Derive an expression for the capillary height change h, as shown, for a fluid of surface tension Y and contact angle 0 between two parallel plates W apart. Evaluate h for water at 20°C if W = 0.5 mm.

Q: Problem 5: Hydrostatic Pressure Consider the swimming pool light fixture shown below. It has a…

A: Given data,D=Dia=15cm=0.15mR=radius=mz=depth=2.5mFINDvertical hydrostatic force (N)

Q: Problem # 1 Determine the natural frequency of the beam-spring system shown below consisting of a…

A: NOTE : As per guidelines, first question is solved. Request you to post remaining question…

Q: Water GLYCERIN, SG = 1.26 Pipe 30mm 3mm

A:

Q: n Figure 2 the plan view and elevation view (sideview) of an air-liquid tank is shown. The specific…

A: Solution: considering the above elevation view: Pressure at A: Patm=PAPressure at B:…

Q: Determine the maximum height (y) to which the jet will rise above the orifice. 1.5m

A: Given-A jet which is issued from the side of a tank with its side inclined at 1H:1V Required-…

Q: The radius of the tube shown as shown in the figure is 1 mm. The surface tension of water at 20°C is…

A: To determine: capillary rise in given tube total force due to surface tension weight of water above…

Q: A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.