Answered: Describe the origin of shot noise in a…

Describe the origin of shot noise in a spectrophotometer. How does the relative uncertainty vary with concentration if shot noise is the major noise source?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter26: Molecular Absorption Spectrometry

Section: Chapter Questions

Problem 26.2QAP

See similar textbooks

Related questions

Q: SPECTROSCOPY 1. If the concentration of solute in a solution is high, the Absorbance will be high or…

A: #Q.1: Concentration(C) of a solution and absorbance(A) are related through Beer's law formula which…

Q: Transmitance 0.8 0.6 0.4 0.2 4000 3000 INFRARED SPECTRUM 2000 1000

A: The question is based on the concept of organic spectroscopy. We need to analyse the spectral data…

Q: % transmittance alkane 4000 2.0 1.8 3500 1.6 CH (sp³) 3000 2 (nonet) 1.4 Molecule 4 2500 2000…

A: The question is based on the concept of organic spectroscopy. We need to analyse the spectral data…

Q: A spectrophotometer method for the quantitative analysis of Pb2+ in blood uses Cu2+ as an internal…

A: given : SASIS = 0.8320.351= 2.37 CA = concentration of analyte = 1.75 CIS = concentration of…

Q: A solution containing a mixture of the compounds X and Y had an absorbance of 0.584 at 443 nm and an…

A: According to Beer Lambert's Law, A=ε.C.l where A is the absorption, ε is the molar absorptivity, C…

Q: Analysis of pure molecules either heterogenous mixture or analysis of pure molecules neither…

A: The mass spectroscopy method can be used to analyze the pure compound. X-ray crystallography method…

Q: To test a spectrophotometer’s accuracy, a solution of 60.06 ppm K2Cr2O7 is prepared and analyzed.…

A: For the given solution of potassium chromate with the concentration of 60.06 ppm, the absorbance is…

Q: Using the calibration curve y=0.146x+-0.368 find the the quantity of unknown protein that gives a…

A: The equation to the curve is given as, y = 0.146 x + (- 0.368) It is in the form of, y = mx + c,…

Concept explainers

Spectroanalytical Methods

Spectroanalytical methods measure the wavelength and intensity of radiations that are either emitted or absorbed by a molecular or atomic species. These methods are useful for evaluating the electronic or atomic arrangement of the molecules of a given analyte.

Question

Describe the origin of shot noise in a spectrophotometer. How does the relative
uncertainty vary with concentration if shot noise is the major noise source?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

A 5.3 × 10-2 M solution is to be used to prepare a series of five 100 mL solutions of varying concentration for use in creating a calibration curve for a spectrophotometric experiment. Determine the concentrations of each of the five dilutions if 10 mL aliquots of the current solution is used for V1.
A molecular exclusion column has a diameter of 7.8 mm and a length of 30 cm. The solid portion of the particles occupies 20% of the volume, the pores occupy 40%, and the volume between particles occupies 40%. (a) At what volume would totally excluded molecules be expected to emerge? (b) At what volume would the smallest molecules be expected? (c) A mixture of polymers of various molecular masses is eluted between 23 and 27 mL. What does this imply about the retention mechanism for these solutes on the column?
One method for the quantitative determination of the concentration of constituents in a sample analyzed by gas chromatography is area normalization. Here, complete elution of all the sample constituents is necessary. The area of each peak is then measured and corrected for differences in detector response to the different eluates. This correction involves dividing the area by an empirically determined correction factor. The concentration of the analyte is found from the ratio of its corrected area to the total corrected area of all peaks. For a chromatogram containing three peaks, the relative areas were found to be 16.4, 45.2 and 30.2, in order of increasing retention time. Calculate the percentage of each compound if the relative detector responses were 0.60, 0.78 and 0.88, respectively.
When opening the cover of an analytical detector, which optical elements can help us to differentiate whether the instrument is a spectrofluorometer or a UV-Vis spectrophotometer. Justify your answer:
The response of the instrument must be lincar in the sample matrix. Systematic errors can occur due to sample or standard preparation. It consists of a series of standard analyte solutions separate from the unknown. A blank is used to correct the response from the instrument. Known quantities of a standard solution of the analyte are added to the unknown. It is the method of choice when the matrix of the sample may affect the signal. Matrix effects can cause the same analyte concentration in an unknown and standard to give different responses. It is used to measure the instrument response as a function of a known analyte concentration under a set of conditions.
1. From spinach, the chromatographic analysis will yield two major substances: (a) B-carotene (C40H56), which will separate from the spinach mixture to form a yellow band, and (b) chlorophyll A (CSSH72MGN4OS), which will separate from the mixture to form a green band. i. Describe the characteristics and draw structures of these molecules. ii. From the spectrophotometric analysis, what wavelength (Amax) would you expect ß-carotene (C40H56) to absorb? What wavelength would chlorophyll A (CssH72MgN4O5) absorb?
Quantitative Analysis by External Standard Method Calcium in a juice sample is determined by atomic absorption spectrophotometry. A stock solution of calcium is prepared by dissolving 1.834 g of CaCl, 2H20 in water and diluting to 1000.0 mL. A substock calcium solution was prepared by transferring 10.00 mL of the stock to a 100.00 mL volumetric flask and diluting to the mark. Three standard solutions of calcium were prepared by transferring 2.500 mL. 5.00 mL and 10.00 mL of substock to 50.00 mL volumetric flasks and diluting to the mark. The sample is prepared by transferring 1.000 mL of fruit juice from the original bottle to a 25.00 mL flask and diluting to the mark. Strontium chloride is added to all solutions before dilution to avoid phosphate interference. Instrumental response of the standards is measured against the blank, and the following readings are recorded: 9.10, 18.6 and 37.0. The sampie reading is 28.1. Using the multipoint method, find the concentration of calcium in…
You have obtained a gas chromatogram of a two component mixture of compounds A and B. The height of peak A is 3.84 cm. and the width at half height is 1 cm. The height of peak B is 3.49 cm. and the width at half height is 1.36 cm. The percentage of a component in the mixture is proportional to peak area. Estimate peak areas by multiplying height by width at half height. What was the percentage of compound B in the mixture? (Enter your answer as a number without any percent symbol or the word percent.)
Suppose a student is preparing a set of standard solutions for use in a spectrophotometric study. If percent transmittance, %T, were measured in the standard solutions before the color had a chance to fully develop, the measured value would be compared with solutions that have allowed the color to fully develop.
A standard solution was prepared containing 10.0 ppm of an analyte and 15.0 ppm of an internal standard. Analysis of the sample gave signals for the analyte and internal standard of 0.155 and 0.233 (arbitrary units), respectively. Sufficient internal standard was added to an unknown sample to make it 15.0 ppm in the internal standard. Analysis of the unknown sample yielded signals for the analyte and internal standard of 0.274 and 0.198, respectively. Calculate the concentration of analyte in the unknown sample.
2. Peaks resulting transitions from n → TT* are shifted to shorter wavelengths (blue shift) with an increasing of solvent polarity. * True False
Given the equation of a calibration curve y=5.63x + 0.006, identify the variable that equates to the absorbance value of the Beer's law equation.