Current Attempt in ProgressThe hydraulic oil in a car lift has a density of 8.19 x 102 kg/m³. The weight of the input piston is negligible. The radii of the input pistonand output plunger are 5.87 x 10-3 m and 0.114 m, respectively. What input force F is needed to support the 24300-N combinedweight of a car and the output plunger, when (a) the bottom surfaces of the piston and plunger are at the same level, and (b) the bottomsurface of the output plunger is 1.40 m above that of the input plunger?(a) Number i(b) NumberUnitsUnits

Answered: Image /qna-images/answer/36a7795e-aeef-4a1d-ac23-3957da69cc86.jpg

Answered: Current Attempt in Progress The…

Similar questions

A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of different radii, 1 = 0.0480 m and r2 = 0.300 m, respectively. (a) If a downward force of F1 = 16.0 N is applied to the end with the smaller radius, how much force F2 would the jack exert on a car if it were sitting above the other end? (Enter the magnitude.) ]N (b) If the smaller piston is pushed down a distance d, = 0.176 m, through what distance d, would the other end move? m
Two circular platforms are attached to a fluid reservoir. On one platform rests the entire cast of Glee frozen in carbonite. A force of 7.0 N is applied downward to the empty platform with radius 8.0 m. The other platform applies a force of 7.2 N to the carbonite-frozen pop-idols. What is the radius of the platform holding the Glee cast?
The L-shaped tank shown in the figure is filled with water and is open at the top. If d = 5.35 m, what is the total force exerted by the water (a) on face A and (b) on face B? 3d (a) Number (b) Number d d 2d i d 2d d B Units Units <
A boat displaces 5.76 m3 of water when if floats on the surface of a lake. What is the magnitude of the buoyant force acting on the boat? (The density of water is 1000kg/m3)
Hi I need help with this question: Logs sometimes float vertically in a lake because one end has become water-logged and denser than the other. What is the average density (in kg/m3) of a uniform-diameter log that floats with 28.0% of its length above water?
A vat contains a mixture of oil and water. The water forms a lower layer which is 0.8 m deep, and above it there is an oil layer 0.3 m thick. The density of water is 1000 kg/m3, and the density of oil is 800 kg/m3. Find the force on a flat door at the bottom of the vessel that has a cross-sectional area of 0.5 m2. The acceleration due to gravity is 9.81 m/s2.
If this diver has a mass of 150 kg ( including his diver gear), and a total volume of 0.14 m3 , How much force is provided by the bottom of the swimming pool on which he is sitting?
A 80 kg person stands on snowshoes. If the total area of the 2 snowshoes is 0.34 m2 , what is the pressure on the snow? Use g = 9.8 m/s2 Calculate answer to two decimals.