Answered: Derive the critical depth condition for…

Derive the critical depth condition for trapezoidal channels with given y and calculate the critical depth for a trapezoidal section with Q = 20+Z m 3 /s, y=2.0, b=6 m. z=53

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Using an engineer's level, the reading on a rod 80 m away was observed to be 2.84 m. The bubble was…

Q: Consider the following steady, incompressible, two-dimensional velocity field: V = (u,v)…

A: The objective of the question is to generate an analytical expression for the flow streamlines and…

Q: Compute the "b" and "d" of a trapezoidal channel if it is most efficient to convey a 6.35 cu.m./s of…

Q: Q4/ A trapezoidal open channel. Flow rate in the channel Q = 150 (m3/s), Cross -sectional area of…

A: Given: A = 100m2 P = 150m y = 5m So = 0.0001 n= 0.025 m1/3/s

Q: Q. 25. In a rectangular channel there occurs jump corresponding to F₁ = 3. Determine itical donth…

Q: SITUATION 10: A rectangular channel has a discharge equal to m3 18 The base of the channel is equal…

A: Given data: Rectangular channel. b=6m. Q= 18 m3/s n=0.012 S=0.00025

Q: Compute the "b" and "d" of a trapezoidal channel if it is most efficient to convey a 6.35 cu.m./s of…

Q: Critical depth for rectangular channels A rectangular open channel has a bottom width of 6.0 m and…

A: For a given value of specific energy, the critical depth gives the maximum discharge or we can say…

Q: A trapezoidal channel has a top width of 75 feet and a side slope of 1.5:1 (H:V). Using the given…

A: Given Data: The top width of the channel is B=75 ft. The side slope of channel is 1.5:1. The…

Q: 5. The ratio between depth and width of a rectangular channel is 4 and the area of the rectangular…

Q: For a wide open rectangular channel with a critical velocity of 6 m/s, compute the critical depth.…

Q: Find the base width and water depth of a trapezoidal channel with side slopes of 1.5 horizontal to 1…

Q: show that for a submerged hydraulic jump just downstream of a sluic gate, in a horizontal…

Q: What are differences in normal depth calculations seen comparing the rectangular and trapezoidal…

A: Solution: The normal depth for a rectangular flow section is given by: h=(nQ/bS)3/5(1+2h/b)2/5…

Q: Q3: A square gate (AB) mass (200 kg), resting on smooth bottom (B) and hinge at (A). For what water…

A: Given: Mass of the square gate AB = 200 kg A is hinged Depth of water is 'h' Depth of other liquid =…

Q: A hydraulic jump occurs in a rectangular channel having a discharge of 3.45 m^3/s of water per meter…

A: as per guidelines provided to us we are restricted to solve only 1 question if multiple question are…

Q: Q. In a rectangular channel there occurs jump corresponding to F,= 3. Determine the critical depth…

A: Given, A rectangular channel, Froude Number= 3 Find out: critical depth and head loss in terms of…

Q: critical slope for the duct

A: Given Data: The sides of the triangle = 1m x 1m x 1m Critical depth = 0.74 m Manning's co-efficient…

Q: hould be the height of the water, h, in the cut so that the stability of the saturated clay is not…

Q: A rectangular channel with a width of B = 2 m drains water with a discharge of Q = 2,4 m3/s. The…

A: Width of channel (B) = 2m Depth at upstream = 1.5m Area= 2 x 1.5 =3m2 Discharge = 2.4 m3/s Perimeter…

Q: y=2.44m, use the equivalent channel roughness formula when calculating Q

A: Manning coefficient for channel (n1) = 0.025Manning coefficient for floodway (n2) = 0.04 Determine…

Q: 5. In a rectangular channel there occurs jump corresponding to F₁ = 3. Determine critical depth and…

Q: A rectangular concrete channel (n = 0.014) has a bottom width of 12.0 m, a water depth of 6.0 m and…

A: A rectangular concrete channel-Manning's constant n=0.014,Bottom width b =12 m,Water depth d =6…

Q: Use the sketch and channel properties to complete Table 1 below.

A: Longitudinal slope S = 0.001Manning's n = 0.025When depth is 3 ftFlow area = 90 ft2 Wetted perimeter…

Q: T2. As depicted in the figure, two channels of different shape have the same cross sectional area,…

Q: An open channel is to be designed to carry 1.5 m3/s at a slope of 0.007. The channel material has an…

A: solution Given discharge Q = 1.5m3/secslope S =0.007n=0.012 for the most efficient rectangular…

Q: Derive the critical depth condition for trapezoidal channels with given y and calculate the critical…

A: Draw the trapezoidal channel. Here, y is the depth, T is the top width, and b is the bottom width…

Q: 30y Q-8:The velocity distribution v(y) in a wide channel is given by v(y) = 5.75 Vgy. S. log in…

Q: Prove that the condition that the critical depth yc=2/3E holds for non-rectangular channels?

A: Flow is said to be critical when Fr=vcgDc=1vc=gDcvc2=gDc............1

Q: A standard triangular channel is lined with fresh concrete (n=0.013) and is designed based on the…

Q: What are the limit states of a symmetric channel that has "compact" flanges and a "compact" web?…

A: A compact section is the one that is formed and casted out as a single piece of steel and not…

Q: D 1,5m OT DEPTH OM M O M 00 KN له 2,5m 2MB ilm A 5m TO TAP POINT A 3m Im

A: The problem involves finding the stress increment at a given depth under a rectangular footing. The…

Q: An concrete lined trapezoidal channel (n = 0.013) has an 6-foot wide base, slide slopes of 2.5, bed…

A: Let the normla depth be 'y'so,A=6y+2.5y2P=6+2y1+2.52so,Using mannings…

Q: Compute the "b" and "d" of a trapezoidal channel if it is most efficient to convey a 6.35 cu.m./s of…

A: Data is as given

Q: The trapezoidal channel below must supply a discharge rate of 2 x SN (m³/s). The Manning's roughness…

A: Consider the free body diagram;

Q: A rectangular channel with: n = 0.015, b=4 m, Q=5 m/sec, So=0.0008. The water depth in the channel…

Q: Q. In a rectangular channel there occurs jump corresponding to F,= 3. Determine the critical depth…

Q: 6. What is the normal depth denoted as? a) Yo b) Y,

A: To find : How is normal depth denoted.

Q: A concrete lined (n = 0.013) trapezoidal channel has a bed slope of 0.00152 and it carries a…

A: Trapezoidal channelManning coefficient (n) = 0.013Bed slope (S) = 0.00152 Discharge (Q) = 8 m3/s…

Q: Here

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Derive the critical depth condition for trapezoidal channels with given y and
calculate the critical depth for a trapezoidal section with Q = 20+Z m
3
/s, y=2.0, b=6 m.

z=53

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

9. It is known that: •Q = 18 m^ 3 /s • Rectangular channel, 3 m wide • Unfinished form concrete channel • occurs at a depth of y1 = 1 m jumpDetermine : Velocity after hydraulic jump %3D
A 45° elbow of a rectangular duct has a 12.4-centimeter throat radius. Theduct width is 20.5 centimeters.a. Find the inside arc length. a.b. Find the outside arc length.
Q-6: Show that the relation between the alternate depths in a rectangular channel is 2h; h h = %3D h, + h, where, h. = critical depth h, and h, are alternate depth
A trapezoidal open channel carries water at a depth of 2m. The canal has a bottom width of 6m and a side slope of 1.5H:1V. Using n = 0.025 and S = 0.0002, compute for C using Manning's Equation. A) 42.116 В 39.977 C) No Answer among the choices 43.811 E 41.232
The slide slope of a trapezoidal open channel are 1 horizontal to 1.75 vertical. The bottom width is 2.5 m and the depth flow is 3m. The coefficient of roughness n=0.015 and the slope of the channel bed is 0.0004. Calculate the velocity of flow using Manning's formula
A 3-m wide rectangular concrete channel has a normal depth of 1.25 m when the discharge is 8.75 m³/s. The slope of the channel is classified as: Select an answer and submit. For keyboard navigation, use the up/down arrow keys to select an answer. a b с d mild critical steep very steep
Question 12 Determine the critical depth in meters for Trapezoidal channel. Base width = 5m Side Slope 2H:3V Discharge = 180 m³/s
None
Within 30 Minutes.
A trapezoidal channel is 0.5 m deep and the top width is 1.25 m. The bottom width and side slope of the channel are not given. Please help me find the bottom width and side slope of the channel. Please see the attached drawing.