dense silt has the following properties: void ratio = 0.64, specific gravity = 2.5. Free ground water = 10.23m below the ground. Capillary action rise will reach 5.6m. The soil above the capillary action rise is dry while within the zone, it is saturated at 51.53%. Determine the effective pressure (in kPa) at a depth of 7.42m from the ground surface.

dense silt has the following properties: void ratio = 0.64, specific gravity = 2.5. Free ground water = 10.23m below the ground. Capillary action rise will reach 5.6m. The soil above the capillary action rise is dry while within the zone, it is saturated at 51.53%. Determine the effective pressure (in kPa) at a depth of 7.42m from the ground surface.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Qsn. A soil mass has kx=8*10-7cm/s and ky=4*10-7cm/s. The effective permeability of the soil is ______ 5.6*10-7cm/s 6.6*10-7cm/s 4.6*10-7cm/s
A 3 m thick soil has coefficient of permeability 3 x10^-7 m/s. A separate test porosity 40% and bulk unit weight 21 kN/m^3 at a moisture content of 31%. Determine the head at which upward seepage will cause quick condition? a. 1.034 m b. 2.724 m c. 3.1 m d. 6.12 m
A uniform soil deposit has a void ratio of 0.6 and specific gravity of 2.65. The natural ground water is at 2.5m below natural ground level. The average degree of saturation above ground water table is 50%. What is the effective pressure at 1.0 m depth?
The soil profile at a site consists of a 2.0 m thick sand layerat the top, underlain by a 3.0 m thick clay layer. The watertable lies at a depth of 1.0 m below the ground level. Thebulk and saturated unit weights of the sand are 16.0 kN/m3and 19.0 kN/m3, respectively. The properties of the clay are:water content = 45.0%, specific gravity of the soil grains =2.70, compression index = 0.65, swelling index = 0.08, andoverconsolidation ratio = 1.5.a. The ground level is raised by placing a 1.5 m high compactedfill with unit weight of 20.0 kN/m3. What is theconsolidation settlement?b. When the consolidation due to the fill is completed,it is proposed to construct a warehouse imposing a uniform pressure of 40.0 kN/m2. What would be theconsolidation settlement due to the construction of thewarehouse?
A dense silt layer has the following properties: e =0.406 D10= 10.1 um Capillary constant = 0.209 sq.cm Free ground water level is 8m below the ground surface. 1.) Find the height of capillary rise in the siltin meters. 2) Find the vertical effective stress at 6m depth. Assume ys = 26.51 kn/m3 and the soil above capillary action rise and ground surface is partially saturated at 79%.
4- A 22 ft clay layer in the field (drained on one side) is normally consolidated. When the pressure is increased from 1,000 lb/f? to 3,000o 1b/ft?, the void ratio decreases from 0.9 to 0.75. The hydraulic conductivity, k, of the clay for the above loading range was found to be 2.4 x 10 in'sec. a) How long (in days) will it take for the clay layer to reach 50% consolidation? b) What is the settlement at that time (that is, at 50% consolidation)?
A soil has the following profile with depth (sand layer over clay layer): z = 0-5 ft, Yt= 110 pcf; z = 5-40 ft, Y = 119 pcf. The water table is at a depth of 5 ft. Note: for sand layer (0-5 ft), w = 5.5%, G, = 2.65; K, = 0.30; for clay layer (5-40 ft), PI = 42%, S = 100%; K. = 0.67. The horizontal effective stress at 22 ft into the clay layer is (ignore capillary pressures in the sand) is most nearly %3D %3D
A 3m deep sand layer has a specific gravity of 2.68 and a void ratio of O.60. Under this layer is a 2.5m deep clay profile with a specific gravity of 2.7 and a moisture content of 30%. The water table is observed at 1m below the ground surface. Determine the effective soil pressure at the midweight of clay.
A dense silt layer has the following properties: void ratio = 0.75, specific gravity = 2.59. Free ground water is 9.49 m. below the ground. Capillary action rise will reach 6.69 meters. The soil above capilary action rise is dry while within the zone, it is saturated at 50.02%. Determine the effective pressure (in kPa) at a depth of 7.51 meters from the ground surface. Round off to three decimal places. Selected Answer: 128.657
Question 32 A dense silt layer has the following properties: void ratio = 0.66, specific gravity = 2.5. Free ground water is 9.47 m. below the ground. Capillary action rise will reach 6.66 meters. The soil above capilary action rise is dry while within the zone, it is saturated at 52.77%. Determine the effective pressure (in kPa) at a depth of 7.42 meters from the ground surface. Round off to three decimal places.