d water are at 25.6 °C. To make a cup of coffee, a small electric heater is immersed in the water and brings it to a boil in two minutes. sume that the cup and water always have the same temperature and determine the minimum power rating of this heater. umber Units

d water are at 25.6 °C. To make a cup of coffee, a small electric heater is immersed in the water and brings it to a boil in two minutes. sume that the cup and water always have the same temperature and determine the minimum power rating of this heater. umber Units

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: A small vegetable shop use the following electric appliances: (1) Two Air Conditioner of rating 2200…

A: Energy is the ability to perform work. Energy can neither be created nor destroyed, and it can only…

Q: 7. Determine the work done

A: Work Done-When energy transfer from one form to another it termed as work…

Q: Refer to the figure below. A toroid consists of a ring having an inner radius a=2cm and outer radius…

Q: A heat pump takes in 440J of heat from a low temp reservoir in each cycle and uses 200J of work to…

Q: A domestic refrigerator sits in a kitchen, switched on, with the refrigerator door wide open. The…

A: To determine the correct statement regarding the situation. Given:The kitchen is an insulated system…

Q: A heat pump has a coefficient of performance of 3.1. Hint If it requires 290 J of work per…

Q: It is found that an engine discharges 50 J while absorbing 85 J each cycle of operation. Hint a.…

A: Detailed solution of given question is given in below steps.

Q: Analyze the given situation and determine what happens to the entropy of the area or system. Choose…

A: Situation : Arranging beddings after the sleeping To find : the effect on entropy of the area or…

Q: all electric immersion heater is used to heat 85 g of water for a cup of instant coffee. The heater…

Q: Which of the following equations is a mathematical statement of the Joule's Law of Resistive…

A: The joules law of resistive heating states that when a current I pass conductor for certain period…

Q: How much energy is required to heat 50 gallons of water from 20C to 130F? Note the unit change.…

A: The required expression for the energy is,

Q: 1. A heat engine is found to have an efficiency of 0.3. If it does 180 J of work per cycle, what are…

Q: Find the average specific heat of the liquid in this temperature range. Assume that negligible heat…

Q: e-Services Academic Departments ETC - CIMS - A stationery shop use the following electric…

A: Energy = Power × time 1 KW = 1000 W

Q: For the process shown in the figure below, answer questions 7, 8, and 9 when the system consist of…

Q: A- The voltage a cross the terminals of a certain machine is 220 <30 V whereas the current which is…

Q: When air enters the insulated duct depicted in the following figure, it is at 65 °F and 1.2 atm of…

A: Introduction:-Air enters the insulated duct.Given:- Pressure Pressure Temperature Temperature…

Q: Your response differs significantly from the correct answer. Rework your solution from the beginning…

A: According to Kirchhoff's first law Algebraic sum of current at a junction is always zero. According…

Q: You want to heat your oven to 400°F. Given that your oven has a surface area of 1m2, about how much…

A: Given Surface area of oven(A)= 1 m2 Temperature of oven (T) = 400°F We want to calculate power…

Q: RQuestion 3 of 4 Question 3 Note: Round off your answer to the nearest whole number. Input the…

Q: How long does a 56 kW water heater take to raise the temperature of 170L of water from 22°C to 37°C?…

Q: QUESTION 38 This image depicts homeostatic regulation of temperature and the output signals control…

A: Given : An image of homeostatic regulation of temperature and the output signals control a heating…

Q: A heat engine with an efficiency of 30% takes in 800 J of heat from the high-temperature reservoir…

A: Given: The efficiency of the heat engine is 30%. The heat input to the engine is 800 J.

Q: How long does a 69 kW water heater take to raise the temperature of 110 Lof water from 24°C to 37°C?…

Q: (290 = 9.Skw = 50 हु 290KAM - lookpa 1000 ma

A: The given expression with the units is 50kgs290kPa-100kPa1000kgm3 Pa or Pascals is the unit of…

Q: Answer below questions for a heat pump that puts in 80 J of heat into the hot reservoir per cycle…

A: Given data, Heat given to the hot reservoir (QH)=80 J Coefficient of performance (n)=4

Q: cylindrical resistors R1 and R2 made from the same material are connected in parallel in a…

A: Resistance =ρl/A

Q: I do not understand in what form the answer is supposed to be in

A: The given vector C is

Q: Q2. In the figure below, obtain the values of x and r such that Va is zero for the (positive…

Q: An engine releases 0.450 kJ of heat for every 0.510 kJ of work it does. What is the efficiency of…

A: heat released Q2=0.450kJwork done by engine W=0.510kJ

Q: A small vegetable shop use the following electric appliances: (1) Two Air Conditioner of rating 1800…

A: (i) Rating of n=2 air conditioners P=1800 W=1.8 kW for t=10 h. (ii) Rating of n=2 heaters P=500…

Q: i. Appraise the development of a solar powered TV set in the context of thermodynamics ii.…

Q: Two cylindrical resistors Ri and R2 made from the same material are connected in parallel in a…

Q: A Nichrome heater dissipates 517 W when the applied potential difference is 110 V and the wire…

A: The initial power dissipation is given as, Po=517 W The applied potential difference is given as,…

Q: A heat pump has a coefficient of performance of 2.2 in heating mode. If it requires 140 J of work…

Q: The efficiency of a gas turbine is much larger than that of a steam turbine since Question 2…

A: INTRODUCTION:- Gas-Turbine: The gas turbine has grow to be an vital, big, and dependable device…

Q: Question 1 a) In Figure Q1(a), RT represents a resistance temperature device (RTD), whose…

A: Given equation for resistance at a temperature T is RT=R0(1+αT). R0=100 Ωα=0.0039 °C-1T=100 °C…

Q: A refrigerator (located in a 22°C kitchen) removes heat from the cold compartment (at 3.4°C) at a…

A: Given data: Higher temperature, TH=220C=22+273 K=295 K Lower temperature, TL=3.40C=3.4+273 K=276.4 K…

Q: Resis Resistivity nu Temper You are planning a circuit where you need a resistor that can work withi…

A: The resistance of the resistor is given by where please note here temperature taken is 11 only ,…

Q: A small electric immersion heater is used to heat 56 g of water for a cup of instant coffee. The…

A: Given, mass of water , m = 56 g = 0.056 kg change in temperature , ΔT = 100°C - 24°C = 76°C = 76 K…

Q: A certain coal-fired power plant has a rated power capacity of P = 850 MW. The output of this plant…

A: Given that :- Power capacity , P=850 MW Output , W=0.26Q11

Q: An engine has a hot-reservoir temperature of 900 K and a cold-reservoir temperature of 600 K. The…

A: We are given a heat engine. This heat engine is not Carnot engine. We are given the efficiency of…

Q: A heat engine with an efficiency of 0.45 absorbs 540 J of heat per cycle. a. How much work does it…

Q: Which of the following statements are correct about different unit combinations? There is more than…

A: Below are the correct answers.

Q: How long does a 55 kW water heater take to raise the temperature of 100 L of water from 18°C to…

Q: 18. A perfect engine would have On the other hand, a perfect refrigerator would need which would…

A: The fill in the blanks. A perfect engine would have ......................., which would lead to an…

Question

100%

**Problem Statement:**

A 0.288-kg coffee mug is made from a material that has a specific heat capacity of 930 J/kg°C and contains 0.319 kg of water. The cup and water are at 25.6°C. To make a cup of coffee, a small electric heater is immersed in the water and brings it to a boil in two minutes. Assume that the cup and water always have the same temperature and determine the minimum power rating of this heater.

**Input Required:**

- Number: [Input field]
- Units: [Dropdown menu for units selection]

**Explanation:**

The task involves calculating the minimum power rating of an electric heater that raises the temperature of water and a coffee mug to boiling point within a specified time.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Write the given values

VIEW

Step 2: Calculate the required value

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

1.0x1016 electrons flow through a cross section of silver wire in 300 μs with a drift speed of 7.2x10-4 m/s. Part A What is the diameter of the wire? Express your answer to two significant figures and include the appropriate units. D= Submit ΜΑ Value Request Answer Units ?
Which of the following quantities do not have direct-proportional relationship with the heat current by conduction? length of the conductor O none of the above cross-sectional area of the conductor O temperature difference between hot and cold region
A waterbed heater uses 440 W of power. It is on 35% of the time, off 65 %. Part A What is the annual cost of electricity at a billing rate of $0.12 per kWhr? Express your answer in dollars. B VEL ΑΣΦ ? cost= dollars Submit Previous Answers Request Answer X Incorrect; Try Again; 5 attempts remaining t
Assume that Q₁ = -15.0 J and Q2 = -80.0 J in (Figure 1). For help with math skills, you may want to review: Substituting Numbers into Mathematical Expressions For general problem-solving tips and strategies for this topic, you may want to view a Video Tutor Solution of Heat engine details. Figure p (kPa) 400 200 0- 0 100 200 22 1 of 1 - V (cm³) Part B What is QH for the heat engine shown in the figure? Express your answer with the appropriate units. QH = 125 J Submit Part C Correct n = Previous Answers What is the thermal efficiency for the heat engine shown in the figure? Submit - ΑΣΦ Request Answer ?
3) Consider a system consisting of one particle with two states, one of energy 0 and one of energy +ɛ. a) Write down the partition function Z for this system. b) Show that the average energy for this system can be written as
answer please vvv
if the heat capacitance for a Container of Aluminum is 270 J/Co and the specific tempreture of Aluminum is 900 J/kg.Co , find the Container mass
A heat engine provides a net power output of 14 kW and has an efficiency of 23 %. The engine rejects 1200 J of energy per cycle to a low temperature reservoir. a)Determine the amount of heat delivered to the engine from the high temperature reservoir per second. Your answer should be in units of Watts. b)Determine the required number of cycles per minute executed.
Please state if each question is True or False; if False, please explain why
8
When the first law of thermodynamics is applied to a system, the Q and Wstand for what? Select one: A. the heat flow into the system and the work on the system. O B. the heat flow out of the system and work done on the system. C. the heat flow into the system and the work done by the system O D. the heat flow out of the system and the work done by the system.
In1816, Robert Stirling, a Scottish clergyman , patented the Stirling engine which has found a wide variety of applications ever since, including current use in solar energy collectors to transform sunlight into electricity. Fuel is burned externally to warm one of the engine's two cylinders, A fixed quantity of inert gas moves cyclically between the cylinders, expanding in the hot one and contracting in the cold one. Figure P21.33 represents a model for its thermodynamic cycle. Consider n moles of an ideal monoatomic gas being taken once through the cycle, consisting of two isothermal processes at temperatures 3Tiand Ti and two constant-volume processes. Let us find the efficiency of this engine .(a) Find the energy transferred by heat into gas during the isovolumetric process AB. (b) Find the energy transferred by heat into the gas during the isothermal process BC. (c) Find the energy transferred by heat into the gas during isovolumetric process CD. (d) Find the enrgy transferred by…