Constant head permeability tests were performedon two soil specimens, S1 and S2. The ratio ofheight of the two specimens (Ls1: Ls2) is 1.5, theratio of the diameter of specimens (Ds:Ds2) is0.5. and the ratio of the constant head (h:h)applied on the specimens is 2.0. If the dischargefrom both the specimens is equal, the ratio of thepermeability of the soil specimens (k,:k2)S1's1is

Answered: Image /qna-images/answer/00c63165-0a7a-4610-8fd8-0ce5357b85b9.jpg

Constant head permeability tests were PENUI height of the two specimens (Ls1: Ls2) is 1.5, the ratio of the diameter of specimens (Ds:Ds) is 0.5, and the ratio of the constant head (h.:h) applied on the specimens is 2.0. If the discharge from both the specimens is equal, the ratio of the permeability of the soil specimens (kk) S1 is

Constant head permeability tests were PENUI height of the two specimens (Ls1: Ls2) is 1.5, the ratio of the diameter of specimens (Ds:Ds) is 0.5, and the ratio of the constant head (h.:h) applied on the specimens is 2.0. If the discharge from both the specimens is equal, the ratio of the permeability of the soil specimens (kk) S1 is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q.5) For a sand sample the values of the minimum (emin) and maximum void ratio (e...) are 0.42 and 0.67, respectively. The specific gravity of solids (G.) for the sand is 2.66. a) What is the corresponding range in dry unit weights? b) What is the corresponding range in the saturated unit weights? c) If a relative density (Dr) of 87% is desired, what will be the moisture content associated with full saturation?
Constant head permeability tests were performed height of the two specimens (Ls1: Ls2) is 1.5, the ratio of the diameter of specimens (Ds:Ds) is 0.5. and the ratio of the constant head (h:h) applied on the specimens is 2.0. If the discharge from both the specimens is equal, the ratio of the permeability of the soil specimens (k:k2) S1 's1 is
i need the answer quickly
The moist sample collected from the field is 465 g,its oven dried mass is 405,76 g, the spesific gravity of solids was determined in the lab to be 2.68. If the void ratio of the soil in the natural state is 0.83. Find the following: 1)the moist density of the soil in the field; 2)The dry density of the soil in the field; 3) The mass water to be added per cubic meter gamma (or L I am not sure either) soil in the field for saturation;
The coefficient of permeability of fine sand is 0.12 cm/sec at a void ratio of 0.37. Estimate the increase in the permeability using the (a) kozeny-carman formula (b) casagrande formula of the same sand when its void ratio has increased by 0.45.
The given values are as follows: The specimen's e=0.46 length of soil specimen=450mm constant head difference=700mm Water collected in 3 minutes =3.54x10-4 m3 Area=2.26x10-3 m2 1) Find the coefficient of permeability (Ans. 2.012 m/hr) 2) Find the discharge velocity (Ans. 0.052 m/min) 3) Find the interstitial velocity (Ans. 0.165 m/min)
In the soil triaxial compression test, the test body is first compacted under a confining pressure of 600 kN/m2, and the water in the test body is reversed. The pressure is 300 KN/m2. After compaction was completed, the drain of the specimen was turned off and the confining pressure was increased to 720 kN/m2, while the At this time, the pore water pressure of the specimen was measured to be 410 kN/m2. Subsequently, under the same confining pressure, the axial pressure is activated to make the shaft The differential stress reaches 550 kN/m2, and the pore water pressure of the test body is measured to be 565 kN/m2. trial calculation Skempton's pore water pressure coefficients A and B.
i need the answer quickly
The liquid limit and plastic limit of sample are 60% and 30% respectively. The percentage of the soil fraction with grain size finer than 0.002 mm is 20. The activity ratio of the soil sample is (a) 0.50 (c) 1.50 (b) 1.00 (d) 2.00
For a constant head laboratory permeability test on a fine sand, the following are given:Length of specimen = 250 mmDia. of specimen = 62.5 mmHead difference = 450 mmWater collected in 2 min. = 484 cu.mmDetermine the discharge velocity in mm/sec.
In a permeability test with constant load in the laboratory, the following are given: L = 250 mm and H = 105 cm². If the value of k is 0.014 cm/s and a flow rate of 120 cm³/s must be maintained through the soil, what is the difference in charge, h, across the sample? determine also the percolation rate under the test conditions.
Show calculation on how to determine the average coefficient of permeability of the sand sample at 20°C. Also show calculations on how to determine the discharge the K1 and Average K1