Answered: Consider the system shown. A 5.00 m… | bartleby

Related questions

Question

Consider the system shown. A 5.00 m beam supports a mass of 3000 kg attached to a cable. The mass of the beam is 1000 kg. Assume that the mass of the beam is uniformly distributed throughout its length. (a) Determine the tension in the cable (b) Calculate the horizontal and vertical components of the force exerted at point O.

Consider the system shown. A 5.00 m beam supports a mass of 3000 kg attached to a cable. The mass of the beam is
1000 kg. Assume that the mass of the beam is uniformly distributed throughout its length. (a) Determine the tension in
the cable (b) Calculate the horizontal and vertical components of the force exerted at point O.
5.00m,
3000 kg
45.0°

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Please help me
A uniform ladder weighing 490 N rests against a frictioniess wall. The ladder has a length L = 14.0 m and makes a 59.0° angle with the horizontal ground. An 820 N firefighter has climbed d = 4.20 m along the ladder from the bottom. Find the coefficient of static friction Hs between the ladder and the ground. O 0.863 O 0.225 O 0.119 O 0.332 O 0.567
The drawing shows a uniform horizontal beam attached to a vertical wall by a frictionless hinge and supported from below at an angle 0 = 40° by a brace that is attached to a pin. The beam has a weight of 340 N. Three additional forces keep the beam in equilibrium. The brace applies a force P, and the hinge applies a force with a horizontal component H and a vertical component V. (a) Draw the free- body diagram showing the forces that act on the beam. Find the magnitudes of the forces (b) P, (c) H, and (d) V. Beam Hinge Pin Ꮎ Brace E
A beam with length of 2 m and a mass of 10 kg supports a 50 kg box. The beam is connected to a wall by a hinge at its base and a horizontal wire. The wire is connected to the beam 1.5 m from the hinge and makes an angle θ of 35o to the beam. The goal is to find the tension in the wire and the horizontal and vertical components of the force exerted by the hinge on the board. Suppose the maximum tension that the wire can withstand is 1500 N. What is the maximum load that the hinge can support before the wire breaks?
A uniform 34.0-kg beam of length { = 5.95 m is supported by a vertical rope located d = 1.20 m from its left end as in the figure below. The right end of the beam is supported by a vertical column. (a) Find the tension in the rope. (b) Find the force that the column exerts on the right end of the beam. (Enter the magnitude.)
One end of a uniform { = 4.30-m-long rod of weight w is supported by a cable at an angle of 0 = 37° with the rod. The other end rests against a wall, where it is held by friction (see figure). The coefficient of static friction between the wall and the rod is µ. = 0.490. Determine the minimum distance x from point A at which an additional weight w (the same as the weight of the rod) can be hung without causing the rod to slip at point A. B Need Help? Read It Watch It
A fence post of mass m = 8 kg supports a fence with three lengths of barbed wire. The bottom wire is a distance d = 0.35 m from the ground and each wire is a distance 0.35 m above the previous one. Each of these three wires has the tension on it. For this problem, assume that the force exerted by these wires is purely horizontal. An additional guy wire is used to keep the pole upright with a tension of Fa = 490 N. The guy wire attaches to the post at a point h = 0.86 m above the ground and makes an angle of θ = 45 with respect to the horizontal. Write an expression for the tension in any one of the three fence wires. What is the normal force that the ground exerts upward on the post?
A ladder rests against a frictionless wall. It has a mass of 40 kg, a length of 6.4 m, and makes an angle of 56° with the ground. Find the horizontal and vertical force components exerted by the ground on the bottom of the ladder if a standard man stands on the ladder 4 m from the ground. (Assume the mass of the standard man is 70 kg. Enter the magnitudes in newtons.)