d. What are the line currents (laa, IbB, lec)? e. What real, reactive and apparent power does the generator supply when the switch is closed? f. What are the line currents when the switch is closed? g. Determine the value of each capacitor when a Y-connected capacitor bank is to be connected in parallel with the loads to raise the PF to 0.95.

d. What are the line currents (laa, IbB, lec)? e. What real, reactive and apparent power does the generator supply when the switch is closed? f. What are the line currents when the switch is closed? g. Determine the value of each capacitor when a Y-connected capacitor bank is to be connected in parallel with the loads to raise the PF to 0.95.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --
Quèstion 7 A shunt generator running at 1000 r.p.m. has generated e.m.f. as 300 V. If the speed increases to 1200 r.p.m., the generated e.m.f. will be nearly 300 480 420 360 A Movinn to another ouestion will caro thic roenonco P Type here to search O O O O
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
The type generator field winding is supplied from the external D.C. source. O Compound Self excited O Shunt separately excited
Question#5 Figure below shows a simple single-phase AC power system with three loads. The voltage source is V = 240 < o°v and the impedances of these three loads are z, = 10 < 30°n Z2 = 10 < 45°0 Z3 = 10 < -90°n z,
A synchronous generator having ratings of 100 MVA operates on a full load at a frequency of 50 Hz. The load suddenly reduced to 60 MVA. The steam valve begins to close after 0.7 second due to time lag in the governor system. What would be the change in frequency that occurs in this time. Use generator capacity of H = 4 kW-s/kVA. Answer Choices: a. 1.72 Hz b. 1.02 Hz c. 1 Hz d. 0.72 Hz
What is reactive power, and how does it affect the efficiency and stability of an electrical grid?
A synchronous generator runs at 250 rpm and generators at 60HZ. There are 240 slots each containing 5 conductors arranged in full-pitched winding for three-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load distributed sinusoidally over the pole pitch is 2.5 x106 Maxwell. What is the emf induced in each winding and the terminal voltage?
A generator at no-load operates 61 Hz, slope 1MW/Hz. Load 1= 1.0 MW and load 2=0.8MW are connected. Find the frequency before and after adding the load 2. (Using House Diagram)A. 60 Hz & 59 Hz C. 60 Hz & 59.2 HzB. 60 Hz & 59.1 Hz D. 60 Hz & 59.3 Hz
The winding data for three different alternators are as follows I. 60 slots, four poles, span 1 to 9 II. 120 slots, six poles, span 1 to 16 III. 144 slots, eight poles, span 1 to 11 The windings having a pitch factor less than 0.9 are a. II and III only b. I and II only c. I, II and III. d. I and III only
What will be the value of the twiddle factor: W42