correction factor or CF (show the actual plotting of CF on temp-correction chart) b)    true LMTD

Q: A counterflow, concentric tube heat exchanger is used to cool the lubricating oil for a large…

A:

Q: Hot water (Cp= 4.188 kJ/kg.K) with mass flow rate of 2.5 kg/s at 100 C enters a thin-walled…

A: specific heat of hot waterCph=4.188kJ/kg-Kmass flow rate of hot waterm˙h=2.5kg/sInlet temperature of…

Q: Hot water flowing at 0.015 m3/min enters the tube side of a counter current shell & tube heat…

A: Given data: Hot water flowing at m˙w= 0.015 m3/min enters the tube side of a counter current shell…

Q: Q4) Consider a tube-and-shell heat exchanger consisting of one single shell and one tube, each…

A: A counter-flow exchanger, the temperature difference between the hot and cold fluids remains high…

Q: Consider a water-to-water counterflow heat exchanger with these specifications. Hot water enters at…

A: Given data:- Overall heat transfer coefficient ×Surface area (UA)=2200W/K ∆Tm=32.374 °C To…

Q: A shell-and-tube heat exchanger must heat 2.8 kg/s of a solution with a specific heat of 3.25…

A: Mass flow rate of the solution→m=2.8 Kg/s Specific heat of the solution→Cp=3.25 KJ/KgK Initial…

Q: A shell-and-tube heat exchanger has one shell pass and two tube passes. Oil (cp 2100 J/kg C) heats…

A: A shell and tube heat exchanger is made up of a series of tubes enclosed in a cylindrical container…

Q: Determine the maximum heat transfer that can happen during the heat exchange process? Take specific…

A:

Q: Water enters a body-tube heat exchanger as a hot fluid at a flow rate of 2.6 kg/s at 68 °C. The cold…

A: Calculate the heat transfer rateSince the heat exchanger efficiency is known as 0.55,…

Q: A two shell, eight tube pass STHE is to heat mineral oil from -5°C to 40°C using water with an inlet…

A: According to the data  number if the sell = n = 2  Number of the tube nt = 8  total tubes N=8x2 =16…

Q: FAUIO HEATER MEATS 2 S0 kg PER SECEND OF ELUID PRoM 35°C 100't IN A PARALLEL PLow HEAT EXCHANGERHE…

A: As given that For fluid heater :- mass of fluid (mf)= 250 Kg/s , Tc1=35°C=308 K ,Tc2=100°C=373 K,…

Q: A counterflow, concentric tube heat exchanger is used to cool the lubricating oil for a large…

A:

Q: An engineer designed a double pipe heat exchanger where the hot fluid (c,=2400 J/kg.K) enters at a…

A:

Q: i. If you increase the length of the tube, will the overall heat transfer coefficient U change?…

A: A heat exchanger typically involves two fluids separated by a solid wall. Heat is first transferred…

Q: 4. Hot oil (cp= 2.5 kJ/kg-K) at 125 C with a flow rate of 97 kg/min is used in a shell-and-tube heat…

A:

Q: 3. A one-shell pass and two-tube passes heat exchanger cools 1.8 L/s of oil (cp = 2.5 kJ/kg-K and…

A:

Q: - In a heat exchanger, steam of 0.08 bar and a specific steam content of 95% is condensed. 381.6…

A: a.

Q: A counterflow double-tube heat exchanger with hot engine oil fluid at inlet and outlet temperatures…

A:

Q: A cold liquid enters a counter flow heat exchanger at 15 deg at a rate of 8 kg/s. A hot stream of…

A: Given, Inlet temperature of cold fluid = Tc1 = 15 oC Mass flow rate of cold fluid = mc = 8 kg/s…

Q: I. A Carnot heat engine receive 1700 kJ of heat per cycle from a high-temperature reservoir at 500…

A: Given: Heat received by the carnot engine QH=1700kJUpper temperature limit of the carnot cycle…

Q: A shell-and-tube heat exchanger with 2- shell passes and 12-tube passes is used to heat water (Cp =…

A:

Q: A single-pass, cross-flow heat exchanger uses hot exhaust gases (mixed) to heat water (unmixed) from…

A:

Q: 1. A two shell, eight tube pass STHE is to heat mineral oil from -5°C to 40°C using water with an…

A:

Q: (a) Draw complete schematic diagram of this heat exchanger. Calculate the rate of heat transfer and…

A: Heat exchangers with counterflows use flows that are in the opposite direction of each other. Heat…

Q: A counterflow concentric tube heat exchanger is used to cool the lubricating oil from a large gas…

A:

Q: In a heat exchanger, water (Cp = 4200 j/kg.K ) is heated from 15 0 C to 350 C by a hot oil which has…

A:

Q: For a 1 shell, 30 tube heat exchanger, the inlet temperature of the shell is 8 C and the outlet…

A: The overall heat transferred by the heat exchanger can be calculated using the formula given below…

Q: A finned-tube heat exchanger is used as an air-conditioning condenser. During a steady state…

A: The condensing temperature is Tc=67°C. The inlet temperature of air is Ti=22°C. The mass flow rate…

Q: As shown in Figure 1, one portion of the hot flue gases is supplied to the steam generator. The…

A: Evaluate properties of flowing fluids.Steam outlet:At outlet, steam pressure is  and temperature is…

Q: A heat exchanger is heating water on the tube side with steam condensing on the shell side.  The…

A:

Q: A shell and tube heat exchanger is designed as a counter flow type. Water (cp = 4182 J/kg.o C)enters…

A:

Q: At the rate of 5,000 lbm/min, water is heated from 100 to 130-F in a shell-and-tube heat exchanger.…

A: Given: Mass flow rate, m˙1=500 lbm/min, 5000 lbm/min is physically impossible for the given…

Q: gas from a power plant contains noxious vapors that must be condensed by lowering its temperature…

A: Given that ,  Thi=initial temp of gas =315°C=588KTci=initial temp of water…

Q: Hot water enters at 46 ° C and leaves at 37 ° C, and cold water enters with 19 ° C to a well…

A: Given data: The inlet hot water temperature, Th,i = 46oC. The outlet hot water temperature, Th,o =…

Q: 500 Liter / hour flow rate and 3.7 ° C cold water is heated up to 30 ° C by using a counter flow…

A:

Q: At the rate of 5,000 lbm/min, water is heated from 100 to 130-F in a shell-and-tube heat exchanger.…

A: Total heat transfer

Q: Water at the rate of 86 kg/min is heated from 20 to 70-C by an oil having a specific heat of 1.9…

A:

Q: A heat exchanger is being investigated as a waste heat recovery device. A heat exchanger is common…

A: Given data as per questionTemperature of cold fluid at entrance = 294.2kTemperature of device =…

Q: 500 Liter / hour flow rate and 3.7 ° C cold water is heated up to 30 ° C by using a counter flow…

A:

Q: Required information Consider a water-to-water counterflow heat exchanger with these specifications.…

A:

Basic Thermodynamic Processes

The word 'thermodynamics' can be divided into two words, 'thermo' and 'dynamics'. The word thermo deals with the heat and thermal phenomenon, whereas dynamics deals with forces or external agent that drives the heat flow or aids in the motion of heat.