Describe the separation techniques you would likely need to use to separate a mixture of iron fillings, styrofoam beads, sand, and magnesium sulfate given the information in the table below. Give reasons for your choices. Styrofoam beads Magnesium sulfate Iron fillings Sand Water soluble No No No Yes State of matter at 25°C Solid Solid Solid Solid Less dense than water No Yes No No

Describe the separation techniques you would likely need to use to separate a mixture of iron fillings, styrofoam beads, sand, and magnesium sulfate given the information in the table below. Give reasons for your choices. Styrofoam beads Magnesium sulfate Iron fillings Sand Water soluble No No No Yes State of matter at 25°C Solid Solid Solid Solid Less dense than water No Yes No No

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A student runs two experiments with a constant-volume "bomb" calorimeter containing 1100. g of water (see sketch at right). First, a 7.500 g tablet of benzoic acid (CH-CO₂H) is put into the "bomb" and burned completely in an excess of oxygen. (Benzoic acid is known to have a heat of combustion of 26.454 kJ/g.) The temperature of the water is observed to rise from 24.00 °C to 65.95 °C over a time of 6.6 minutes. Next, 5.060 g of ethylene (C₂H4) are put into the "bomb" and similarly completely burned in an excess of oxygen. This time the temperature of the water rises from 24.00 °C to 77.48 °C. Use this information, and any other information you need from the ALEKS Data resource, to answer the questions below about this reaction: 1 stirrer n thermometer chemical reaction "bomb" A "bomb" calorimeter. water insulation C₂H₂(g) + 30₂(g) 2CO₂(g) + 2H₂O(g) Be sure any of your answers that are calculated from measured data are rounded to the correct number of significant digits. Note for…
You are given the following data: H₂(g) 2H (g) Br₂(g) → 2 Br (g) H₂(g) + Br₂(g) 1 kJ mol → → 2 HBr (g) Calculate AH° for the reaction. H(g) + Br(g) HBr (g) Be sure your answer has the correct number of significant digits. x10 ΔΗ° = 436.4 X ΔΗ° = 192.5 ΔΗ° = - 72.4 kJ mol kJ mol kJ mol
Use the References to access important values if needed for this question. An electric heater is used to supply 41.2 J of energy to a 24.0-g graphite block with an initial temperature of 10.0 "C. Determine the final temperature of the graphite. (Specific heat of graphite = 0.72 J/g °C.) O2.38 °C 7.62 "C 173 °C OOOOO Ⓒ 12.4°C O 17.2°C
question is in the photo
9. The temperature is a critical variable that needs to be recorded when calibrating glassware. Which of the following statements is NOT true? the volume water occupies increases with increasing temperature the density of water decreases with increasing temperature the volume of glassware increases with increasing temperature due to its thermal coefficient of expansion laboratory glassware contracts 0.0010% per °C as the temperature increases near room temperature
14.0 g of cream at 20.3 °C are added to an insulated cup containing 100.0 g of coffee at 78.8 °C. Calculate the equilibrium temperature of the coffee. You may assume no heat is lost to the cup or surroundings, and that any physical properties of cream and coffee you need are the same as those of water. Be sure your answer has 3 significant digits. [°C x10 X S
Is the following chemical or physical change endothermic or exothermic? co2 + H20 + sunlight → glucose It is an endothermic chemical change It is an endothermic physical change It is an exothermic physical change It is an exothermic chemical change
895/variants/431895/take/9/ TEXT ANSWER Question 10 A calorimeter holds 50 g water at 22.0°C. A sample of hot iron is added to the water. The final temperature of the water and iron is 28.0°C. What is the change in enthalpy associated with the change in the water's temperature? Note: The specific heat of water is 4.18 g°C Use the formula AH = - cm AT Show your work. Normal A A 3x S I = = = = 外 Iロび Enter your answer here Oo00 OO of 10 Total Questions Answered All Changes Saved Continue > 11:10 AM Vordsworth, Shelle.. OEdio | Course Stude. 书 5/5/2022
Which of the following is true about an exothermic process? O An exothermic process feels hot to touch An exothermic process absorbs energy from the surroundings An exothermic reaction has products that are higher in energy than the reactants O An exothermic process feels cold to touch O More than one of these statements are true
Scenario #1- You are cooking when you burn your hand. Which would hurt more: burning your hand with 50 g of boiling water or burning your hand with 50 g of steam? Keep in mind that when burning your hand in water, the water hits your skin, and the water temperature changes from 100°C to 37°C. When burning your hand with steam, the water hits your skin, condenses, and then the water temperature changes from 100°C to 37°C. A. Determine the classification of the substances in your scenario B. Determine if characteristics described are chemical or physical. C. Give the calculations (and calculation type) used to answer the question in the scenario. Show your work.
DATA : Mass of Magnesium (g) 0.0525 g Volume of hydrogen gas (mL) 50.0 mL Temperature of hydrogen gas (°C) 25.0°C Atmospheric Pressure (mmHg) 762 mm Hg Vapor pressure of water (mmHg) Partial pressure of hydrogen (mmHg) DATA ANALYSIS