Consider the following transport network 300 100 400 550 300 150 300 500 400 c. Find the maximum flow if if the indicated capacities are w = 200, x = 100, y = 300 d. Find the maximum flow if if the indicated capacities are w = 300, x = 200, y = 450
Q: Ks 120 N Vs 20 V RL The source in Figure 2 has an internal resistance of 120 Ohm. Determine the load…
A:
Q: A seven-story office building has 15 adjacent offices per floor. Each office contains a wall socket…
A:
Q: API=(141.5/(SG))-131.5 SG=(141.5/(API+131.5)) The Characterization factor(Kw) for crude oil is…
A: Given data: SG=(141.5/(API+131.5)) Kw=(∛TB)/SG where; TB=mean aberage boiling point, deg Rankine SG…
Q: A regional telephone company had 5.2 million subscribers. Each of their telephones is connected to a…
A: The following formulas help in calculation: 1. Radius = diameter / 2 2. Area of circle = π * r2 2.…
Q: Consider the following flow graph G. Show the maximum flow graph in G with sourcevj and sink V5.…
A: Here are the stpes involved :- We have to keep considering the paths to reach from source to…
Q: the maximum flow graph in Gwith source V1 and sink v-
A: Given :- In the above question, a graph G is mention in the above given question Need to compute…
Q: 120 Ql:A/ Answer the questions for the figure below: 1-Re-arrange the curves (A,B and C) from the…
A: Answer
Q: where; TB=mean aberage boiling point, deg Rankine SG =specific gravity at 60 °F Crude oil are…
A: The answer is
Q: A seven-story office building has 15 adjacent offices per floor. Each office contains a wall socket…
A: Introduction A LAN can be pretty much nothing or huge, going from a home network with one client to…
Q: Fully developed flow moving a 40 cm diameter pipe has the following velocity profile: Radius r, cm…
A: Solution of the given question is:-
Q: Pipeline fluid flows are indicated below. Determine the maximum flow from Node 1 to Node 4.…
A: Solution: Correct answer is : b) 600
Q: Q1: a traffic signal control is being designed for a four-leg intersection on a divided highway with…
A: Hey, since there are multiple questions posted, we will answer first question. If you want any…
Q: A robot system has a protective barrier enclosing the work cell area. The total time for the system…
A: Given The answer is given below.
Q: Given a flow network G = (V, E) and any flow between s and t, let (A,B) be a minimum cut. Then,…
A: Network flow refers to the concept of modeling the movement of quantities, such as data, goods, or…
Q: Pipeline fluid flows are indicated below. Determine the maximum flow from Node 1 to Node 3. From…
A: Flows available from Node1 to Node3: 1. 1->2->3 = 300+100=400 2. 1->3 = 400
Q: Tasks: Plot the power curve of the turbine and the histogram of the wind speed in two subplots in…
A: Python which refers to the one it is dynamically typed and garbage-collected, and supports multiple…
Q: A seven-story office building has 15 adjacent offices per floor. Each office contains a wall socket…
A: LAN is also known as local area network.
Q: The Pentium 4 Prescott processor, released in 2004, had a clock rate of 3.6 GHz and voltage of 1.25…
A: the answer is given below:-
Q: n assembly line with 30 activities is to be balanced. The total amount of time to complete all 30…
A: 1. Maximum and minimum cycle time Maximum cycle time is total time for all activities= 60 minutes…
Q: Q1. Given the hazard rate function () = 2 × 10-5, Determine R(t) and f(t) at t= 500 h.
A:
Q: For traffic signal control in a T junction: · Provide the allocation List…
A: Answer is given below .
Q: A seven-story office building has 15 adjacent offices per floor. Each office contains a wall socket…
A: Introduction A local area network (LAN) is an assortment of gadgets associated together in one…
Q: A seven-story office building has 15 adjacent offices per floor. Each office contains a wall socket…
A: What is LAN? A local area network is a computer network that interconnects computers within a…
Q: For the following separation system, we know the inlet mass flow rate (in Kg/hr) the mass fractions…
A: %% use MATLAB to find the solution A=[1 1 1;0.04 0.54 0.26;0.93 0.24 0] % given AB=[10;2;6] % B in…
Q: In Figure, suppose that the wellheads can be divided into two groups depending on gas pressure: a…
A:
Q: a. Find the general flow pattern of the network shown in the figure. b. Assuming that the flow must…
A: From the Network, There are 5 nodes in the Network i.e, A,B,C,D,E and 6 variables X1,X2,X3,X4,X5,X6.…
Q: Write a script that will create 10,000 random resistors with a normal distribution, a mean of 100…
A: 1. Define the parameters for the resistors: - `total_resistors` for the total number of resistors…
Q: 1. For traffic signal control in a T junction: Provide the allocation List Draw the Grafcet and…
A: Allocation list :- Sr. no. Address Name Input / Output 1 I:0/0 Start Input 2 I:0/1 Stop Input…
Q: A seven-story office building has 15 adjacent offices per floor. Each office contains a wall socket…
A: A) a star configuration with a single router in the middle? B)an 802.3 LAN?
Q: 2= 5 Ω, 10 Ω and 15 Ω, calculate i2 with each R2? If the value of the resistor R2 is in Ω, maximum…
A:
Q: Fully developed flow moving a 40 cm diameter pipe has the following velocity profile: Radius r, cm…
A: Solution of the given question is-
Q: In the manufacturing of a chemical adhesive, 3% of all batches have raw materials from two different…
A: Find Your Answer Below
Step by step
Solved in 2 steps with 2 images
- QUESTION 7 Given the following flow network. The red line represents a cut (S,T), where T is OO {s,a,b} {c,d,t} {a,b,c,d} {s,t} none of these QUESTION 8 3/4 8/8 a 3/3 6/6 6/6 1/1 d 9/11 3/3 2/2Consider the flow network shown in the following figure (left), where the label next to each arc is its capacity, and the initial s-t flow on right. (a) What must be checked to show that the initial f is a flow?a. Find the general flow pattern of the network shown in the figure. b. Assuming that the flow must be in the directions indicated, find the minimum flows in the branches denoted by x2, x3, x4, and X5. 40 40 =HF Xyx D 30 40 80 60 <100 90
- Data communication systems. The solution time of the problem is 10 minutes. In an FDMA-based multiple access system, each user is assigned an 80 kHz channel for full-duplex communication. There are 1000 channels in total in the system.Depending on the information given above, if the initial frequency of the frequency spectrum used by the FMDA system in one direction is 1000 Mhz, the carrier frequency of the channel belonging to the first user is 1.000.040 KHz.A) False B) TrueThe current and voltage across a circuit element are given by the equations I(t) = 20e 100t (mA), V(t) = 105e-1⁰⁰t (V) Determine the total energy E dissipated by the element between t=0 and t=10ms. The instantaneous power dissipated by the element is P(t) = 1(t)V (t). Find the total energy E by integrating P(t) over the time interval from t=0 to t=10ms=0.01sec. To do so, use the function trapez(fn, a, b, h), which implements the trapezoidal rule for numerical integration and where fn is a function handle to a function that needs to be integrated, a and b are the integral limits and h is the step length. Write in Matlab the function that needs to be integrated and call function trapez with appropriate parameters.A cell-phone carrier is allocated 642 radio frequencies to operate in a city with a hexagon pattern cell design. 42 of the frequencies is reserved for control channel and each phone call uses 2 frequencies per call (1 for transmitting and 1 for receiving). In an advance mobile phone service, use the frequencies distribution to answer the following question. If the distance between centers of adjacent cells is 2km and the minimum distance between centers of cells with the same cochannel is 7km, Calculate the area of each cell. Answer: 165,95,55
- A cell-phone carrier is allocated 642 radio frequencies to operate in a city with a hexagon pattern cell design. 42 of the frequencies is reserved for control channel and each phone call uses 2 frequencies per call (1 for transmitting and 1 for receiving). In an advance mobile phone service, use the frequencies distribution to answer the following question. if the distance between centers of adjacent cells is 2km and the minimum distance between centers of cells with the same cochannel is 7km. Calculate the area of each cell.For traffic signal control in a T junction: · Provide the allocation List · Draw the Grafcet and obtain the grafcet equation · Develop the ladder programming from the grafcet Figure below shows the T junction with three traffic signals. Each traffic light cycles through red (i.e. stop) time depends on the other two signals, red & amber (i.e. get ready to go) for 5 seconds, green (go) for 20 seconds, and amber (stop if safe to do so) for 5 seconds.Solve the given question in the pic.
- Q1:For the network of figure, determine: 1-IB ,Ic ,B,VCE . if hie=1.6KQ, hre=2*10-4, hfe=110 and hoe=20ps. 2-S(Ico) ,S(VBE) ,S(B) using T1 as the temperature at which the parameter values are specified and B(T2) as 25% more than B(T1). 3-Determine the net change in Ic if a change in operating condition results in Ico increase from 0.2µA to 10HA,VBE drops from 0.7 to 0.5 and ß increase 25%. 4-Find the change in Ic if the temperature increase from 25 to 75 [C'] +16 3 KOhm 20 uF 220 kOhm HH 10 uF 1 k Ohm HE 12k Ohm 120 my 200 Ohm 20 uF 1 kOhn (10] M 10A simple telephone system consists of two end offices and a single toll office to which each end office is connected by a 1-MHz full-duplex trunk. The average telephone is used to make four calls per 8-hour workday. The mean call duration is 6 min. Ten percent of the calls are long-distance (i.e., pass through the toll office). What is the maximum number of telephones an end office can support? (Assume 4 kHz per circuit.)API=(141.5/(SG))-131.5 SG=(141.5/(API+131.5)) The Characterization factor(Kw) for crude oil is given as; Kw=(VTB)/SG where; TB=mean aberage boiling point, deg Rankine SG =specific gravity at 60 °F Crude oil are classified based on the following criteria; Kw =12.5-13.0→Paraffin based crude oil Kw =11.0-12.0–→Napthenic based crude oil Kw =9.8-11.0→Aromatic based crude oil based on the above information,write php program for the classification of crude oils