Considering normal barometric pressure, what will be the depth of water in the ocean at that point where an air bubble, upon reaching the water surface has eight times its volume than it had at the bottom. Unit of the Correct Answer: meter, m Decimal Places required in the final answer: 3

Considering normal barometric pressure, what will be the depth of water in the ocean at that point where an air bubble, upon reaching the water surface has eight times its volume than it had at the bottom. Unit of the Correct Answer: meter, m Decimal Places required in the final answer: 3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The vapor pressure of water at 100 C is 101 KNm, because water boils under these conditions. The…

A: To find boiling temperature at 3000 m altitude

Q: Given a liquid water having a volume of 6m3 and weight of 44kN at 4°C, Calculate a. Specific weight…

A: Note:-Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: What is the height 'h' of water for a figure as shown in which gauge 'P' attached at the bottom of…

A: Given- Gauge ‘P’ attached at the bottom of tank reads 550 kPa (absolute), Figure shown for the water…

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.1 m as shown in…

Q: Oil 45 kPa SG = 0.72 75 cm Air Water 30 cm -Mercury SG = 13.6

Q: Q4 Calculate absolute and gauge pressures in the tank above the water surface.

Q: 1. In reference to figure 1, when the funnel is empty the water surface is at point A and the…

Q: PROBLEM 1: Both a gage and a manometer are attached to a tank to measure pressure. Given the reading…

Q: 3Q. At normal atmospheric conditions, approximately what pressure in MPa must be applied to water to…

Q: The gage pressure in a gas tank is 3.75 atmospheres. Compute the pressure head in meter of water? Do…

Q: A weather person states that the barometric pressure is 40 inches of mercury. Convert the pressure…

Q: Determine the pressure difference between points A and B in kPa. Given Specific Gravities: Benzene…

Q: what value of atmospheric pressure in psi, and in pascals?

A: Solution: 1 atm = 14.7 psi = 1.0325 x 105 Pa = 76 m of Hg = 29.9213 in…

Q: Question- A pressure gauge reads 62.3 kPa and 90 kPa respectively at heights of 7 m and 4 m fitted…

A: Pressure gauge readings at 7 m & 4 m are 62.3 kPa & 90 kPa as shown below- To Find- The…

Q: Calculate the density and specific weight of carbon dioxide at a pressure of 300 kN/m² absolute and…

A: Given carbon dioxide at a pressure of 300kN/m2 absolute and 60o C

Q: Q1:- Consider a large cubic ice block of (1 m) surface area floating in seawater. The specific…

A: The above question is based on the archimedes principle, the loss in weight of the submerged body is…

Q: Convert the following pressure readings from millimeters of mercury to pascal:a. 28.5 mm Hgb. 30.5…

Q: A mercury manometer used for measuring pressure difference indicates 50 cm head of Hg. This pressure…

A: Given- Pressure difference=50 cm head of Hg, Pressure difference in meters of water is required.

Q: The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the…

Q: Find the atmospheric pressure when the barometer reading is 800 mmHg. Given the specify gravity of…

Q: e an expression for the capillary rise h for a fluid of surface tension a and contact angle between…

Q: Please answer asap Both a gage and a manometer are attached to a tank to measure pressure. Given the…

Q: Calculate the absolute pressure (in psia) in the natural gas pipeline. Assume that the effect of air…

A: Calculate the absolute pressure (in psia) in the natural gas pipeline.

Q: 1. For the computation of density of liquids to be tested, use the following values of density of…

Q: What is the height 'h' of water for a figure as shown in which gauge 'P' attached at the bottom of…

A: Gauge ‘P’ attached at the bottom of tank reads 550 kPa (absolute), Figure shown for the water and…

Q: 4. In figure, fluids A and B have specific gravities of 0.75 and 1.00, respectively. If mercury is…

A: Given data : S.GA=0.75S.GB=1.00

Q: Calculate the hydrostatic pressure at the surface of a tank filled with mercury (Hg). The specific…

Q: if the concentration of [H+] in a fluid is 6.8*10-7 M, what is the pH of the fluid. if the pH level…

Q: 3. Determine the level "y" of the oil (SG=0.80) in the right hand tube as shown in the figure. Both…

Q: An air compressor intakes atmospheric air at 101.325 kPa and increases its pressure to 1.275 MPa…

A: Given: Atmospheric pressure, Patm = 101.325 kPa Gauge pressure, Pgauge = 1.275 MPa

Q: PROBLEM 5: The water in a tank is pressurized by air, and the pressure is 4 points measured by a…

Q: The absolute pressure of gas in the tank is 77.1 kPa. Determine the reading of a pressure gage on…

Q: This subject is fluid mechanics,i dont know how to solve this.please help me before exam.

A: Flow rate of orifice meter, Q = C A1 A2 2ghA12-A22 .............................. (1) Where C…

Q: Atmosphere h The blue rectangle represents 60 degree F water exposed to the atmosphere. Determine…

A: Objective: To determine the absolute pressure (psi) at the given depth. Given: Temperature of…

Q: 18. The water in a tank is pressurized by air and the pressure is measured by a multifluid manometer…

Q: A pressure gauge at elevation 12m at the side of a tank containing a liquid reads 80 kPa. Another…

Q: -Oil SG 0.79 P = 260 kPa gage Gasoline SG = 0.70 Pipe Air- 45 cm 50 cm 22 cm 10 cm Water Mercury SG…

Q: IV. CALCULATION 1. Calculate the density as follows: m V Where: density of the liquid, g/mL mass of…

A: to find - mass and density of given liquids.

Q: Give the reason behind the followings: 1- All gases can be considered as compressible fluids.

A: Compressibility is defined as the change in volume of fluid with the increase in pressure. it is…

Q: (a) What is the height of atmosphere above earth surface, if the pressure of air at mean sea level…

A: Pressure at height (h) is given by P=density * g * h where, P=pressure g= acceleration due to…

Q: The height of a liquid column of mercury open to the atmosphere is 2.493 ft. Calculate the absolute…

Concept explainers

Pressure and Stress

Question

Considering normal barometric pressure, what will be the depth of water in the ocean at that point where an air
bubble, upon reaching the water surface has eight times its volume than it had at the bottom.
Unit of the Correct Answer: meter, m
Decimal Places required in the final answer: 3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please answer
The pressure on a closed tank reads 68.86 kPa. What is the equivalent height in terms of Oil having a sp.gr of 0.85? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: 3
A pressure gauge at elevation 12m at the side of an open tank containing a liquid reads 80 kPa. Another gauge at elevation 7m reads 120 kPa. What is the elevation of the liquid surface? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: /Zero
3. Situation 1 - The pressure on a closed tank reads 58.86 kPa. What is the equivalent height, in meters, in terms of mercury? Round off to three decimal places.
i need the answer now
If your blood pressure is measured as 119 mm Hg (i.e., mercury column height), what is the corresponding absolute pressure in kPa? O 85.2 kPa O 117.3 kPa O 16.0 kPa O 101.3 kPa
2- The density of a liquid is to be determined by an old 1-cm-diameter cylindrical hydrometer whose division marks are completely wiped out. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into the other liquid, and it is observed that the mark for water has risen S cm above the liquid-air interface. If the height of the original water mark is 12.7 cm, determine the density of the liquid S (cm) Last names starting 0.95 with A to L Unknown liquid Mark for water S cm
A barometric pressure of 50 in. Hg corresponds to what value of atmospheric pressure in psi, and in pascals? (a) p = (b) p = psi Pa
A pressure gage 10.52 m. above the bottom of a tank containing a liquid reads 58.5 kPa; another gage at height 3.16 m. reads 85.83 kPa. Determine the density of the liquid. Round off to three decimal places.
Please solve it very correctly. I need the correct solution. Thank you. Last two digit of the registration number= 18
Compute the absolute pressure in kPA of a given tank if a barometer reads 820mmHg and a pressure gage attached to a tank has a reading of 975cm of oil (S.G. of 0.85) Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: KPA abs. Decimal Places required in the final answer: 3
I need the answer as soon as possible