(d) What are major mineral components in sedimentary rocks?
Q: Are the stress-strain curves shown true stress-strain or engineering stress-strain curves?
A: To classify the shown stress-strain diagrams as true of engineering stress-strain curves. In an…
Q: Why do crystal formations create grains?
A: Introduction: A collection of crystals oriented in the same direction. The proliferation of tiny…
Q: ) Describe bonding and structure in clay minerals and name groups and specific minerals. 2) Draw…
A: Solution: 1. Clay is considered to be one of the fine-grained materials found in the stomach of the…
Q: Which one is a rock-forming mineral (calcite, diamond, coal, garnet)?
A: Calcite: It is a rock forming mineral its chemical formula is CaCo3 (calcium carbonate ) It is…
Q: Name two minerals in your set that have two directions of cleavage at right angles, and the third…
A: Plagioclase and potassium feldspar are two feldspar minerals with cleavage planes that are at an…
Q: is one of the basic and most popular units of clay minerals. .......... Select one: a. Alumina…
A: Given unit of the clay mineral
Q: Does water affect the bonding of particles of soil? Explain your answer.
A: Yes water do affect the bonding of particles of soil. Water breakers the bond between the particles…
Q: What is the significance of stress concentration factor? What are the factors that influence…
A:
Q: What the primary structures in sedimentary rocks.
A: We have to asked Primary structure in sedimentary rocks, Sedimentary rocks are those rocks ch are…
Q: what is the cone of distribution, explain why stiffer materials are placed closer to the surface
A: Required: To explain what is cone of distribution and reason why stiffer materials are placed closer…
Q: Give five reasons why the study of clay minerals is of importance. State six uses of kaolinite
A: Study of clay minerals is important because 1.It provides the structure of the minerals. 2.It…
Q: xplain the need to preserve aseful solid materials in the environment for life
A: For resource conservation, economic stability, environmental protection, climate change mitigation,…
Q: What are the two principal steps needed to convert an igneous rock into a sedimentary rock?
A: Igneous rocks are formed when the magma cools and solidifies either at the surface of earth or…
Q: A liquid compressed in a cylinder has a volume of 1000 cm³ at 1 MN/m² and a volume of 995 cm³ at 2…
A: A liquid compressed in a cylinder has volume, V1= 1000 cc At, P1= 1 MN/m2 V2 = 995 cc At, P2= 2…
Q: Briefly describe the physico-chemical parameters that control the ductile and brittle behavior of…
A: The physico-chemical parameters that control the ductile and brittle behavior of rocks under stress…
Q: List one common rock-forming minerals and give at least three uses of the mineral.
A: There are many rock-forming minerals that are used as an important tool in classifying rocks One of…
Q: F = Pe" %3D Engineering Economy's Formula Find n:
A:
Q: Discuss how to determine the basic material properties of a material sample based on its…
A: Explanation- The fundamental material characteristics of a material sample as determined by its…
Q: What shear force is required to deform the oil at a strain rate of 7000/sec?
A:
Q: True or False: "Shields" are very old rocks that make up the granitic core of the continents. True…
A:
Q: List the 10 minerals in the Moh’s hardness scale, from the softest one to the hardest one.
A: Moh's Hardness Scale : The most important test which identifies mineral specimens is the Mohs…
Q: When . is subjected to sufficient pressure, the minerals in it move in the same direction, forming…
A: Gneiss Rock is the rock that has formed by the metamorphosis of sedimentary or igneous such as…
Q: According to the definition of minerals, point out which one is a mineral among the following ones…
A: Amoung the following given above which one is a mineral.
Q: Which of the following types of deformation results in rock folds? a. Ductile Deformation b.…
A: Ductility- It may be defined as the property of materials that plastically deformed without the…
Q: Void ratio e = 0.78 Water content w = 12% %3D Specific gravity G, = 2.68 %3D
A:
Q: The other term for rock stresses
A: In general, the stresses lead to deformation that is the internal resistive force is stress.
Q: Darcy's law theme Why is it not possible to measure the geometry of a natural porous medium?
A: The Darcy Law describes the flow of liquid through the porous medium. It describes the ability of…
Q: If you rub plagioclase and calcite together, which mineral will be scratched by the other? Why?
A: Given, Plagioclase and calcite rubbed together To find : Which material will be scratched and by…
Q: Air water solids Total Volume Void vatio = 0.89 W.C. = 7%. = 3 5.74 m ³ gravity of solids= solids =…
A: Given data in questionTotal volume 5.74 m3Void ratio 0.89Water content 7%Specific gravity 2.47To…
Q: Enumerate the factors affecting the rate of deposition on metals.
A: There are some factors affecting the rate of deposition on metal and they are :- 1) Current…
Q: hear Stress
A:
Q: Sedimentary rocks are the oldest rocks on earth and they represent the origin for the other two…
A: the answer is false
Q: A liquid compressed in a cylinder has a volume of 1000 cm³ at 2MN/m² and a volume of 993 cm³ at 3.3…
A: Given: A Liquid compressed in cylinder has, Volume of 1000 cm3 at 2 MN/m2 Volume of 993 cm3 at 3.3…
Q: Cite some practical importance of determining water hardness in the industry
A: It has been asked in the question to list why we determine hardness in the factories.
Q: Water and ______ from the atmosphere form _______ , which reacts with the existing rock minerals to…
A: the process of formation of the soil is referred as pedogentsis. soil is formed due to the…
Q: describe the changes that rocks undergo at and near the Earth’ssurface due to weathering.
A: The role of a Risk Manager is to communicate risk policies and processes for an organisation. They…
Q: Draw a graphical relationship between the diameter of the impact and the hardness of Vickers
A: it depends on the temperature so we draw it for 3 different temperatures, lets say 500, 600, 700…
Q: A stone weight W 575N in air , when submerged in water, the stone lost 40% of its weights a-What is…
A:
Step by step
Solved in 2 steps