Constant head permeability tests were performedon two soil specimens, S1 and S2. The ratio ofheight of the two specimens (Ls1: Ls2) is 1.5, theratio of the diameter of specimens (Ds:Ds2) is0.5. and the ratio of the constant head (h:h)applied on the specimens is 2.0. If the dischargefrom both the specimens is equal, the ratio of thepermeability of the soil specimens (k,:k2)S1's1is

Answered: Image /qna-images/answer/00c63165-0a7a-4610-8fd8-0ce5357b85b9.jpg

Constant head permeability tests were PENUI height of the two specimens (Ls1: Ls2) is 1.5, the ratio of the diameter of specimens (Ds:Ds) is 0.5, and the ratio of the constant head (h.:h) applied on the specimens is 2.0. If the discharge from both the specimens is equal, the ratio of the permeability of the soil specimens (kk) S1 is

Constant head permeability tests were PENUI height of the two specimens (Ls1: Ls2) is 1.5, the ratio of the diameter of specimens (Ds:Ds) is 0.5, and the ratio of the constant head (h.:h) applied on the specimens is 2.0. If the discharge from both the specimens is equal, the ratio of the permeability of the soil specimens (kk) S1 is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1.4 A soil specimen is 38 mm in diameter and 76 mm long and in its natural con- dition weighs 168.0 g. When dried completely in an oven the specimen weighs 130.5 g. The value of G, is 2.73. What is the degree of saturation of the specimen?
In a constant head permeability test in the laboratory as shown in Figure Q2(e), the data is recorded in Table Q2(b). The void ratio of the soil specimen is 0.46. Determine; (i) Hydraulic conductivity, k, of the soil in cm/sec. (ii) Discharge velocity in cm/sec.
During Atterberg limit tessts in the Naboratory,the studens obtained the following results froma clayey soil. Wumber of Blows (N) Molsture Content \ 38/4 16 36/5 20 33.1 28 2/7 0 Plastic limit tests: Students conducted two trials and found that PL= 17 2% for the first trial and PL = 18.4% for the second trial. Assume that the liquid limit of the soil iS LL= 29.0% a. Determine the flow index. b. Determine the liquidity index of the soil if the in situ moisture content is 22.0%.
The coefficient of permeability of fine sand is 0.012 cm/sec at a voids ratio of 0.57. Estimate the increased permeability using the Kozeny-Carman formula of this same sand when its voids ratio has increased to 0.72.
A sample of sand is subjected to a constant head permeability test. The sample diameter is 60 mm and its length is 130 mm. Under an applied head of 60 cm, 119 cm³ of water flows through the sample in 5 minutes. Determine (a) the coefficient of permeability, and (b) the discharge velocity.
For each of the three cases shown in Figure 3 determine: a). the pressure head, elevation head, total head, and cumulative head loss at the entrance, exit and point A of the soil sample. For each case, set the datum at the tail water elevation. b). the discharge velocity and the seepage velocity if the soil's permeability coefficient is 0.10 cm/s and the porosity is 40%. POTTAWA c). the discharge velocity and the seepage velocity if the soil's permeability coefficient is 0.001 cm/s and the void ratio is 0.600. BAINA LE DROIT 3 m 4m + 2m A. Case I ez ilise ROTÉGÉ PAR 3 m 1m 4m est cadre A. Case II sirez 1 m e mate ificati Figure 2 dood 3 m 5 m TED MATERIA Case III urse are rected by cop not harmission to up nox clarification, ple 1 m
Problem (3) The hydraulic conductivity of a sand specimen at a void ratio of 0.55 is 0.051cm/sec. Estimate its hydraulic conductivity at a void ratio of 0.7.
a) A CU triaxial test was carried out on a silty sand soil sample. The cell pressure was equal to 200 kPa. At failure the deviator stress was equal to 410 kPa and the pore pressure was equal to 73 kPa. i) Assuming that the cohesion intercept is equal to 0, calculate the friction angle of the soil. ii) If the friction angle was equal to 35°, calculate the cohesion intercept of the soil. iii) Calculate the angle of the failure plane relative to the horizontal plane for the soil shear strength parameters in Question 4 a i and 4 a ii.
5. For a constant head laboratory permeability test on a fine-sand, the following values are given: Length of specimen, L = 10 inches Diameter of specimen = 2.5 inches Head difference, h = 22 inches Water collected in 2 min = 0.011in? Void ratio = 0.34. Determine the conductivity, k, of the soil in inches/min and the discharge velocity through the soil in inches/min. Porous stone Soll specimen Porous stone Graduated flask
Ex Two identical soil samples (A) and (B) of a fully saturated N.C.C. were tested. Sample (A) was subjected to an unconfined compression test and failed when the deviator stress (OT-13) was (200) kN /n². Sample (B) was tested under UU conditions with a cell pressure of (300) kN/m². The pore water pressure at failure. was (200) kN/m². a) What was the pore water pressure at failure in sample (A). b) If C=o, Find (2) for this clay. (Itint. Start with soil B, and that (OJ) un= (FJ) afined). unconfined
For a falling-head permeability test, the following values are given:• Length of specimen 8 in.• Area of soil specimen 1.6 in.2• Area of standpipe 0.06 in.2• Head difference at time t 0 20 in.• Head difference at time t 180 sec 12 in.Determine the hydraulic conductivity of the soil in in./sec
1. For a constant head laboratory permeability test on a fine sand, the following values are given: L = 300 mm; D₁ = 200 mm; h = 400 mm; Vol = 420 m³; t = 4 min; e = 0.55. a. Compute the coefficient of permeability in cm/sec. b. Compute the discharge velocity in cm/sec. c. Compute the velocity. seepage 2. For a falling head permeability test, the following are given. Length of specimen is 380 mm, are of specimen - 6.5 cm², hydraulic conductivity of soil specimen is 0.175 cm/min. a. What should be the area of the stand pipe for the head to drop from 650 cm to 300 cm in 8 min?