also smooth concrete pipe with slope (10%). (Assume uniform ow for both lateral and collector use B= 2.0)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

kN 150mm 300mm Alw. O'ampressive = 5 MPa Peampressile= 5 MPa
solve the problem 11-28 please.
Why are vertical drains used with preload? a. Reduces total consolidation settlementsb. Increases consolidation speedc. Controls divergent sitting d. Prevents elastic deformations e. Decreases the percentage of consolidation
Find the question, thanx.
Q- Earthworks are very important because.. . making the soil as described in the site and that the level is considered necessary for the performance of other works making the soil as described in the drawings and that the level is considered necessary for the performance of other works making the manual drilling as described in the drawings and that the level is considered necessary for the performance of other works. Not of them
Example 5.15 A sheet pile wall drove into having silty permeability m/sec. find the quantity of soil а 7 m of 5*10-8 L. 1.75 m 1.5m seepage, pore water 1.0m 3.5 m 0.75m pressure at points (A to J), and exit gradient. 7 m M Impermeable layer
Subject water system design
If the velocity through rack at max design DWF is 0.58 m/s, and the velocity through rack at peak WWF is 0.91 m/s. The peak design WWF is 0.631 m/s and the angle(6) = 65°, B=1.82, upstream depth of wastewater = 1.12 m. Choose a 25 mm clear opening, and 10 mm width and 50 mm thick of bars. %3D Compute the total clear area (m2) through the rack. What is the number of openings?
ps. not graded, don't mind the circle
Answer in three decimal places please
The following cross-sectional areas (m2) are calculated for centre line of a drain trench at 5 m interval; 2.5 2.7 1.8 3.5 3.7 2.9 2.8 1.6 1.1 V=d[(first+last)/2)+ sum of rest cross-sectional areas] Trapezoidal formula The calculated volume in m3 of the material for the trench is: Select one: O a. 111.4 O b. 113.0 Oc 104.0 O d. 118.0 Oe. 34.2 Of None of the given answers
TW DISCHARGE the solution for this case is Select one: O A. Build a sloping apron O B. A simple concrete apron O C. A secondary dam or sill provide a satisfactory jump at high discharge and baffle piers may be used to break up the flow. D. A secondary dam or stilling pool. O E. Provide a sloping apron between the main and secondary dams. NATER LEVEL