Consider the loading shown. The allowable normal stress for the steel used is 172 MPa. For the selected design, determine the maximum value of the principal stress σmax at the junction of a flange and the web. (Round the final answer to one decimal place.)

Q: Consider a hollow circular shaft of inner radius r; = 1.25 inch and outer radius of ro = 1.50in,…

A: Find the state of stress at point P

Q: For the selected design, determine the actual value of om in the beam. (Round the final answer to…

A: Given:Allowable Normal Stress For The Steel Used Is 25.2Load = 48 kipsTo find:lActual value of…

Q: The homogeneous bar ABC is supported by a pin at C and a cable that runs from A to B around the…

A:

Q: PLEASE ANSWER QUICKLY

A: Given data as per question Diameter = 2 in Length of bar =24 in Force = 20000 lb

Q: Steel wire AB and aluminum wire CA support the 400 kg mass as shown. Determine the required diameter…

A:

Q: Three forces, each of magnitude P = 3 kN, are applied to the structure shown. Determine the…

A: Solution.jpg

Q: A hook is fashioned by bending a 8.0 mm wide metal bar into the shape shown. A force of 85 N is…

A: Given data: Dare the diagram of the hook by transferring the F from D to B and moment due to F at…

Q: Draw Mohr's circle that describes each of the following states of stress.

A: Given data:- σx =-8 ksi σy =12 ksi τxv=-6 ksi To draw:- Mohrs circle

Q: B The two rods AB and AC have diameters of 10 millimeters and 8 millimeters. Determine largest…

A:

Q: B

A: Given DataHorizontal force at end D of the lever, P=150 lbThe diameter of portion AB of the lever,…

Q: Determine the principal stresses and the maximum shearing stress at point H. (Round the final…

A: At point H, loading will be as per following, M=600(2.5)=1500 lb-inT=600(2.5)=1500 lb-inP=2300 lb…

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.